Philips 220x1sw User Manual

2T
	SFRVFOUMZ
TLFE
2VFTUJPOT



A:
 Because you activate Theft Deterrence function in SmartControl II. Plea\
se contact

IT manager or Philips Service Center.


More information is provided in the Regulatory Information section.
RETURN TO TOP OF THE PAGE


 

 


GJMF%]-$%.POJUPS0&.1IJMJQT.QSPKFDU99&%67POMJOFXBSSBOUZ:4PVSDF&/(-*4)9TBGFUZTBG@GBRIUN 

5SPVCMFTIPPUJOH






 

 





•  Safety and 
Troubleshooting

• FAQs

• Common Problems

• Imaging Problems



•  Regulatory Information

• Other Related Information




 


 


 

Troubleshooting

This page deals with problems that can be corrected by a user. If the pr\
oblem still persists after you have tried these 
solutions, contact Philips customer service representative. 
Common Problems 
Having this problem Check these items
No Picture
(Power LED not lit)

µ




Make sure the power cord is...

5SPVCMFTIPPUJOH


Display position is incorrect
µ




Press the Auto button. 
µ




Adjust the image position using the Phase/Clock of Setup in 
OSD Main Controls.


Image vibrates on the screen
µ




Check that the signal cable is properly connected to the 
graphics board or PC.


Vertical flicker appears
µ




Press the Auto button.

µ




Eliminate the vertical bars using the Phase/Clock of Setup in 
OSD Main Controls.


Horizontal flicker appears
µ




Press the Auto button. 
µ




Eliminate the...

5SPVCMFTIPPUJOH
Green, red, blue, dark, and white dots 
remainsµ




The remaining dots are normal characteristic of the liquid 
crystal used in today’s technology.


Adjust blue power on light
µ




Adjust blue power on light using the power LED of Setup in 
OSD Main Controls.


For further assistance, refer to the Consumer Information Centers list and contact Philips customer service 
representative.


RETURN TO TOP OF THE PAGE



 
 

 

...

3FHVMBUPSZ
*OGPSNBUJPO


 



 

 






•
Recycling Information for Customers

•Waste Electrical and Electronic 
Equipment-WEEE

•
CE Declaration of Conformity

•Energy Star Declaration


•Federal Communications 
Commission (FCC) Notice (U.S. 
Only)

•
FCC Declaration of Conformity

•Commission Federale de la 
Communication (FCC Declaration)

•EN 55022 Compliance (Czech 
Republic Only)

•Polish Center for Testing and 
Certification Notice

•North Europe (Nordic Countries) 
Information

•BSMI Notice...

3FHVMBUPSZ
*OGPSNBUJPO
This product is in conformity with the following standards  
- EN60950-1:2001 (Safety requirement of Information Technology Equipmen\
t)  
- EN55022:2006 (Radio Disturbance requirement of Information Technology\
 Equipment)  
- EN55024:1998 (Immunity requirement of Information Technology Equipmen\
t)  
- EN61000-3-2:2006 (Limits for Harmonic Current Emission)  
- EN61000-3-3:1995 (Limitation of Voltage Fluctuation and Flicker) 
following provisions of directives applicable 
-...

3FHVMBUPSZ
*OGPSNBUJPO
This equipment has been tested and found to comply with the limits for a\
 Class B digital 
device, pursuant to Part 15 of the FCC Rules. These limits are designed \
to provide 
reasonable protection against harmful interference in a residential inst\
allation. This 
equipment generates, uses and can radiate radio frequency energy and, if\
 not installed and 
used in accordance with the instructions, may cause harmful interference\
 to radio 
communications. However, there is no...

3FHVMBUPSZ
*OGPSNBUJPO
Commission Federale de la Communication (FCC Declaration)
Cet équipement a été testé et déclaré conforme auxlimi\
tes des appareils numériques de 
class B,aux termes de larticle 15 Des règles de la FCC. Ces limites \
sont conçues de façon 
à fourir une protection raisonnable contre les interférences nuisi\
bles dans le cadre dune 
installation résidentielle. CET appareil produit, utilise et peut é\
mettre des hyperfréquences 
qui, si lappareil nest pas installé et utilisé selon les...

3FHVMBUPSZ
*OGPSNBUJPO


To completely switch off the equipment, the power supply cable must be r\
emoved from the power supply 
socket, which should be located near the equipment and easily accessible\
.
A protection mark B confirms that the equipment is in compliance with \
the protection usage 
requirements of standards PN-93/T-42107 and PN-89/E-06251.
RETURN TO TOP OF THE PAGE
North Europe (Nordic Countries) InformationPlacering/Ventilation 
VARNING: 
FÖRSÄKRA DIG OM ATT HUVUDBRYTARE OCH UTTAG ÄR...

3FHVMBUPSZ
*OGPSNBUJPO
Paikka/Ilmankierto 
VAROITUS: 
SIJOITA LAITE SITEN, ETTÄ VERKKOJOHTO VOIDAAN TARVITTAESSA HELPOSTI 
IRROTTAA PISTORASIASTA. 


Plassering/Ventilasjon 
ADVARSEL: 
NÅR DETTE UTSTYRET PLASSERES, MÅ DU PASSE PÅ AT KONTAKTENE FOR \
STØMTILFØRSEL ER LETTE Å NÅ. 
RETURN TO TOP OF THE PAGE
BSMI Notice (Taiwan Only)


RETURN TO TOP OF THE PAGE
Ergonomie Hinweis (nur Deutschland)
Der von uns gelieferte Farbmonitor entspricht den in der Verordnung ü\
ber den Schutz vor Schäden 
durch...