Panasonic Remote Control Cz Rwsk1 Control Functions Information Manual

							Setting Up Remote Control Functions (CZ-RWSK1U)
The functions of the wireless remote can be set on site.
(These settings are saved in nonvolatile memory in the remote controller, so even when its batteries are 
changed, the settings do not revert to the defaults.)
   The operation of the air conditioner can be impacted, depending on the settings made, so only 
service personnel should make the settings.
  Furthermore, making changes to these settings may cause actual operation to deviate from what 
is printed in the Operating Instructions, so be sure to explain this to the customer fully.
Making Settings (Do with unit stopped.)
1.  Holding down the Swing/Wind Direction + OFF Timer  + Mode Select buttons at the same time for 4 or more 
seconds makes the display switch to the setting screen. (See Diagram Below.) 
2.  Use the Temperature setting buttons, 
/, to select the number of the item to be set.
3.  Use the ON Timer buttons, 
/, to change settings.
4.  The settings are saved with the Once/Every Day button. When this is done, the settings display of the LCD 
changes from blinking to light.
5.  If other settings are to be changed as well, repeat steps 2 to 4.
6.  When all settings have been made, press the Start/Stop button.
Example: Operation mode setting screen
Note 1  While the unit is in the swinging mode (Swing/Wind Direction), the fl ap cannot be stopped in a desired position.
Note 2  When Setting OFF is selected, “°C” is displayed on the LCD screen.
Note 3  You can toggle between ON and OFF by pressing Ventilation for 4 seconds or more.
Note 4  If the Heater Max ON/OFF setting is not changed to EP (ON), the setting change will not be refl ected.
Note 5  This is the number of addresses that can be set in the address change mode. Do not set it to 07 or above.
Item Number & Setting Item Setting ContentSetting when 
Shipped
1
Operation Mode       
   
2
Flap Display      (No Display) 
(Note 1)
3
Select Fan Speed      (No Display) 
4
Display of Set 
Temperature °F  Setting Off (Note 2)  °C °F
5
Time Display AM/PM 
 24 Hour (No Display) AM/PM
6
Ventilation Fan ON/OFF Off (No Display) 
 On OFF (Note 3)
7
Cool temp Max 41 – 95°F 86°F
8
Cool temp Min 41 – 95°F 64°F
9
Heat temp Max 41 – 95°F 78°F (Note 4)
10
Heat temp Min 41 – 95°F 60°F
11
Dry temp Max 41 – 95°F 86°F
12
Dry temp Min 41 – 95°F 64°F
13
Auto temp Max 41 – 95°F 80°F
14
Auto temp Min 41 – 95°F 62°F
16
Address Setting Max 
Value00 (ALL only) 
 01 – 31 06 (Note 5)
17
Heat temp Max ON/OFF JP (Heater Max Temp Change Off)  
  EP (On)JP
1 4 326
Item 
Number
85464159511010 Printed in Japan
1BOBTPOJD@./6-@JOEE


1BOBTPOJD@./6-@JOEE