Ricoh B230 Service Manual

 
 
 
 
LCIT 
B801  

SM i B801 
Read This First 
Safety and Symbols 
Replacement Procedure Safety 
 
ƒ  Turn off the main power switch and unplug the machine before beginning any of 
the replacement procedures in this manual. 
  
Symbols Used in this Manual 
This manual uses the following symbols. 
: See or Refer to 
: Screws 
: Connector 
: Clip ring 
: E-ring  

B801 ii  SM 
B801 
TABLE OF CONTENTS 
Read This First............................................................................................................ i 
Safety and Symbols ......................................................................................... i 
Replacement Procedure Safety .................................................................... i 
Symbols Used in this Manual ........................................................................i 
Table of...

SM iii B801 
Paper Stack Transport ................................................................................... 20 
  

Left and Right Tray 
SM 1 B801 
B801 
LCIT 
1. REPLACEMENT AND ADJUSTMENT 
1.1  LEFT AND RIGHT TRAY 
 
1.  Pull the LCT drawer. 
 
ƒ  If the right tray comes up with the left tray, push the right tray into the LCT. 
2.  Left tray [A] (
 x 2) 
 
3.  Remove the right tray [B] pressing down the stopper [C]. 
 
ƒ  When reinstalling the tray, set the tray on the guide rail and carefully push the 
tray in, making sure to keep the tray level.  

Sensors 
B801 2  SM 
1.2 SENSORS 
1.2.1  PAPER HEIGHT SENSORS ON PAPER STORAGE SIDE 
 
1. Tray (
 Left and Right Tray) 
2.  Rear fence [A] (
 x 1) 
3.  Rear fence bracket [B] (
 x 2) 
4.  Paper height sensors [C] (
 x 1 each) 
1.2.2  END FENCE HP SENSOR/PAPER END SENSOR 2 
 
1.  Bottom cover [D] (s x 1) 
2.  End fence HP sensor [E] (h x 1) 
3.  Paper end sensor 2 (paper storage side) [F] (h x 1)  

Changing the Tray Size 
SM 3 B801 
B801 
LCIT 
1.3  CHANGING THE TRAY SIZE 
 
1.  Remove the fence screws (
 x 5). 
2.  Change the position of the fences. 
 
ƒ  Before fastening the screws, set paper in the tray.  

Motors 
B801 4  SM 
1.4 MOTORS 
1.4.1  TRAY LIFT MOTOR 
 
1.  Securing brackets [A] (
 x 1 each) 
2.  Rear cover [B] (
 x 2) 
 
1.  Tray lift motor [C] (
 x 1,  x 3)