Ricoh Aficio SP 5210SF User Manual

2
Do not incinerate spilled toner or used toner. Toner dust is flammable and might ignite when exposed to
an open flame.
Disposal should take place at an authorized dealer or an appropriate collection site.
Keep toner (used or unused) and toner containers out of reach of children.
3
Safety Labels of This Machine
19
Downloaded From ManualsPrinter.com ManualsCFE019
23 CFE006 CFE003 3  

Do not put your hands inside the machine. The inside of this machine becomes very hot. Do not touch
parts with this label (indicating a hot surface).
4
The inside of this machine becomes very hot. Do not touch parts with this label (indicating a hot surface).
5
The inside of this machine becomes very hot. Do not touch parts with this label (indicating a hot surface).
3. Safety Information for This Machine
20
Downloaded From ManualsPrinter.com ManualsCFE072
4
5 CFE001 CFE002 3  

Positions of WARNING and CAUTION labels on Type 3
This machine has labels for WARNING and CAUTION at the positions shown below. For safety,
please follow the instructions and handle the machine as indicated.
1
Type 3 weighs approximately 52 kg (114.7 lb.). When moving the machine, use the inset grips on both
sides. At least four people are needed to lift the machine.
Safety Labels of This Machine
21
Downloaded From ManualsPrinter.com Manuals  CFE073
1 CFE004 3  

2
Do not incinerate spilled toner or used toner. Toner dust is flammable and might ignite when exposed to
an open flame.
Disposal should take place at an authorized dealer or an appropriate collection site.
Keep toner (used or unused) and toner containers out of reach of children.
3
3. Safety Information for This Machine
22
Downloaded From ManualsPrinter.com ManualsCFE018
2
3
4 CFE006 CCS037 3  

Keep your hands clear of the finisher when removing the staple cartridge. You might trap your fingers if
you do not.
4
Do not put your hands inside the machine. The inside of this machine becomes very hot. Do not touch
parts with this label (indicating a hot surface).
5
The inside of this machine becomes very hot. Do not touch parts with this label (indicating a hot surface).
6
Safety Labels of This Machine
23
Downloaded From ManualsPrinter.com ManualsCFE003 CFE020
5
6 CFE001 3  

The inside of this machine becomes very hot. Do not touch parts with this label (indicating a hot surface).
Power Switch Symbols
The meanings of the symbols for the switches on this machine are as follows: •
 : POWER ON
•
 : STANDBY
3. Safety Information for This Machine
24
Downloaded From ManualsPrinter.com ManualsCFE002   3  

Laws and RegulationsLaser Safety
CDRH Regulations
This equipment complies with requirements of 21 CFR subchapter J for class I laser products. This equipment contains two AlGaAs laser diodes, 6.2 milliwatts, 770 
 795 nanometer wavelength for
each emitter. The beam divergence angle is 25 degrees (minimum) and 38 degrees (maximum) in the
vertical direction, and 8 degrees (minimum) and 14 degrees (maximum) in the horizontal direction, and
laser beams are generated in Continuous Wave (CW) mode.
Caution:
Use...

Model Number:• SP 5200S/Aficio SP 5200S
• SP 5210SF/Aficio SP 5210SF
• SP 5210SR/Aficio SP 5210SR
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause...

connected to a compatible modular jack that is also compliant. See installation instructions for
detail.
4. The REN is used to determine the number of devices that may be connected to a telephone line. Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming
call. In most but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the
number of devices that may be connected to a line, as determined by the total RENs, contact the
local...

other entity, or individual. (The telephone number provided may not be a 900 number or any other
number for which charges exceed local or long-distance transmission charges.)
In order to program this information into your FAX machine, you should complete the following steps:
Follow the FAX HEADER programming procedure in the Programming chapter of the operating
instructions to enter the business identification and telephone number of the terminal or business. This
information is transmitted with your...