Ricoh Projector PJ X2340 User Manual

English
29
English
Basic Operations
E62405SPR
	Due to the differ-ence in applications for each country, some regions may have dif-ferent accessories.
Note
		To ensure the projector works well with your computer, 
please make sure the timing of the display mode is 
compatible with your projector.
1.........................................................................\
...................Power Cord (supplied)2.........................................................................\...

30
English
Basic Operations
Powering On the Projector
1. Ensure that the power cord and signal cable are securely 
connected. The Power indicator will turn red.
2.   Remove the lens cap. 
3.   Turn on the lamp by pressing “Power” on the control panel 
or the remote control.  The Power indicator will flash blue.
 The startup screen will display in approximately 5 seconds. 
After the screen disappears, the Power indicator will turn 
blue. 
 The first time you use the projector after purchase, the lan-...

English
31
English
Basic Operations
Powering Off the Projector
1.    Press the “Power” to turn off the projector lamp, you will 
see a message as below on the on-screen display.
 
2.   Press the “Power” again to confirm. 
3.   The cooling fan continues to operate for about 60 seconds for 
cooling cycle and the Power indicator will flash red. When 
the light stop flashing, the projector has entered standby 
mode.
   If you wish to turn the projector back on, you must wait 
until the projector has...

32
English
Basic Operations
Warning Indicator
   When the “Temp” indicator lights red, it indicates the pro-
jector has overheated. The projector will automatically shut 
itself down.
 
   When the “Lamp” indicator lights red, and you see the mes-
sage below displays on-screen, the projector has detected 
that the lamp is approaching its end of life. Please change 
the lamp as soon as possible or contact your local dealer or 
our service center. 
 
   When the “Temp” indicator flashes red (0.5 sec on,...

English
33
English
Basic Operations
Adjusting the Projected Image
Adjusting the Height of Projector Image
The projector is equipped with adjustable feet to raise and lower 
the image to fill the screen.
 To raise/lower the image:
1.   Use  to fine-tune the display angle.
You can raise the projector front up to 6 degrees by rotating the adjustable feet.
Note
Front Adjustable feet1
Maximum Length:15mm     

34
English
Basic Operations
Focus Ring
Adjusting the Projector Zoom and Focus
You may turn the zoom lever to zoom in or out. To focus the 
image, rotate the focus ring until the image is clear. 
The projector will focus at distances from 3.9 to 43.0 feet (1.2 
to 13.1 meters).
Adjusting Projection Image Size
Zoom Lever
Width
Height
Diagonal
Side ViewProjection Distance (D) Screen
Screen (H)
Offset (Hd)
Projection Image Size from 30” to 300” (0.7 to 7.6 meters).     

English
35
English
Basic Operations
Diagonal length (inch) size of 4:3 Screen
Screen Size W x HProjection Distance (D)Offset (Hd)(m)(inch)(m)(feet)
WidthHeightWidthHeightwidetelewidetele(m)(feet)
300.610.4624181.21.33.94.30.070.22
400.810.6132241.61.85.25.70.090.30
501.020.7640302.02.26.47.20.110.37
601.220.9148362.42.67.78.60.14045
701.421.0756422.83.19.010.00.160.52
801.631.2264483.13.510.311.50.180.60
901.831.3772543.53.911.612.90.210.67
1002.031.5280603.94.412.914.30.23.0.75...

36
English
User Settings
The Projector has a multilingual On Screen Display that allows 
you to make image adjustments and change a variety of set-
tings. The projector will automatically detect the source. 
How to operate
1.   To open the OSD, press “Menu” on the Remote Control or the key-
pad.
2.  When OSD is displayed, use      keys to select any item in the 
main menu. While making a selection on a particular, press     key 
to enter sub menu.
3.  Use      keys to select the desired item in the sub...

English
37
English
User Settings
Menu Tree
Main Menu2nd Level3rd Level4th LevelDefault ValueRange
Picture
Color Mode
Dynamic
Depends on the signal type and on changes to Color Mode amd User Mode settings.
PC
Movie
Game
User
Wall Color
White
White
Light Yellow
Light Blue
Pink
Dark Green
BrightnessDepends on Color Mode.0 ~ 100
ContrastDepends on Color Mode.0 ~ 100
SharpnessDepends on Color Mode.0 ~ 31
SaturationDepends on Color Mode.0 ~ 100
HueDepends on Color Mode.0 ~ 100
GammaDepends on Color Mode.0 ~ 3...

38
English
User Settings
Main Menu2nd Level3rd Level4th LevelDefault ValueRange
Position
Aspect Ratio
Auto
Auto4:3
16:9
16:10
PhaseDepends on Input Signal.0 ~ 31
ClockDepends on Input Signal.‘-5~+5
H.PositionDepends on Input Signal.
Depends on Input Signal (usually, min = -30, max = 30).
V.PositionDepends on Input Signal.Depends on Input Signal (for example, -5~5).
Digtial Zoom00 ~ 10
V Keystone0-40~+40
Ceiling Mount
Front
FrontFront Ceiling
Rear
Rear Ceiling