Home
>
Panasonic
>
Car Satellite Radio System
>
Panasonic Wma Mp3 Cd Player Receiver Cq C5303 Operating Instructions
Panasonic Wma Mp3 Cd Player Receiver Cq C5303 Operating Instructions
Here you can view all the pages of manual Panasonic Wma Mp3 Cd Player Receiver Cq C5303 Operating Instructions . The Panasonic manuals for Car Satellite Radio System are available online for free. You can easily download all the documents as PDF.
Page 1
WMA MP3 CD Player/Receiver Model:CQ-C5303N Operating Instructions Bedienungsanleitung Manuel d Manuel d’instructions Gebruiksaanwijzing Bruksanvisning Manuale di istruzioni Manuale di istruzioni Manual de Instrucciones Brugsvejledning Instrukcja obs¬ugi Návod k obsluze Használati utasítások Operating Instructions Bedienungsanleitung Manuel d’instructions Gebruiksaanwijzing Bruksanvisning Manuale di istruzioni Manual de Instrucciones Brugsvejledning Instrukcja obs¬ugi Návod k obsluze Használati...
Page 2
2 1 E N G L I S H CQ-C5303N Safety Information Warning Observe the following warnings when using this unit. ❑ The driver should neither watch the display nor operate the system while driving. Watching the display or operating the system will distract the driver from looking ahead of the vehicle and can cause accidents. Always stop the vehicle in a safe location and use the parking brake before watching the display or operating the system. ❑ Use the proper power supply. This product is designed for...
Page 3
3 2 E N G L I S H CQ-C5303N Caution Observe the following cautions when using this unit. ❑ Keep the sound volume at an appropriate level. Keep the volume level low enough to be aware of road and traffic conditions while driving. ❑ Do not insert or allow your hand or fingers to be caught in the unit. To prevent injury, do not get your hand or fingers caught in moving parts or in the disc slot. Especially watch out for infants. ❑ This unit is designed for use exclusively in automo- biles. ❑ Do not operate...
Page 4
4 3 E N G L I S H CQ-C5303N Safety Information (continued) Label Indications and Their Locations CAUTION LASER RADIATION WHEN OPEN. DO NOT STARE INTO BEAM. Caution:This product utilizes a laser. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation expo- sure. Do not take apart this unit or attempt to make any changes yourself. This unit is a very intricate device that uses a laser pickup to retrieve information from the surface...
Page 5
5 4 E N G L I S H CQ-C5303N Panasonic welcomes you to our constantly growing family of electronic products owners. We endeavor to give you the advantages of precise electronic and mechanical engineering, manufactured with carefully selected components, and assembled by people who are proud of the reputation their work has built for our company. We know this product will bring you many hours of enjoyment, and after you discover the quality, value and reliability we have built into it, you too will be...
Page 6
6 5 E N G L I S H CQ-C5303N PAN EUROPEAN GUARANTEE (Warranty Card) Qty: 1 Power Connector (YEAJ02874) Qty: 1 Mounting Collar (YEFX0217263) Qty: 1 Installation Instructions (YEFM294106) (YEFM294107) (YEFM294108) Qty: 1 set XXXXXXXXXXXXXXX XXXXXXXXXXXXXXXXX XXXXXXXXXXXXXX XXXXXXXXXXXXXXXXOO-OOOOO Operating Instructions (YEFM285753) Qty: 1 XXXXXXXXXXXXXXX XXXXXXXXXXXXXXXXX XXXXXXXXXXXXXX XXXXXXXXXXXXXXXXOO-OOOOO System Upgrade Guidebook (YEFM262693) Qty: 1 Note: ¡The number in parentheses underneath...
Page 7
![Page 7
7
1
E
N
G
L
I
S
H
CQ-C5303N
6
Preparation
The demonstration message appears for initial
use.
qSet your car’s ignition switch to the ACC or ON position.
wPress [SRC/PWR].
The demonstration screen appears.
ePress and hold [VOLUME] (PUSH SEL) for more
than 2 seconds to open the menu.
rPress [VOLUME] (PUSH SEL) to select the
Demonstration setting. (“DEMO” is displayed)
tTurn [VOLUME] counterclockwise. (Press [0] ({)on
the remote control unit.)
a
Note:
¡To return to the regular mode, press [D] (DISP).
¡Refer...](http://img.usermanuals.tech/thumb/58/65697/w300_cq-c5303_en_om_d-6.png "Page 7
7
1
E
N
G
L
I
S
H
CQ-C5303N
6
Preparation
The demonstration message appears for initial
use.
qSet your car’s ignition switch to the ACC or ON position.
wPress [SRC/PWR].
The demonstration screen appears.
ePress and hold [VOLUME] (PUSH SEL) for more
than 2 seconds to open the menu.
rPress [VOLUME] (PUSH SEL) to select the
Demonstration setting. (“DEMO” is displayed)
tTurn [VOLUME] counterclockwise. (Press [0] ({)on
the remote control unit.)
a
Note:
¡To return to the regular mode, press [D] (DISP).
¡Refer...")
7
1
E
N
G
L
I
S
H
CQ-C5303N
6
Preparation
The demonstration message appears for initial
use.
qSet your car’s ignition switch to the ACC or ON position.
wPress [SRC/PWR].
