Proxima Dp9240 Projector User Manual

							Problem:
No power.
Image is out of focus.
Try these Solutions:
lPlug the projector into an AC outlet.
lTurn the MAIN ON/OFF switch to ON.
lPress the POWER ON/OFF switch to ON.
lBe sure the READY INDICATOR light is ON.
lWait approximate 2 minutes after the projector is turned OFF before turning the
projector back on.
NOTE: After pressing the POWER ON/OFF button to OFF. The projector functions
as indicated.
1. The LAMP POWER indicator will light and the READY indicator will turn off.
2. After approximate 2 minutes, the READY indicator will light green again and the
projector may be turned on by pressing the POWER ON/OFF button.
lCheck temperature warning indicator. If the indicator flashes red, the projector
cannot be turned on.
(See BASIC OPERATION section on page 27).
lCheck the projection lamp.
lReplace the lamp cover. (Check the interlock switch inside of the lamp cover.) 
lAdjust the focus.
lMake sure the projection screen is at least  4.6 (1.4 m) from the projector.
lCheck the projection lens to see if it needs cleaning.
NOTE:Moving the projector from a cool temperature location to a warm
temperature location may result in moisture condensation on the lens. In
such an event, leave the projector OFF and wait until condensation
disappears.
51
Before calling your dealer or service station for assistance, check the items below once again.
1. Make sure you have connected the projector to your equipment as described in section CONNECTING THE
PROJECTOR on pages 11 ~ 18.
2. Check cable connections. Verify that all computer, video and power cords are properly connected.
3. Verify that power is switched on.
4. If the projector still does not display an image, re-start the computer.
5. If the image still does not display, unplug the projector from the computer and check the computer monitors display.
The problem may be with your graphics controller rather than with the projector. (When you reconnect the projector,
remember to turn the computer and monitor off before you power up the projector. Power the equipment back up in
order of: Projector and computer)
6. If the problem still exists, check the following chart.
TROUBLESHOOTING
APPENDIX
Follow these steps to clean the projection lens:
1. Apply a non-abrasive camera lens cleaner to a soft, dry cleaning cloth.
Avoid using an excessive amount of cleaner.
Abrasive cleaners, solvents or other harsh chemicals might scratch the lens.
2. Lightly wipe the cleaning cloth over the lens.
3. When you are not using the projector, replace the lens cover.
CLEANING THE LENS
USA 
						

							No sound.
52
Problem:
Check Ceiling feature.
(See OTHER FUNCTION SETTING section on pages 46 ~ 47).
Picture is L/R Reversed.Check Ceiling/Rear feature.
(See OTHER FUNCTION SETTING section on pages 46 ~ 47).
Picture is T/B inverted.
Check Display feature.
(See OTHER FUNCTION SETTING section on pages 46 ~ 47).Some displays are not seen
during the operation.
lCheck audio cable connection from audio input source.
lAdjust audio source.
lPress the VOLUME (+) button.
lPress the MUTE button.
Remote control unit does not
work.
lCheck the cable connection between the projector and the computer.
lCheck the mouse setting on your computer.
lTurn on the projector before you turn on the computer.Wireless mouse function
does not work.
Try these Solutions:
APPENDIX
If you still need help after checking the table above, you
should call your dealers technical support line and
explain your problem.
If your dealer cannot solve your problem, please call
Proximas customer service.  The number is :
USA or Canada Phone (800) 447-7692
FAX    (858) 457-9647
Rest of Word Phone (858) 457-5500
Europe Phone  +31-43-358-5210
Support FAX     +31-43-358-5202
www.proxima.com In the event that your unit is determined to be defective,
youll be issued a Return Authorization Number.
After youve received this number, send the unit, a copy
of your sales receipt, and a description of the problem,
freight prepaid, to Proxima. Clearly note the Return
Authorization Number on the outside of the shipping
box.
Where to Get Help : 
USA
lCheck the batteries.
lMake sure nothing is blocking between the remote control sensor and
remote control unit.
lMake sure you are not too far from the projector when using the remote
control unit. Maximum operate range 16.4  (5 m).
lCheck the ALL-OFF switch on the Remote Control Unit is set to ON.
lCheck the transmitted signal mode from the remote control unit.
(See OTHER FUNCTION SETTING section on pages 46 ~ 47). 
						

