Plus Projector U6 132 User Manual

							
U6-112
U6-132
U6-232
DATA PROJECTOR
USER’S MANUAL 
						

							
PBEnglish i English
Regulation & safety notices
This appendix lists the general notices of your Projector. 
FCC notice 
This  device  has  been  tested  and  found  to  comply  with  the  limits  for 
a  Class  B  digital  device  pursuant  to  Part  15  of  the  FCC  rules.  These 
limits  are  designed  to  provide  reasonable  protection  against  harmful 
interference  in  a  residential  installation.  This  device  generates,  uses, 
and  can  radiate  radio  frequency  energy  and,  if  not  installed  and  used 
in  accordance  with  the  instructions,  may  cause  harmful  interference  to 
radio communications. 
However,  there  is  no  guarantee  that  interference  will  not  occur  in  a 
particular  installation.  If  this  device  does  cause  harmful  interference 
to  radio  or  television  reception,  which  can  be  determined  by  turning 
the  device  off  and  on,  the  user  is  encouraged  to  try  to  correct  the 
interference by one or more of the following measures: 
• Reorient or relocate the receiving antenna. 
• Increase the separation between the device and receiver. 
•  Connect  the  device  into  an  outlet  on  a  circuit  different  from  that  to  
which the receiver is connected. 
•  Consult  the  dealer  or  an  experienced  radio/television  technician  for  
help.
Notice: Shielded cables 
All  connections  to  other  computing  devices  must  be  made  using 
shielded cables to maintain compliance with FCC regulations. 
Caution 
Changes  or  modifi  cations  not  expressly  approved  by  the  manufacturer could  void  the  user’s  authority,  which  is  granted  by  the  Federal 
Communications Commission, to operate this product. 
Regulation & safety notices 
						

							
iiEnglish 1 EnglishiiEnglish iiEnglish 1 English
Operation conditions 
This device complies with Part 15 of the FCC Rules. Operation is subject 
to the following two conditions: 
1.  this device may not cause harmful interference, and
2.  this  device  must  accept  any  interference  received,  including interference that may cause undesired operation.
Notice for Canadian users: 
This Class B digital apparatus complies with Canadian ICES-003. 
Remarque à l’intention des utilisateurs canadiens 
Cet appareil numerique de la classe B est conforme a la norme NMB-003 du Canada. 
Declaration of Conformity for EU countries 
EMC Directive 89/336/EEC (including amendments)
Low Voltage Directive 73/23/EEC (amended by 93/68/EEC)
R & TTE Directive 1999/EC (if product has RF function)
Regulation & safety notices 
						

							
iiEnglish 1 EnglishiiEnglish 1 English1 English
Table of Contents
Table of Contents ........................................................................\
.................1
Usage Notice ........................................................................\
........................2
Safety Information ........................................................................\
........................2
Precautions........................................................................\
...................................3
Eye safety Warning ........................................................................\
......................5
Introduction........................................................................\
...........................6
Product Features ........................................................................\
..........................6
Package Overview........................................................................\
........................7
Product Overview ........................................................................\
.........................8
Main Unit ........................................................................\
................................................8
Control Panel ........................................................................\
.........................................9
Connection Ports ........................................................................\
.................................10
Wireless Remote Control ........................................................................\
.....................11
Installation ........................................................................\
..........................12
Connecting the Projector ........................................................................\
............12
Powering On/Off the Projector ........................................................................\
....13
Powering On the Projector ........................................................................\
...................13
Powering Off the projector ........................................................................\
...................14
Warning Indicator ........................................................................\
.................................14
Adjusting the Projected Image........................................................................\
....15
Adjusting the Projector Image Height ........................................................................\
..15
Adjusting the Projector Zoom / Focus ........................................................................\
..16
Adjusting Projected Image Size ........................................................................\
...........16
User Controls ........................................................................\
.....................17
Control Panel & Remote Control ........................................................................\
17
Remote Control Range  ........................................................................\
.......................20
On-Screen Display Menus........................................................................\
..........21
How to operate  ........................................................................\
....................................21
Menu Tree ........................................................................\
............................................22
Picture (Computer Mode/ Video Mode) .......................................................................23
View (Computer Mode/ Video Mode)  ........................................................................\
..25
Audio ........................................................................\
....................................................27
Language ........................................................................\
.............................................28
Setting ........................................................................\
..................................................29
Lamp Setting  ........................................................................\
.......................................31
Appendices........................................................................\
.........................32
Troubleshooting ........................................................................\
..........................32
Replacing the lamp ........................................................................\
.....................36
Compatibility Modes ........................................................................\
...................37
Ceiling Mount Installation ........................................................................\
...........39
Important ........................................................................\
....................................40
Specifi cation ........................................................................\
...............................41 
						

