Projector Christie Mirage S2k User Manual

Appendix D: Throw Distance 
 
 User’s Manual     D-7 
 
  

Appendix D: Throw Distance 
D-8     
 User’s Manual 
 
 
  

Appendix D: Throw Distance 
 
 User’s Manual     D-9 
 
  

Appendix D: Throw Distance 
D-10     
 User’s Manual  

Appendix E 
System Integration 
 
 User’s Manual     E-1 
The GPIO (General Purpose Input Output) connector located on the input panel provides a flexible 
method of interfacing a wide range of external I/O devices to the projector. There are 7 GIO pins 
available on the 9pin D-Sub GPIO connector, which are configurable via RS232 commands. The other 
two pins are reserved for ground and power – see table below for pin identification. 
 
GPIO Pins 
Pin #  Signal 
1  + 12V (200mA) 
2 GPIO 1 
3 GPIO 2 
4...

Appendix E: System Integration 
E-2     
 User’s Manual 
Query Command 
(GIO?)  Request the state and configuration of all pins 
(GIO! “HHLLHLH” “OOIOOOI”)   Reply of pin state and configuration 
(GIO? C2)  Request configuration for pin #2 
(GIO! C2 O)  Reply with pin #2 configuration as output 
(GIO? 2)  Request the state of pin #2 
(GIO! H)  Reply with pin #2 state as high 
 
Real Time Event 
Use the serial command RTE to specify an action that is initiated at a particular time or based 
on an external...

Appendix F 
Optional Input Modules 
 
 User’s Manual     F-1 
There are many optional input modules and accessories currently available for this 
projector. Contact your dealer for a complete and up-to-date listing. 
 
The RGB500 Input Module may be installed in this projector, a Marquee Signal 
Switcher, or a Marquee Case/Power Supply. The module receives analog RGB input 
signals from computers or other RGB source devices. 
 
RGB500 Features 
◊ accepts 3, 4, or 5 wire RGB video (sync-on-green,...

Appendix F: Optional Input Modules 
F-2    
  User’s Manual 
The RGB400 ALT Input Module may be installed in this projector, a Marquee Signal 
Switcher, or a Marquee Case/Power Supply. The module receives analog RGB input 
signals from computers or other RGB source devices. Video inputs are 75
Ω 
terminated. Video outputs provide buffered loop-through to another display device. 
 
RGB400ALT Features 
◊ accepts 3, 4, or 5 wire RGB video (sync-on-green, composite sync, or 
separate horizontal and vertical...

Appendix F: Optional Input Modules 
 
 User’s Manual     F-3  
 
This module can display digital video input signals conforming to the DVI (Digital 
Visual Interface) single-channel standard. 
 
Features  ◊  supports Digital Visual Interface (DVI) single-channel  
◊   supports VESA  Extended Display Identification Data (EDID )  
◊   provides an active-loop-through using a DVI connector (conforming to 
the DVI Specification) 
 
The module accepts a serial digital 4:2:2 component video signal (YCbCr) via...