Ricoh Projector PJ KU12000 User Manual

							11
About the batteries
Explains things that you should follow in regard to the batteries.
 WARNING
  For safe operation, follow the warnings below regarding the batteries used in 
the remote control. If you use the batteries incorrectly, it may result in fire or 
injury due to batteries leaking or exploding.
  Do not use batteries other than the ones specified.
  Do not mix and use batteries that are different types or that are new and 
old.
  Correctly insert batteries according to the polarity (+/-).
  Do not charge non-rechargeable batteries.
  Do not heat or throw the batteries into fire or water.
  Do not connect the positive and negative terminals on a battery with a 
wire.
  Remove the batteries from the remote control that are past their sug-
gested use period or that are depleted.
  Remove the batteries when they will not be used for extended periods.
  Keep the batteries out of the reach of children. Children may swallow or 
choke on the batteries. If this happens, contact a doctor immediately.
 WARNING
  What to do if a battery has leaked
  If leakage from a battery adheres to your skin, rinse it with water immedi-
ately, and then contact a doctor.
  Wipe off the leakage with tissue paper while being careful not to touch it.
  Soak the tissue paper that you used in water, and then throw it away as 
burnable trash. 
						

							12
About the lamp
Explains things that you should follow in regard to the lamp.
 WARNING
  Do not look into the lens or vent when the product is on. The bright light may 
damage your eyes. Be especially careful in an environment with children.
 WARNING
  Before replacing the lamp, turn off the power and wait at least one hour to 
allow the product to cool completely. If it is not completely cool, you may burn 
or injure yourself due to the inside of the product and lamp unit being hot. 
If you replace the lamp without unplugging the power cord from the power 
outlet, electric shock or explosion may occur.
  Be careful when handling the used lamp so that it does not break. If it breaks, 
it may cause injury.
 CAUTION
  The product’s light uses a mercury vapor lamp that becomes high pressure 
when it is turned on. The lamp has the following characteristics, so be sure to 
handle it with care after understanding the contents.
  Deterioration or shock can cause the lamp’s life span to end or the lamp 
to explode. If the lamp explodes, it may make a big noise.
  The time that it takes for the lamp to reach its life span or explode de-
pends on each individual lamp and its operating conditions. It is possible 
that it might explode the first time it is used.
  If you use the lamp past its replacement period, the possibility of explo-
sion increases.
  If the lamp explodes, broken glass pieces may be scattered around the 
inside of the product and ejected from the vent or other opening.
  If the lamp explodes, a very small amount of mercury vapor in the lamp 
tube and broken glass pieces may be ejected from the vents or other 
opening. 
						

							13
 CAUTION
  What to do if a lamp has exploded
  If the lamp explodes, remove the power cord from the product, leave the 
room while making sure it is thoroughly ventilated.
  If the lamp explodes and you think that you have gotten glass particles 
or mercury vapor in your eyes or have inhaled either, contact a doctor 
immediately.
  Clean up the area around the product completely while being careful not 
to get injured from any broken glass pieces.
  Throw away any food that was near the product.
  Ask your service representative to replace the lamp and inspect the 
product.
 CAUTION
  Do not block the projection light when it is on. If you do so, the part that is 
blocking the projection light may get quite hot and deform, deteriorate or 
cause a burn or fire. The reflected light may make the lens hot and cause a 
product failure. To temporarily suspend projection, select the mute function. 
To suspend longer, turn off the product.
 CAUTION
  Be sure to always use a dedicated replacement lamp that is new when 
replacing the lamp. If you use a lamp that is not dedicated, it may result in an 
explosion and injury.
Moving
This section explains safety precautions about moving the machine.
 CAUTION
  Unplug the power cord from the wall outlet before you move the machine. 
While moving the machine, take care that the power cord is not damaged 
under the machine. Failing to take these precautions could result in fire or 
electric shock. 
						

							14
Other Information
Copyrights to Images
When projecting images using the projector, be careful not to infringe the copyright 
of protected materials.
The following are examples that may infringe the copyright of protected materials.
•  Broadcasting images or movies for commercial purposes
•  Modifying images or movies using functions such as freeze, magnify , or zoom to 
broadcast images for commercial pur poses or public viewing
•  Varying the aspect ratio of images or movies using a function that changes the 
screen size to broadcast images for com  mercial purposes or public viewing
Note to Users Viewing 3D Images
Pay attention to the following points when viewing images us  ing 3D glasses with 
projector:
•  How 3D images are viewed may vary according to the indi  vidual.
•  Do not use 3D glasses for viewing any material other than 3D images.
•  Before viewing 3D images, make sure to read the manuals provided with your 3D 
glasses and 3D compatible content.
•  Avoid viewing 3D images for a long period of time. Take a break of 15 minutes or 
longer after every hour of viewing.
•  If you feel sick while viewing 3D images, stop viewing them. If you continue to 
feel sick, consult a doctor.
•  When viewing 3D image in a room where on LED lighting system or fluorescent 
lights are used, you may feel that the light in the room flickers. If this is the case, 
dim the lights until you do not notice any flickers, or turn off the lights.
•  If you or any member of your family has a history of lightsen  sitive seizures, con-
sult a doctor before viewing 3D images. 
						