							
2English 3 English
2English 3 English

Usage Notice

Safety Information
The lightning fl ash with arrowheard within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous \
volt-age” within the product’s enclosure that may be of suffi cient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of import operating and maintenance (servicing\
) instructions in the literature accompanying the appliance.
 WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH VOLTAGES ARE PRESENT INSIDE THE ENCLOSURE. DO NOT OPEN THE CABINET. REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
Class B emissions limitsThis Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Important Safety Instruction  1.  Read these instructions –before using this projector.  2.  Keep these instructions –for future reference.  3.  Follow all instructions.  4.  Install in accordance with the manufacturer’s instructions  A. Do not block any ventilation openings   To ensure reliable operation of the projector and to protect it from overheating, put the projector in a position and location that will not \
interfere with its proper ventilation. For example, do not place the projector on a bed, sofa, carpet, or similar surface that may block the \
ventilation openings. Do not put it in an enclosure, such as a bookcase \
or a cabinet that may keep air from fl  owing through its ventilation openings.  B. Do not use this projector near water or moisture.  To reduce the risk of fi  re or electric shock, do not expose the projector to rain or moisture. C. Do not install near any heat sources, such as radiators, heaters, stoves or other apparatus (including amplifi  ers) that produce heat.  5.  Clean only with a dry cloth.   6.  Only use attachments/accessories specifi  ed by the manufacturer.  7.  Refer all servicing to qualifi  ed service personnel. Servicing is required when the projector has been damaged in any way:
 Such as power cable or plug is damaged. Liquid has been spilled or objects have fallen into the apparatus. The projector has been exposed to rain or moisture, does not operate normally, or has been dropped.Do not attempt to service this projector yourself. Opening or removing covers may expose you to dangerous voltages or other hazards. Please call to an authorized service center near you.  8.  Do not let objects or liquids enter the projector –as they may touch \
dangerous voltage points or short-out parts that could result in a fi  re or electric shock.  9.  See projector enclosure for safety related markings.10.  The projector should not be adjusted or repaired by anyone except properly qualifi  ed service personnel. 
						

							
2English 3 English
2English 3 English

Usage Notice

3
 English

Do not look into the projector’s lens when the lamp is on. 
The bright light may hurt your eyes.
To reduce the risk of fi  re or electric shock, do not expose 
this product to rain or moisture.
Please do not open or disassemble the product as this may 
cause electric shock.
When changing the lamp, please allow unit to cool down, 
and follow all changing instructions.
This product will detect the life of the lamp itself.  Please 
be sure to change the lamp when it shows warning 
messages.
Reset the “Lamp Timer Reset” function from the On 
Screen Display “Lamp Setting” menu after replacing the 
lamp module (Refer to page 31).
When switching the projector off, please ensure the 
projector completes its cooling cycle before disconnecting 
power.
Turn on the projector fi  rst and then the signal sources.
Do not use lens cap when projector is in operation.
When the lamp reaches the end of its life, it will burn out 
and may make a loud popping sound.  If this happens, the 
projector will not turn back on until the lamp module has 
been replaced. To replace the lamp, follow the procedures 
listed under “Replacing the Lamp”. (See page 36)
 Precautions
Follow all warnings, precautions and maintenance as 
recommended in this user’s guide to maximize the life of 
your unit. 
						

							
4English 5 English
4English 5 English

Usage Notice

Do:
  Turn off the product before cleaning.
  Use a soft cloth moistened with mild detergent to clean 
the cabinet of the unit.
  Disconnect the power plug from AC outlet if the product 
is not being used for a long period of time.
Don’t:
  Block the slots and openings on the unit provided for 
ventilation.
  Use abrasive cleaners, waxes or solvents to clean the unit.
  Use under the following conditions:
   -  In extremely hot, cold or humid environments.
    -  In areas susceptible to excessive dust and dirt.
    -  Near any appliance that generates a strong magnetic fi  eld.
    - In direct sunlight. 
						

							
4English 5 English
4English 5 English

Usage Notice

Eye Safety Warnings
 Avoid staring directly into the projector beam at all times.
 Minimize standing facing into the beam. Keep your back to 
the beam as much as possible.
 A stick or laser pointer is recommended to avoid the need for 
the user to enter the beam. 
 When projector is used in a classroom, adequately supervise 
students when they are asked to point out something on the 
screen.
 In order to minimize the lamp power needed, use room 
blinds to reduce ambient light levels. 
						

							
6English 7 English
6English 7 English

 Introduction

 Product Features
 
U6-112 - SVGA single chip 0.55” DLP® projector. 
U6-132 / U6-232 - XGA single chip 0.55” DLP® projector. 
Outstanding features include:
Single chip Dark Chip2TM DLP® technology
NTSC3.58/NTSC4.43/PAL/PAL-M/PAL-N/SECAM and HDTV compatible (480i/p, 576i/p, 720p, 1080i)
Multi-Auto functions: Auto detection, Auto image and Auto saving the adjustments
Full function remote control
User friendly multilingual on screen display menu 
Advanced digital keystone correction and high quality full screen image re-scaling
User friendly control panel
Built-in one speaker with 2 Watt amplifi  er
SXGA compression and XGA, VGA, re-sizing (U6-112)
SXGA+, SXGA compression and SVGA, VGA, re-sizing 
(U6-132/U6-232)
Mac compatible 
						

							
6English 7 English
6English 7 English

Introduction

 Package Overview
This projector comes with all the items shown below.  
Check to make sure your unit is complete.  Contact your 
local reseller immediately if anything is missing.
 Due to the difference in applications for each country, some regions may have different accessories.
User’s Manual (CD-ROM)Wireless Remote Controller
2 x AAA Batteries
Power Cable 1.8mRGB Signal Cable 1.8mProjector with lens cap
Carrying Case
Quick Start Card