Ricoh Projector PJ LX3000ST User Manual

							9
This appendix lists the general notices of your Projector. 
Notice: Users in the United States of America
FCC notice 
MODEL NAME: RICOH PJ XL4540
TRADE NAME: PROJECTOR
MODEL NAME: RICOH XL4540
Tested To ComplyWith FCC Standards
FOR HOME OR OFFICE USE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.   This device may not cause harmful interference and2.  
This device must accept any interference received, including interference that may cause undesired operation. 
This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ▀■  Reorient or relocate the receiving antenna. ▀■  Increase the separation between the device and receiver. ▀■  Connect the device into an outlet on a circuit different from that to which the receiver is connected. ▀■  Consult the dealer or an experienced radio/television technician for help.
Regulation & Safety Notices
English 
English
Usage Notice
English   
						

							10
Notes to Users in the State of California
Perchlorate Material - special handling may apply, See www.dtsc.
ca.gov/hazardouswaste/perchlorate. 
WARNING:  Handling the cord on this product will expose you to 
lead, a chemical known to the State of California to cause cancer, 
and birth defects or other reproductive harm. Wash hands after 
handling.
RESPONSIBLE PARTY: Ricoh Americas Corporation5 Dedrick Place, West Caldwell, NJ 07006Phone: 973-882-2000
Notice: Shielded cables 
All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations. 
Caution 
Changes or modifications not expressly approved by the manufacturer could void the user’s authority, which is grant-ed by the Federal Communications Commission, to operate this projector.  
English
Usage Notice   
						

							11
Declaration of Conformity for EU countries 
▀■  EMC Directive 2004/108/EC (including amendments) 
▀■  Low Voltage Directive 2006/95/EC
Notice: Users in EU countries 
CE Marking Traceability Information  
(For EU Countries Only)
Manufacturer:Ricoh Co., Ltd.3-6 Nakamagome 1-chome, Ohta-ku, Tokyo. 143-8555, Japan
Importer:Ricoh Europe PLC20 Triton Street, London. NW1 3BF, United Kingdom
User Information on Electrical and 
Electronic Equipment
Users in the countries where this symbol shown in this section has 
been specified in national law on collection and treatment of E-
waste.
Our Products contain high quality components and are designed to facilitate recycling.Our products or product packaging are marked with the symbol be-low.
This product contains substances which are harmful to humans and 
the environment.
English 
English
Usage Notice
English   
						

							12
Notice: Users in Turkey
All Other Users
If you wish to discard this product, please contact your local 
authorities, the shop where you bought this product, your local dealer 
or sales/service representatives.
Laser Notice
•  
This Product is classified as Class 2 of IEC60825-1:2007 and also complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to Laser Notice No.50, dated June 24,2007. (For USA)• IEC 60825-1:2014 and IEC 62471: CLASS 1 LASER PRODUCT - RISK GROUP 1. (For EU countries and Japan and China)
Light source specification
3.5W laser diodes x 19
Wavelength: 440-455nm
Pulse duration: 1.32ms
Warning
• This projector has built-in laser module.
Possibly hazardous optical radiation emitted from this product.  
Do not stare into the beam. May be harmful to the eyes.
Caution
• Use of controls or adjustments or performance of procedures 
other than those specified herein may result in hazardous radiation 
exposure.
Laser emissionport 
English
Usage Notice   
						

							13
Notice: Users in the EU
Note for the Battery and/or Accumulator 
Symbol
In accordance with the Battery Directive 2006/66/EC Article 20 Information for end-users Annex II, the above symbol is printed on batteries and accumulators. This symbol means that in the European Union, used batteries and accumulators should be disposed of separately from your household waste. In the EU, there are separate collection systems for not only used electrical and electronic products \
but also batteries and accumulators. Please dispose of them correctly at your local community waste collection/recycling centre.
Notice: Users in Taiwan
.Šf£
						

							14
Other Information
 
Copyrights to Images
When projecting images using the projector, be careful 
not to infringe the copyright of protected materials.
The following are examples that may infringe the copy-
right of protected materials.
•  Broadcasting images or movies for commercial purposes
•  Modifying images or movies using functions such as freeze, 
magnify, or zoom to broadcast images for commercial pur-
poses or public viewing
•  Varying the aspect ratio of images or movies using a function 
that changes the screen size to broadcast images for com-
mercial purposes or public viewing
Note to Users Viewing 3D Images
Pay attention to the following points when viewing images us-
ing 3D glasses with projector:
•  How 3D images are viewed may vary according to the indi-
vidual.
•  Do not use 3D glasses for viewing any material other than 
3D images.
•  Before viewing 3D images, make sure to read the manuals 
provided with your 3D glasses and 3D compatible content.
•  
Avoid viewing 3D images for a long period of time. Take a 
break of 15 minutes or longer after every hour of viewing.
•   If you feel sick while viewing 3D images, stop viewing them. 
If you continue to feel sick, consult a doctor.
•  When viewing 3D image in a room where on LED lighting 
system or fluorescent lights are used, you may feel that the 
light in the room flickers. If this is the case, dim the lights until 
you do not notice any flickers, or turn off the lights.
•  If you or any member of your family has a history of light-sen-
sitive seizures, consult a doctor before viewing 3D images. 
English
Usage Notice   
						

							15
Product Features
 
Outstanding features include:
 ■ Single chip DLP® technology
 ■  NTSC3.58/NTSC4.43/PAL(B/D/G/H/I/M/N)/SECAM 
(B/D/G/K/K1/L) and SDTV(480i/576i), EDTV(480p/576p), 
HDTV(720p/1080i/1080p) compatible
 ■   Multi-Auto functions: Auto detection, Auto image and Auto 
saving the adjustments
 ■ Full function remote control
 ■ User friendly multilingual on screen display 
 ■   Advanced digital keystone correction and high quality full 
screen image re-scaling
 ■   Built-in  mono 10-Watt speaker.
 ■  UXGA, WXGA, SXGA+, SXGA, XGA  compression and 
VGA re-sizing
 ■ Macintosh compatible
English 
English
Introduction
English   
						

							16
	Due to different applications in each country, some regions may have different accessories.
Documentation : 
 		Read This First
 		User Manual (CD)
Remote Control  (with Battery)
CR20253V
Power Cord
Package Overview
Unpack and inspect the box contents to ensure 
all parts listed below are in the box. If something 
is missing, please contact your nearest customer 
service center.
ProjectorVGA Cable 
	Use only the VGA cable, power code provided with the projector. 
English
Introduction   
						

							17
Product Overview
Main Unit
1. Control Panel
2. Focusing Ring
3. Ventilation (inlet)
4. IR Receiver
5. Ventilation (outlet)
6. Speaker
7. Power Socket
8. Input / Output 
Connections
9. Lens
	The interface is subject to model’s  specifications.6
7
8
4
2
5
3
1
9
English 
English
Introduction
English   
						

							18
Control Panel
1. Power LED
2. Enter
3. Temp LED
4. Light LED
5. Menu
6. Input
7. Four Directional Select Keys
8. Power/Standby button
9. IR Receiver
8
5
6
9
3142
7 
English
Introduction