Panasonic Wv Q151c Operating Instructions Manual

Before attempting to connect or operate this product,
please read these instructions carefully and save this manual for future use.
No model number suffix is shown in this manual.
Ceiling Mount Bracket
Operating Instructions
Model Nos.WV-Q151C/WV-Q151S 

3
• Select an installation area that can support the total weight.
If a selected area is too weak to support the total weight, a fall of the product may occur
resulting in injury. Installation work shall be started after sufficient reinforcement.
• Periodic inspections shall be conducted.
Rust on the metal parts or screws may cause a fall of the product resulting in injury. Consult
the dealer for the inspections.
• Do not rub the edges of metal parts with your hand.
Failure to observe this may cause...

5
4
Installations
Be sure to read Precautions on the page xx before installation. The Installation Guide of the
network camera, WV-NS202, shall be read as well.
1. Remove the decorative cover.
qLoosen the fixing screw (unremov-
able) to be used for cover fall pre-
vention.
wUnhook the decorative cover from
the hooks (3 positions) of the cam-
era mounting plate and remove the
decorative cover by turning it coun-
terclockwise.
eTake the inner shell out.
2. Remove the camera mounting plate.
Remove the...

7 6
5. Mount the safety wire angle (accessory) on the 2nd anchor bolt and connect the safe-
ty wire (accessory) to the angle.
qDisconnect the safety wire from the
safety wire angle.
wEngage the face marked qwith the
anchor bolt.
eBend the face marked w.
rConnect the safety wire to the safety
wire angle again.
Note:To use the anchor bolt that was already installed, the use of 2 spacer nuts is helpful.
6. Connect the mounting base to the tip
of the safety wire.
Spacer nuts
Safety wire
Spacer nuts
Safety...

9 8
10. Install the inner shell.
Slide the covers located on the both lat-
eral sides of the camera and put the
inner shell on the camera until the hooks
inside the inner shell are held in the
holes of the camera (until a click is
heard).
Important:Put the inner shell down on
the camera until the outside cover of
the camera cannot be seen from the
opening (from which the camera
lens is visible) of the inner shell. If
this integration is not successfully
performed, the inner shell may be
removed or the...

11
10
FRONT
LOCK
F
R
O
N
T
FRONT
LOCK
F
R
O
N
T
Projections Hooks for the
decorative cover
*1 position on the
rear side
START
END
FRONT
FRONT
LOCK
Mounting base
Camera mounting plate
Align Awith A
Align Bwith B
Fixing screw to be used for cover fall prevention
14. Mount the camera mounting plate on
the mounting base.
qAlign the marks (Ato Aand Bto
B) between the camera mounting
plate and mounting base.
wMount the camera mounting plate on
the mounting base with aligning gof
the camera mounting plate with...

Specifications
Ambient temperature: –10 °C- + 50 °C {14 °F - 122 °F}
Dimensions: 185 mm {7-5/16} in diameter x 145 mm {6-7/16} in height 
Weight: Approx. 800 g{1.77 lbs.}
Finish:  Main body: Treatment steel
Decorative cover: ABS resin with silver metallic coating
Dome cover: Acrylic resin
Standard Accessories
Operating Instructions (this book)  ............................. 1 pc.
The following are for installation
Safety wire  ................................................................. 1 pc.
Safety...