Roland XJ 640 User Manual

119Chapter 7  Specifications
7-2 Printing Area
Printing Area and Margins
A: Setting of the [SIDE MARGIN] menu item (10 mm or 5 mm; 10 mm by default)
B: Width clamped by the media clamp (approx. 5 mm)
*1 The amount of the left and right margins is the total of A and B. If the following cases, however, the setting for A
 becomes the amount of margin without change.
➢ When media has been loaded without installing the media clamps and
has been pressed
➢ When the [SHEET TYPE] menu item is set to [CLEAR]...

Chapter 7  Specifications120
7-2 Printing Area
Media-cutoff Location During Continuous Printing
When a media-cutoff command is sent from the computer, the cutoff location on the media is as shown in the figure
below.
First page Second page
75 mm
Margin
(setting on the computer) Location where
separated
Downloaded From ManualsPrinter.com Manuals 

121Chapter 7  Specifications
7-3 Locations of the Power Rating and Serial Number Labels
Power RatingUse an electrical outlet that meets the requirements
for voltage, frequency, and amperage given here.
Serial NumberThis is required when you seek maintenance, servic-
ing, or support. Never peel off the label or let it get
dirty.
Downloaded From ManualsPrinter.com Manuals 

122Chapter 7  Specifications
7-4 Specifications
80
55
35
15 27 32 Humidity
20(%)
°C (°F)(no condensation)
Temperature (59)(90) (81) (68) 0
Use in an operating environment
with this range.
*1
The length of printing is subject to the limitations of the program.
*2
➢With Roland PET film, print travel: 1 m
➢Temperature: 25°C (77°F), humidity: 50%
*3
Not assured when the print heater or dryer is used.
*4
➢Warm-up is required after powerup. This may require 5 to 20 minutes, depending on the operating...

123
Downloaded From ManualsPrinter.com Manuals 

124
Downloaded From ManualsPrinter.com Manuals 

Downloaded From ManualsPrinter.com Manuals 

R1-070820
Downloaded From ManualsPrinter.com Manuals