Philips 22hfl4371d User Manual

							39
English
EN
HDMI cable and HDMI-DVI adaptor• 
 
VGA cable• 
 
Use a Conditional Access 
Module
A Conditional Access Module (CAM) is 
provided by digital TV ser vice operators to 
decode digital TV channels.
Note
If required, refer to documentation from your  •operator on how to inser t a smar t card into the Conditional Access Module.
DVI
LEFT / RIGHT
HDMI 1 / DV IAUDIO IN :
PC IN(AUDIO)Fo
r TV of size 26 inch and la rger
Fo
r TV of size 22 inch
VG A
VG A
PC IN(AUDIO)
For TV of size 22 inch only   
Insert and activate a CAM
Caution
Be sure to follow the instructions described  •below. Wrong inser tion of a CAM may damage both the CAM and your T V.
1 Switch off the T V.
2 Following the directions printed on the 
CAM, gently inser t the CAM into the 
COMMON INTERFACE at the side of the 
T V.
 
3 Push the CAM in as far as it will go.
4 Turn on the T V and wait for the CAM to be 
activated. This may take several minutes. Do 
not remove the CAM from the slot when 
in use — removing the CAM will deactivate 
digital ser vices.
Access CAM services
1 Af ter inser ting and activating the CAM, 
press  MENU.
2 Press  to select [Setup] > [Fe atures] 
> [Common interface].
Applications provided by the digital TV  »
ser vice operator appear on the screen.
Note
This menu option is available only if the CAM  •is inser ted and activated correctly.
 
						

							40EN
Use Philips EasyLink
Your TV suppor ts Philips EasyLink, which 
enables one-touch play and one-touch standby 
between EasyLink-compliant devices. 
Note
Compliant devices must be connected to your  •T V via HDMI.
Enable or disable EasyLink
Note
Do not enable Philips EasyLink if you do not  •intend to use it.
1 Press MENU.
2 Press  to select [Setup] > 
[Installation] > [Preferences] > 
[EasyLink].
3 Select [On] or [Of f ].
Use one-touch play
1 Af ter enabling EasyLink, press play on 
your device. 
The TV automatically switches to the  »
correct source.
Use one-touch standby
1 Press and hold Standby on the T V ’s or 
device’s remote control for at least three 
seconds. 
The TV and all connected HDMI  »
devices switch to standby.
Use a Kensington lock
There is a Kensington security slot at the back of 
the TV. Prevent theft by looping a Kensington lock 
between the slot and a permanent object, such as 
a heavy table.
 
 
						

							41
English
EN
9 Product 
information
Product information is subject to change without notice. For detailed product 
information, go to www.philips.com/suppor t.
Supported display resolutions
Computer formatsResolution • - refresh rate:
640 x 480 - 60Hz• 
800 x 600 - 60Hz• 
1024 x 768 - 60Hz• 
1280 x 720 - 60Hz• 
1280 x 768 - 60Hz• 
1280 x 1024 - 60 Hz• 
1360 x 768 - 60 Hz • 
1440 x 900 - 60Hz (For Full HD only)• 
1680 x 1050 - 60Hz (For Full HD only)• 
Via HDMI/DVI input• Video formatsResolution • - refresh rate:480i - 60Hz• 
480p - 60Hz• 576i - 50Hz• 576p - 50Hz• 720p - 50Hz, 60Hz• 1080i - 50Hz, 60Hz• 1080p - 24Hz, 25Hz, 30Hz, 50Hz, • 
60Hz.
Multimedia
Supported • storage device: USB (Only FAT or FAT 32 USB storage devices are suppor ted) Supported • multimedia file formats:Images: • JPEG
Audio: • MP3
Note
Multimedia file names must not exceed 128  •characters. 
Tuner/Reception/Transmission
Aerial • input: 75ohm coaxial (IEC75)DVB: • DVB Terrestrial, DVB -T MPEG4 (only 
in some models)TV • system: DVB COFDM 2K /8K; PAL I, B/G, D/K; SECAM B/G, D/K , L /L’ Video • playback: NTSC , SECAM, PALTuner • Bands: Hyperband, S-channel, UHF, 
VHF
Remote control
Type: • RC-6
• Batteries: 2 x A A A (LR03 type)
Power
Mains • power: 220 -240V, 50Hz ~ 60HzStandby • power: < 0.3WAmbient • temperature: 5 to 40 degrees 
Celsius
Supported TV mounts
To mount the TV, purchase a Philips TV mount or a VESA-compatible TV mount. To prevent damage to cables and connectors, be sure to leave a clearance of at least 2.2 inches or 5.5cm from the 
back of the TV.
Warning
Follow all instructions provided with the T V  •mount. Koninklijke Philips Electronics N.V. bears no responsibility for improper T V mounting that results in accident, injur y or damage.
TV screen 
size (inches)
Required 
pitch (mm)
Required 
mounting bolts
22100 x 1004 x M4
26100 x 2006 x M4
32200 x 2004 x M6
 
						

