Panasonic Ventilation Fv 05vf1 Installation Instructions

READ AND SAVE THESE INSTRUCTIOINS.
Please
readthese
instructionscarefullybeforeattempting
toinstall,
operate or service the Panasonic Ventilating Fan. Failure to comply
with instructions could result in personal injury and/or property
damage. Please retain this booklet for future reference.
Applicable to Models: FV-05VF1, FV-07VF1, FV-09VF1, FV-11VF1
SUPPLEMENTARY
INSTALLATION INSTRUCTIONS
(For Contractor Pack)
Housing Can
FV-05-11VFAMotor/Grille Assembly
FV-05VFB, FV-07VFB, FV-09VFB, FV-11VFB
Table of...

GENERAL SAFETY INFORMATION
CAUTION:
1. For general ventilating use only. Do not use to exhaust
hazardous or explosive materials and vapors.
2. Not for use in cooking area. (Fig .B)
3. This product must be properly grounded.Floor
Do not install above or(Cooking area)
inside this area
45o45o
equipmentCooking
Fig. B
2
WARNING:
To reduce the risk of fire, electric shock or injury to persons, observe the following:
A. Use this unit only in the manner intended by the manufacturer. If you have any questions,...

UNPACKING
Unpack and carefully remove unit from carton.
Refer to the following Supplied Accessories list to verify that all parts are present.
SUPPLIED ACCESSORIES SETS(4 )SUPPLIED ACCESSORIES SETS(4 )
(A) For Motor/Grille Assembly of model: FV-05/07/09/11VFB
Quantity Appearance Part name
Grille4
3
(B) For Housing Can of model: FV-05-11VFA
Part nameAppearance
Quantity
Long screw
(ST4.2X20)
Thumb screw
Suspension
bracketI
Suspension
bracketII
Screw
(ST4.2X6)
Suspension
bracketIII
Clamp
Plate
3 inch...

Adaptor flange
Long screw
B
Suspension
bracketICeiling joist
Adaptor
Ceiling joist
3. Remove junction box cover and secure conduit to junction box knock-out hole.
(Fig. 3). Using wire nuts,connect house power wires to ventilating fan wires:
black to black; white to white; green to green. Replace the junction box cover.
1. Remove the tape from damper and adaptor before installation. (Fig. 1)
2. Remove adaptor from body and secure adaptor to ceiling joists using
long screws. (Fig. 2) Keep the distance B...

Fig. 6
Fig. 7
Fig. 5
5
4. Install a circular duct (using 4 inches duct or 3 inches duct) and secure it with
duct tape or clamp as shown in Fig. 4.
5. Insert fan body into ceiling. (Fig. 5)
6. Secure the fan body to the adaptor by using one thumb screw as shown in Fig. 6.
7. Secure fan body to ceiling joists using 4 long screws (ST4.2X20) in horizontal
direction with suspension bracket and . Secure suspension bracket andII III II III
to the fan body using 2 screws (ST4.2X6). (Fig. 7)
8. Follow steps 11 to...

Fig. 10
Fig. 9
260 (
10 1 /4)
260 (
10 1 /4)
1. Remove the tape from damper and adaptor before installation. (Fig. 1)
2. Secure the fan body to the adaptor by using one thumb screw as shown in Fig. 6
3. Install header between ceiling joists using nails or screws. Then install the fan body
and secure with screws. (Fig. 8).
4. Remove junction box cover and secure conduit to junction box knock-out hole. (Fig. 3)
Using wire nuts,connect house power wires to ventilating fan wires: black to black; white
to...

Fig. 11
2-square knock-outHand driver
Fan body
6. Remove the 2 square knock-out carefully from surface of the frame
by screw driver. (Fig. 11). And remove the bracket cover on the other
side of the frame body.
7. Insert fan body into ceiling. (Fig. 5)
8. Secure the fan body to the adaptor by using one thumb screw as
shown in Fig. 6.
9. Replace with clamp plates(accessories) and secure the fan body
on ceiling board with 2 screws (ST4.2X6) from inside of the frame.
(Fig. 12)
10. Follow steps 11 to 15 of...

X0806-4047 07VFA4020D
PANASONIC CONSUMER ELECTRONICS COMPANY
Division of Panasonic Corporation of North America,
PANASONIC CANADA INC.
5770 Ambler Driver, Mississauga, ON L4W 2T3
www.panasonic.com One Panasonic Way, Secaucus, NJ 07094