							15
Safety Marks of This Machine
Positions of WARNING and CAUTION marks
This machine has marks for WARNING and CAUTION at the positions shown be-
low. For safety, please follow the instructions and handle the machine as indicated.
Main unit
14
5
3
2
1
The lamp attention is for the specialists only.
2
Do not put your face or hand near the exhaust vents. Doing so could result in burns 
or an accident due to hot air coming from the exhaust vents.
3
Do not look into the lens when the product is on. The bright light may damage your 
eyes.
Do not place anything in front of the lens. The object may become very hot and 
cause a fire or burn. To blank the image temporarily, turn on the mute function. 
						

							16
4
Do not remove any screws except the lamp cover screws.
Do not block or cover the vents.
5
Lamp(s) inside this product contain mercury and must be recycled or disposed of 
according to local, state or federal laws.
Power Switch Symbols
The meanings of the symbols for the switches on this machine are as follows:
   : STANDBY 
						

							17
Laws and Regulations
User Information on Electrical and Electronic Equipment
If you wish to discard this product, please contact your local authorities, the shop where you bought this product, your local dealer or sales/service representatives.
Regulation & Safety Notices
This appendix lists the general notices of your Projector.
Notice: Users in the United States of America
FCC notice
MODEL NAME: RICOH PJ KU12000
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 
						

							18
Notice: Shielded cables
All connections to other computing devices must be made using shielded cables to 
maintain compliance with FCC regulations.
Caution
Changes or modifications not expressly approved by the manufacturer could void the 
user’s authority, which is granted by the Federal Communications Commission, to 
operate this projector.
LAMP(S) INSIDE THIS PRODUCT CONTAIN MERCURY AND MUST BE RECYCLED OR DISPOSED OF ACCORDING TO LOCAL, STATE OR FEDERAL LAWS.
Notes to Users in the State of California
Perchlorate Material - special handling may apply, See www.dtsc.ca.gov/hazardouswaste/perchlorate.
WARNING: Handling the cord on this product will expose you to lead, a chemical known to the State of California to cause cancer, and birth defects or other reproductive harm.
Wash hands after handling.
Notes to Canadian Users
Remarques à l’attention des utilisateurs au Canada
Contains mercury / Contient du mercure
For more information on safe handling procedures, the measures to be taken in case of accidental breakage and safedisposal option visit:www.ec.gc.ca/mercure-mercury
Dispose of or recycle in accordance with applicable laws.
Pour plus d’ informations sur les procédures de manutention sécuritaire, les mesures à prendre en cas de bris accidentel et option d’ élimination sécuritaire visitez:www.ec.gc.ca/mercure-mercury/default.asp?lang=Fr&n=DB6D2996-1Éliminez ou les recyclez conformément aux lois applicables.
Declaration of Conformity for EU countries
 `EMC Directive 2004/108/EC (including amendments)
 `Low Voltage Directive 2006/95/EC
Warning
This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures 
						

							19
Notice: Users in EU countries
CE Marking Traceability Information (For EU Countries Only)
Manufacturer:
Ricoh Co., Ltd.
3-6 Nakamagome 1-chome, Ohta-ku, Tokyo. 143-8555,
Japan
Importer:
Ricoh Europe PLC
20 Triton Street, London. NW1 3BF, United Kingdom
User Information on Electrical and Electronic Equipment
Users in the countries where this symbol shown in this section has been specified in national law on collection and treatment of E-waste.
Our Products contain high quality components and are designed to facilitate recycling.Our products or product packaging are marked with the symbol below.
This product contains substances which are harmful to humans and the environment.
•  The lamp contains mercury.
Please dispose of this product or used lamps in accordance with local regulations.
The symbol indicates that the product must not be treated as municipal waste. It must be disposed of separately via the appropriate return and collection syst\
ems available. By following these instructions you ensure that this product is treated correctly and help to re-duce potential impacts on the environment and human health, which could otherwise result from inappropriate handling. Recycling of products helps to conserve natural resources and protect the environment. 
For more detailed information on collection and recycling systems for this product, please contact the shop where you purchased it, your local dealer or sales/service representa-tives.
Notice: Users in Turkey
All Other Users
If you wish to discard this product, please contact your local authorities, the shop where you bought this product, your local dealer or sales/ service representatives. 
						

							20
Notice: Users in the EU
Note for the Battery and/or Accumulator Symbol
In accordance with the Battery Directive 2006/66/EC Article 20 Information for end-users Annex II, the above symbol is printed on batteries and accumulators. This symbol means that in the European Union, used batteries and accumulators should be disposed of separately from your household waste. In the EU, there are separate collection systems for not only used electrical and electronic products but also batteries and accumulators.
Please dispose of them correctly at your local community waste collection/recycling centre.
Notice: Users in Taiwan
.Šf£