							53
TECHNICAL SPECIFICATIONS
Proxima Desktop Projector 9260/9240
APPENDIX
100 ~ 120 V, 200 ~ 240 V AC, 50/60 Hz
3.6/1.8 A (Max. Ampere)
41°F ~ 95°F ( 5°C ~ 35°C)
14°F ~ 140°F (-10°C ~ 60°C)
Projector Type
Dimensions (W x H x D)
Net Weight
LCD Panel System
Number of Pixels
Color System
Scanning Frequency
Projection Image Size (Diagonal) 
Projection Lens
Throw Distance
Projection Lamp
AV Input Jacks
Computer Audio Input Jacks
Computer Input Jacks
Built-in Speaker
Image Elevation Adjustment
Voltage
Power Consumption
Operating Temperature
Storage Temperature
Remote Control Transmitters
10.7 (272 mm) x 6.1 (154 mm) x 16.2 (412.5 mm)
15.6 Ibs (7.1 kg)
1.3 TFT Active Matrix type  x 3 panels
2,359,296 {786,432 (1,024 x 768) x 3}
6 color system (PAL, SECAM, NTSC, NTSC4.43, PAL-M and PAL-N)
H-sync. 15 ~ 100 KHz, V-sync. 50 ~ 100 Hz
Adjustable from 31 to 400
F1.8 ~ 2.1 lens with f=48.4 mm ~ 62.8 mm Motor zoom and focus
4.6 (1.4 m) ~ 47.3 (14.4 m)
200 watt type
RCA Type 3 x 2 sets (Video, Audio R and L), (Y, Cb/Pb, Cr/Pr)
and DIN 4 pin (S-Video) x 1 
Mini Stereo Type  x 2 
Computer Output Jack
Other Jack(VGA) HDB 15 Terminal
EXT. Speaker Jack (Stereo) x 1(VGA) HDB 15 Terminal x 2, DIN 8 pin (Control port) x 2
INT. SP. Stereo (R and L), 2 watt RMS (T.H.D.10%)
Up to 6 °
USA
Wireless Remote Control with Laser Beam (Class Laser)
Max. Output 1mW/Wave Length 650 ± 20nm, batteries (2) AA, UM3 or R06 type.
Horizontal Resolution800 TV lines
This symbol on the nameplate means the product is Listed by Underwriters
Laboratories Inc.  It is designed and manufactured to meet rigid U.L. safety
standards against risk of fire, casualty and electrical hazards. 
						

							Proxima Corporation warrants that the Proxima® Desktop Projector Model 9260/9240 product
manufactured by Proxima is free from defects in materials and workmanship under normal use during the
Warranty Period.  The Warranty Period commences on the day of purchase by the end-user.  The
Warranty Period is two years.  The projector lamp is not covered by this Warranty.
Each Proxima product is manufactured from new parts, or new and some used parts.  In some cases, the
product may have been delivered to another end-user and then returned.  In all cases, the product has
undergone testing and quality inspection, and Proximas full warranty terms apply.
The end-users sales receipt or invoice showing the date of purchase of the product and the name of the
Reseller is proof of the date of purchase.  The Warranty extends only to the original purchaser and is not
transferable.
During the Warranty Period, Proxima will, at no additional charge, repair or replace defective parts or at the
option of Proxima, replace the entire unit.
This Limited Warranty does not extend to any Proxima product that has been damaged or been rendered
defective (a) as a result of accident, misuse, or other abuse; (b) by the use of parts not manufactured or
sold by Proxima; or (c) by modification of the product; or (d) as a result servicing by non-authorized
personnel.
Warranty
Limitation of Warranties
The foregoing warranty is expressly in lieu of any other express or implied warranties, including, without
limitation, warranties of merchantability or fitness for a particular purpose. To the extent not prohibited by
law, all statutory warranties are hereby waived and excluded from this warranty.  Proxima expressly
disclaims all warranties not stated in this Limited Warranty.
USA
54 
						

							For Americas:
Proxima Corporation
9440 Carroll Park Drive
San Diego, CA 92121
Ph: (858) 457-5500
(800) 447-7692 (U. S. and Canada.)
Fax. (858) 457-9647
www.proxima.com For Europe, Asia, Africa, Australasia:
ASK Proxima ASA
K. G. Meldahlsvei 9
Postboks 1403
N-1602 Fredrikstad
tel. +47-69 34 01 55
fax.  +47-69 34 06 32
Technical Support & Service
Horsterweg 24
6191 RX Beek
The Netherlands
tel. +31-43 358 5210
fax.  +31-43 358 5202
1 /2000
610 282 2038  (1AA6P1P2055-- MF6F)Printed in Japan
Part No. 710-00843-1