Runco Cl 510 Projector User Manual
Here you can view all the pages of manual Runco Cl 510 Projector User Manual. The Runco manuals for Projector are available online for free. You can easily download all the documents as PDF.
Page 31
6. Additional Information Runco CL-510/ CL-510LT User’s Manual28 Troubleshooting 7. Put on the front lamp cover.8. Tighten the screw of front lamp cover. 9. Turn on the power and go into the Set Up menu to reset the Lamp Timer item. Problem Possible Cause Remedy This unit does not turn on.There is no power from power cable. Plug the power cord into the AC inlet on the rear of this unit, and plug the power cord into to the power inlet. The power switch is not turned on. Turn on the power switch....
Page 32
6. Additional Information Runco CL-510/ CL-510LT User’s Manual29 Specifications CL-510/ CL-510LT Specifications Projector Type: Digital Light Processing™ (DLP™), Single Matterhorn DMD™ Chip Native Resolution: 1024 x 576, (16:9) Aspect Ratios:4:3, Letterbox, 16:9, Anamorphic, Virtual Wide Video Standards:NTSC, PAL DTV Compatibility:480p, 720p, 1080i Scan Frequency:Horizontal: 15-80 kHz Vertical: 50-100 Hz Picture Size (16:9 Screen):Recommended Width: 72-96 in. Maximum Width: 200 in. Throw...
Page 33
6. Additional Information Runco CL-510/ CL-510LT User’s Manual30*ANSI Lumen specification: This is the typical projector luminosity (brightness) specification found in most sales literature. This measurement is included in RUNCO literature to allow for direct comparison with other manufacturers projectors. These measurements can be taken at 9,000 to 13,000 degree Kelvin to get expected performance data when the projector is used in professional, commercial, and industrial displays. **CSMS Home...
Page 34
6. Additional Information Runco CL-510/ CL-510LT User’s Manual31 Dimensions Unit: in. (mm)
Page 35
6. Additional Information Runco CL-510/ CL-510LT User’s Manual32 RS-232 Setup Baud Rate: 115200 or 9600 Parity: None Data Bits: 8 Bits Stop Bits: 1 Bit Flow Control: None RS-232C Control Codes Code Function X01 Power On X02 Power Off X03 Message On X04 Message Off X10 Menu (arrow key) X11 Enter (arrow key) X12 Exit (arrow key) X13 Up (arrow key) X14 Down (arrow key) X15 Left (arrow key) X16 Right (arrow key) X20 Switch to Composite input X21 Switch to S-Video input X22 Switch to Component input X23...
Page 36
Runco International .2900 Faber Street .Union City, CA 94587 .ph (510) 324-7777 .fax (510) 324-9300 .www.runco.com RUMA-010300 rev 7-03