Ricoh K3 Manual

5Settings
79
u Caution• Be sure to insert an Eye-Fi card or a Flucard in the SD2 slot. 
If it is inserted in the SD1 slot, the wireless LAN function 
cannot be used. When an Eye-Fi card or a Flucard is not 
inserted in the SD2 slot, the [Wireless Memory Card] settings 
of the  D3 menu cannot be set.
• Be sure to set up a wireless LAN access point on a computer  for the card connection.
• For RAW images and movie files, the success of transfer  depends on the specifications and settings of the Eye-Fi card...

6Appendix
80
×: Not available
Restrictions on the Combinations of Special Functions
Composition Adjust.HDR Capture Save RAW DataDistortion 
CorrectionDigital Filter
Flash×
Drive Mode
Continuous Shooting××
Exposure Bracketing×
Mirror Lock-up Shooting×
Multi-exposure×× ×
Interval Shooting×
Interval Composite×× ××
Interval Movie Record××
HDR Capture×
AA Filter Simulator× 

6Appendix
81
All exposure modes are available when DA, DA L, or FA J lens 
is used, or when a lens with an 9 position is used with the 
aperture ring set to the  9 position.
When they are used in a position other than  9, or other lenses 
are used, the following restrictions apply.
x : Available    #: Restricted    ×: Not available
*1 Lenses with a maximum aperture of F2.8 or faster. Only available at  the 9 position.
*2 Lenses with a maximum aperture of F5.6 or faster.
*3 Available when using the...

6Appendix
82
Depending on the lens being used, the use of the built-in flash 
may be limited.The Shake Reduction function operates by obtaining the lens 
information such as focal length. Set the focal length when 
using a lens of which the focal length information cannot be 
automatically obtained.
1Turn the camera off.
2Attach a lens to the camera and turn the camera 
on.
The [Input Focal Length] screen appears.
3Use  AB to set the focal 
length.
Press  C to select a value from 
the list.
When using a...

6Appendix
83
The shutter can be released even if the aperture ring of the D 
FA, FA, F or A lens is not set to the 9 position or a lens without 
an  9 position is attached.
Select [Enable] in [27. Using Aperture 
Ring] of the  E4 menu.
The following restrictions apply depending on the lens being used.
t  Memo• If the aperture ring is set to a position other than  9, the 
camera operates in  J mode regardless of the mode dial 
setting except when set to L , M  or N  mode.
• [F--] appears for the aperture...

6Appendix
84
Using an optional external flash AF540FGZ, AF540FGZ II, 
AF360FGZ, AF360FGZ II, AF200FG or AF160FC enables a 
variety of flash modes, such as P-TTL auto flash mode.
x: Available    #: Restricted    ×: Not available
*1 Available only when using a DA, DA L, D FA, FA J, FA, F or A lens.
*2 Shutter speed of 1/90 seconds or slower.
*3 When combined with the AF540FGZ, AF540FGZ II, AF360FGZ, or  AF360FGZ II, 1/3 of the flash discharge can be output by the built-in 
flash and 2/3 can be output by...

6Appendix
85
The following functions are available when the optional GPS 
unit O-GPS1 is attached to this camera.
t Memo• Refer to the manual of the GPS unit for details on how to 
attach the unit and information on the unit’s functions.
• To display [Electronic Compass], refer to “Shooting Info  Display” (p.12).
u  Caution• “Simple Navigation” cannot be used with this camera.
1Set the mode dial to  M.
2Select [GPS] in  A2 menu and press  D.The [GPS] screen appears.
3Select [ASTROTRACER] and press  D.The...

6Appendix
86
t Memo• In rare cases, the camera may not operate correctly due to 
static electricity. This can be remedied by taking the battery 
out and putting it back in again. If the camera operates 
correctly, it does not require any repairs.
Troubleshooting
ProblemCauseRemedy
The camera does 
not turn on. Battery is not 
installed properly.
Check the orientation of the 
battery.
The battery power 
is low. Charge the battery.
The shutter cannot 
be released. The built-in flash is 
being charged.
Wait...

6Appendix
87
Dust Alert is the function that detects dust adhering to the 
CMOS sensor and visually displays the location of the dust.
Make sure that the camera is in the following status.
• Attach a DA, DA L, FA J lens or a D FA, FA or F lens that has an  9 position, and set the aperture ring to the  9 position.
• Turn the Stills/Movie switch to  A.
• Set the focus mode switch to  v.
1Select [Dust Alert] in  D4 menu and press D.The [Dust Alert] screen appears.
2Fully display a white wall or other bright...

6Appendix
88
Error Messages
Error MessagesDescription
Memory card full The memory card is full and no more 
images can be saved. Insert a new 
memory card or delete unwanted files.
No image There are no images that can be played 
back on the memory card.
This image cannot be  displayed You are trying to play back an image in a 
format not supported by this camera. You 
may be able to play it back on a computer.
No card in the camera There is no memory card inserted in the 
camera.
Memory card error The...