Home > Panasonic > Camera Accessories > Panasonic Wv Q116 2 Instructions Manual

Panasonic Wv Q116 2 Instructions Manual

Add to Favourites
    Download as PDF

    View the Panasonic Wv Q116 2 Instructions Manual for free. All the Panasonic manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 PREFACE The Panasonic Ceiling Mount Bracket WV-Q116 is provided for the surface mounting of the Combination Camera WV-CS954 on a suspended (double) ceiling. Instructions Model No.WV-Q116 Ceiling Mount Bracket Before attempting to connect or operate this product, please read these instructions completely. PRECAUTIONS •Before installing the camera, make sure that the location where the camera is going to be installed is strong enough to support the entire weight of the camera (approximately 2.9 kg {6.38...
    Page 2 2. Drive a standard anchor bolt (#1 in illustration) into the upper concrete ceiling in the center of the hole made in the suspended ceiling as described in step 1. Drive another anchor bolt (#2 in illustration) into position (2) as shown in the following illus- tration. 3. Attach one standard anchor nut at point “D”, measured by using Template B (provided). Measure length “E” by using Template B. - 2 - 1. Use Template A (provided) to make four holes in the suspended ceiling. 1-1. Make four holes (φ12...
    Page 3 Two spacer nuts are needed to use the exist- ing anchor bolt instead. 5. Attach the end of the Fall Prevention Wire to the bracket. 5-1. Put a standard anchor nut onto anchor bolt (2). 5-2. Remove the Fall Prevention Wire from the Fall Prevention Angle Clip. 5-3. Insert the anchor bolt (2) through side “1”. 5-4. Fold (manually bend the clip) side “2” down onto side “1” (when fold- ed properly side “1” and side “2” should match).5-5. Reattach the Fall Prevention Wire to the matched holes of side “1” and...
    Page 4 9. Remove the plate from the camera mounting base (combination camera accessory). 10. Attach the camera mounting base to the bracket. Adjust the lock plate so it is in the orientation show in the following illustration, and then tighten the four M4-L 8 Screws (provided). 11. Connect the fall prevention wire to the camera mounting base. Note:Tug on the Fall Prevention Wire to make sure it is secure. 12. Install the camera to the camera mount- ing base. *The top case is not shown in the fol- lowing...
    Start reading Panasonic Wv Q116 2 Instructions Manual

    Related Manuals for Panasonic Wv Q116 2 Instructions Manual

    All Panasonic manuals