Proxima Dp5800 Projector User Manual

Symbols Used in this Guide ... 3
Safety Precautions ................. 4
Your DP5800 Projector ........... 6
Installation .............................. 8
Using the Projector ................. 9
Projector Messages and
Indicators ....................  11
Using the Menus .................. 12
Connecting to a Video
Source ......................... 17
Connecting to an
RGB Signal ................. 17
Connecting to a Control
Signal .......................... 20
System Setup ....................... 25
Cleaning...

2
  For Customers in the United Kingdom
THIS PRODUCT IS SUPPLIED WITH A TWO-PIN MAINS PLUG FOR USE IN MAINLAND EUROPE.
FOR USE IN THE U.K., PLEASE REFER TO THE NOTES ON THIS PAGE.
 IMPORTANT FOR THE UNITED KINGDOM
The mains lead on this equipment is supplied with a moulded plug incorporating a fuse, the value of which is
indicated on the pin face of the plug. Should the fuse need to be replaced, an ASTA or BSI approved BS 1362
fuse must be used of the same rating. If the fuse cover is detachable, never...

3
WARNING:  This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.  This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation...

4
If any unusual performance occurs.
¥An abnormal smell or smoke may indicate the possibility
of fire or electric shock, etc.  When any unusual
performance is observed, immediately turn off the power
switch and pull out the power plug from the power outlet.
Check that there is no smoke, etc., and then contact your
dealer to repair the unit.  Do not repair it yourself .
¥Do not use this unit as it is after
trouble has occurred, such as ÒNo
pictureÓ,ÒNo soundÓ, ÒAbnormal
soundÓ, etc.  This may cause a...

5
¥When inserting batteries in this unit, pay
attention to the direction of the 
 and 
polarity indications and insert the batteries
correctly.  If the polarities are confused, it
may cause injury or damage near the unit
due to burst batteries, liquid leakage, etc.
Long term without use.
When you are not going use this
unit for a long time be sure to pull
the power plug from the power
outlet and cover the lens.
Clean inside the unit every 24 months.
Ask your dealer to clean inside the unit at least
once...

6
Input menu reset
mute zoom
focuspowertemp
lamp
S-VIDEO VIDEO
AUDIO LR
AC SW
AC IN
AUDIO
INAUDIO
OUTRGB IN
RGB OUT
CONTROL
Your DP5800 Projector
The remote control will function within
16 feet of the projector sensor  and
within 30° to both the left and right.
Speaker
Handle
Cooling fan
(exhaust)LensCooling fan
(intake) Remote control
sensorRemote control
sensor
INPUT buttonTo select the input source.
Each time this button is pressed, the input source is
changed in sequence as shown below.
RGB1 
 RGB2...

7
RIGHT
STANDBY/ON
RISET
FOCUS ZOOM
TIMER
BLANK
POSITION MUTE
RGB1/2 VIDEO1/2
INPUTVOL
MENU
RIGHTRESET
Your DP5800 Projector (continued)
Remote control
How to insert batteries
1 . Remove the battery
compartment cover.
Slide the battery compartment
cover in the direction of the
arrow while pressing slightly
down on it.
2 . Insert the batteries as
illustrated inside the
battery compartment.
3 . Replace the cover.
CautionCautions on remote
control use
¥ Do not drop the remote control or apply any shock to...

8
Screen (inches)
40
60
80
100
120
150
200
Installation
Projector and screen setup
Determine proper picture size and projection distance as illustrated below.
Using the foot adjusters
1.  Lift up the projector and unlock the foot adjusters.
2.  Adjust the feet to the best viewing angle, and then lock the foot adjusters.
3.  To adjust the angle slightly, rotate the foot adjusters.
a (inches)
Minimum
60
89
119
149
179
224
298Maximum
89
134
179
224
269
336
448b (inches)
3.4
5.1
6.9
8.6
10.3
12.9
17.2
Adjust...

9
Using the Projector
Projecting the picture
1Turn the MAIN POWER switch of the projector on. [ ê : ON]
¥ The ON indicator will glow orange.
2Press the STANDBY/ON button.
¥ The ON indicator blinks (green) and then glows (green).
3Remove the lens cap.
4Adjust the picture size using the ZOOM buttons.
5Adjust the focus using the FOCUS buttons.
(1) Press the FOCUS button.  The on-screen display shown on the right appears.
(2) Press the Focus +/- buttons until the picture is clear.
6Turn on all connected...

10
Using the Projector (continued)
Turning off the power
1Press and hold the STANDBY/ON button for 1 second.
¥ The ON indicator lights up orange and the lamp turns off.  About 1 minute later, the fan stops and the
indicator blinks orange.
NOTE:If you press the STANDBY/ON button for less than 1 second, the projector will not switch
to Standby mode.
2Turn the MAIN POWER switch of the projector off. [    : OFF]
3Replace the lens cap.
1
21
3
CautionDo not turn off the projectorÕs MAIN POWER switch before...