							42EN
10 Troubleshooting
This section describes commonly encountered 
issues and accompanying solutions.
General TV issues
The TV does not switch on:
Disconnect the power cable from the  •
power outlet. Wait for one minute then 
reconnect it.
Check that the power cable is securely  •
connected.
The remote control is not working properly:
Check that the remote control   are  •
correctly inser ted according to the +/- 
orientation.
Replace the remote control batteries if  •
they are flat or weak.
Clean the remote control and T V sensor  •
lens.
The standby light on the TV blinks red:
Disconnect the power cable from the  •
power outlet. Wait until the T V cools 
down before reconnecting the power 
cable. If the blinking reoccurs, contact 
Philips Consumer Care. 
You forgot the code to unlock the TV lock 
feature
Enter ‘8888’. •
The TV menu is in the wrong language.
Change the T V menu to your preferred  •
language.
When turning the TV on/off to standby, you 
hear a creaking sound from the TV chassis:
No action is required. The creaking sound  •
is normal expansion and contraction of 
the T V as it cools down and warms up. 
This does not impact per formance.
When TV start-up time is slow:
Select  •[Fast] mode in [Low power 
st andby] menu. 
TV channel issues
Previously installed channels do not appear in 
the channel list:
Check that the correct channel list is  •
selected.
No digital channels were found during the 
installation:
Check that the T V suppor ts DVB -T or  •
DVB -C in your countr y. See the listed 
countries on the back of the T V.
Picture issues
The TV is on, but there is no picture:
Check that the antenna is properly  •
connected to the T V.
Check that the correct device is selected as  •
the T V source.
There is sound but no picture:
Check that the picture settings are correctly  •
set.
There is poor TV reception from an antenna 
connection:
Check that the antenna is properly  •
connected to the T V.
Loudspeakers, unear thed audio devices,  •
neon lights, high buildings and other large 
objects can influence reception quality. 
If possible, tr y to improve the reception 
quality by changing the antenna direction or 
moving devices away from the T V.
If reception on only one channel is poor,  •
fine tune this channel.
There is poor picture quality from connected 
devices:
Check that the devices are connected  •
properly.
Check that the picture settings are correctly  •
set. 
The TV did not save your picture settings:
• Check that the T V location is set to the 
home setting. This mode offers you the 
flexibility to change and save settings.
 
						

							43
English
EN
The	picture	does	not	fit	the	screen;	it	is	too	
big or too small:
Tr y using a different picture format. •
The picture position is incorrect:
Picture signals from some devices may  •
not fit the screen correctly. Check the 
signal output of the device.
Sound issues
There is a picture but sound quality is poor:
Note
If no audio signal is detected, the T V  •automatically mutes the audio output — this does not indicate malfunction.
Check that all cables are properly  •
connected.
Check that the volume is not set to 0. •
Check that the sound is not muted. •
There is a picture but the sound quality is 
poor:
Check that the sound settings are  •
correctly set.
There is a picture but sound comes from one 
speaker only:
Verify that sound balance is set to the  •
centre.
HDMI connection issues
There are problems with HDMI devices:
Note that HDCP suppor t can delay the  •
time taken for a T V to display content 
from a HDMI device. 
If the T V does not recognize the HDMI  •
device and no picture is displayed, tr y 
switching the source from one device to 
another and back again.
If there are intermittent sound  •
disruptions, check that output settings 
from the HDMI device are correct.
If a HDMI-to-DVI adaptor or HDMI to  •
DVI cable is used, check that an additional 
audio cable is connected to AUDIO L/R or 
AUDIO IN (mini-jack only).
Computer connection issues
The computer display on the TV is not stable:
Check that a suppor ted resolution and  •
refresh rate is selected on the computer.
Set the T V picture format to unscaled. •
Contact us
If you cannot resolve your problem, refer to 
the FAQs for this product at w w w.philips.com/
suppor t. 
If the problem remains unresolved, contact 
Philips Consumer Care in your countr y as listed 
in the warranty leaflet.
Warning
Do not at tempt to repair the product yourself.  •This may cause severe injur y, irreparable damage to your product or void your warranty.
Note
Make a note of your T V model and serial  •number before you contact Philips. These numbers are printed on the back of the T V and on the packaging.
 
						

							44EN
F
factory settings 20
H
HDMI
HDMI-CEC in 31
Troubleshooting 43
Hospitality 28
I
Installation
Automatic 21
Manual 22
K
Kensington lock 40
L
Language
Audio language 13
menu language 21
subtitle language 16
Troubleshooting 42
Lock
Kensing ton lock 40
Local KB lock 30
Low power standby 29
M
MENU
Main menu 10
Troubleshooting 42
Monitor out 31
Multimedia
Technical specifications 41
USB 17
Multi remote control 33
Music 18
O
One-touch play 40
One-touch standby 40
Index
A
ALARM 7, 32
Application
Hospitality 28
Signage 28
B
Batteries 41
C
Channel list
install
Automatic 21
Manual 22
PayT V ring 33
Test digital reception 23
Troubleshooting 42
Update 22
clock 16
setup 31
Computer
Connect 38
display resolutions 41
Troubleshooting 43
D
DEMO 20
Digital channels
CAM 39
Test digital reception 23
Display resolutions 41
E
EasyLink
disable 40
Enable 40
one-touch play 40
one-touch standby 40
EPG 14
Professional mode EPG 31
 
						

							45
English
EN
P
Photo
Slide show 17
USB 17
Picture format 12
Picture settings 10
POWER 8
Low power standby 29
Power on 29
Smar t power 29
Technical specifications 41
Professional mode
Activat 25
Options 26
PBS mode 28
Settings 28
R
Remote control
Professional Setup Remote control 24
RC lock 30
Technical specifications 41
Troubleshooting 42
S
Signage 28
Smart card 39
Smart settings 12
Software version 18
Sound settings 12
Subtitles
On analogue channels 15
On digital channels 16
Professional mode subtitle 31
T
Technical	specifications	41
Teletext 9, 13
Troubleshooting 42
TV overview 6
U
USB
Listen to music 18
USB break-in 31
View photos 17
V
Video formats 41
Volum 9
Volume 7
W
Wall mounts 41
Welcome message 30
 
						

							© 2009 Koninklijke Philips Electronics N.V.
All rights reserved.