The demonstration screen appears.
ePress and hold [VOLUME] (PUSH SEL) for more
than 2 seconds to open the menu.
rPress [VOLUME] (PUSH SEL) to select the
Demonstration setting. (“DEMO” is displayed)
tTurn [VOLUME] counterclockwise. (Press [0] ({)on
the remote control unit.)
a
Note:
¡To return to the regular mode, press [D] (DISP).
¡Refer...
Page 8
![Page 8
Power
Set your cars ignition switch to the ACC or ON position.
ON:Press [SRC/PWR].
OFF:Press and hold [SRC/PWR] until you hear
a beep (approximately 1 second), then
release it.
Note:
¡When the ignition switch is set to ON, the face plate is
tilted to secure their former positions.
¡If the security function is set to ON, the security mes-
sage is shown with a warning alarm. (Default: SLED
ON) (aPage 34 about Security Function setting)
Volume
Note:
¡The volume level can be set independently for each...](http://img.usermanuals.tech/thumb/58/65697/w300_cq-c5303_en_om_d-7.png "Page 8
Power
Set your cars ignition switch to the ACC or ON position.
ON:Press [SRC/PWR].
OFF:Press and hold [SRC/PWR] until you hear
a beep (approximately 1 second), then
release it.
Note:
¡When the ignition switch is set to ON, the face plate is
tilted to secure their former positions.
¡If the security function is set to ON, the security mes-
sage is shown with a warning alarm. (Default: SLED
ON) (aPage 34 about Security Function setting)
Volume
Note:
¡The volume level can be set independently for each...")
Power Set your cars ignition switch to the ACC or ON position. ON:Press [SRC/PWR]. OFF:Press and hold [SRC/PWR] until you hear a beep (approximately 1 second), then release it. Note: ¡When the ignition switch is set to ON, the face plate is tilted to secure their former positions. ¡If the security function is set to ON, the security mes- sage is shown with a warning alarm. (Default: SLED ON) (aPage 34 about Security Function setting) Volume Note: ¡The volume level can be set independently for each...
Page 9
![Page 9
(when connected)
(when connected)
(when connected)
(when connected)
9
1
E
N
G
L
I
S
H
CQ-C5303N
8
Source
Press [SRC/PWR]
to change the source.
Radio
CD Player
MP3/WMA Player
AUX1
An optional unit (ex. CD changer)
(if you connect it to System-up Connector of this unit
directly)
Some optional units
(if you use the Expansion Module (CY-EM100N))
Note:
¡For information about connectable devices, refer to
the System Upgrade Guidebookor the instruction
manual for each device.
SQ (Sound Quality)
You have 6...](http://img.usermanuals.tech/thumb/58/65697/w300_cq-c5303_en_om_d-8.png "Page 9
(when connected)
(when connected)
(when connected)
(when connected)
9
1
E
N
G
L
I
S
H
CQ-C5303N
8
Source
Press [SRC/PWR]
to change the source.
Radio
CD Player
MP3/WMA Player
AUX1
An optional unit (ex. CD changer)
(if you connect it to System-up Connector of this unit
directly)
Some optional units
(if you use the Expansion Module (CY-EM100N))
Note:
¡For information about connectable devices, refer to
the System Upgrade Guidebookor the instruction
manual for each device.
SQ (Sound Quality)
You have 6...")
(when connected) (when connected) (when connected) (when connected) 9 1 E N G L I S H CQ-C5303N 8 Source Press [SRC/PWR] to change the source. Radio CD Player MP3/WMA Player AUX1 An optional unit (ex. CD changer) (if you connect it to System-up Connector of this unit directly) Some optional units (if you use the Expansion Module (CY-EM100N)) Note: ¡For information about connectable devices, refer to the System Upgrade Guidebookor the instruction manual for each device. SQ (Sound Quality) You have 6...
Page 10
![Page 10
10
9
E
N
G
L
I
S
H
CQ-C5303N
General (continued)
Open the Face Plate
Press [u] (OPEN).
Note:
¡The face plate automatically closes after a warning alarm
sounds if no operation is performed for approximately
20 seconds.
¡When a disc is already loaded, the disc will be ejected
after the face plate fully opens.
(Disc Eject aPage 20)
Close the Face Plate
Press [u] (OPEN).
Face Plate Angle (Tilt)
Press and hold[u] (TILT)until you hear a beep (approxi-
mately 1 second) from the speaker output, then release it....](http://img.usermanuals.tech/thumb/58/65697/w300_cq-c5303_en_om_d-9.png "Page 10
10
9
E
N
G
L
I
S
H
CQ-C5303N
General (continued)
Open the Face Plate
Press [u] (OPEN).
Note:
¡The face plate automatically closes after a warning alarm
sounds if no operation is performed for approximately
20 seconds.
¡When a disc is already loaded, the disc will be ejected
after the face plate fully opens.
(Disc Eject aPage 20)
Close the Face Plate
Press [u] (OPEN).
Face Plate Angle (Tilt)
Press and hold[u] (TILT)until you hear a beep (approxi-
mately 1 second) from the speaker output, then release it....")
10 9 E N G L I S H CQ-C5303N General (continued) Open the Face Plate Press [u] (OPEN). Note: ¡The face plate automatically closes after a warning alarm sounds if no operation is performed for approximately 20 seconds. ¡When a disc is already loaded, the disc will be ejected after the face plate fully opens. (Disc Eject aPage 20) Close the Face Plate Press [u] (OPEN). Face Plate Angle (Tilt) Press and hold[u] (TILT)until you hear a beep (approxi- mately 1 second) from the speaker output, then release it....