Panasonic LCD Projector PT-LC50U Operating Instructions

							71Previous 
screen
Note
If using a signal source with poor picture quality, such as a 
dubbed tape, it may not be possible to get the picture to display
properly.
If the correct signal format is not selected and the picture
does not appear normal when VIDEO or S-VIDEO signal is
being input, select the format by the following procedure. This
function is set to 
“AUTO ” at the time of shipment from the
factory, so that the projector can normally be used with this
setting.
•  Setting procedure
1Press MENU  to
display the menu.
3Press  or   to
switch the setting to 
“ AU TO ”,   “NTSC ”,
“ NTSC4.43 ”,  “PA L ”,
“ PAL-M ”,  “PAL-N ” or
“ SECAM ” until a
normal picture is
obtained.
S-VIDEO/VIDEO Signal Format Selection
Picture 
White Balance
Video System
Function
Language
Information
AUTO 
NTSC
NTSC4.43
PA L
PAL-M
PAL-N
SECAM
Video System
2Press  or   to
select  “Video
System ”,  and then
ENTER  to display the
screen. 
						

							72Previous 
screen
The LCD Projector is equipped with an internal Blue (Black) 
Screen function which turns the screen blue black when the
video or personal computer equipment connected to the
input jack is turned off, or when there is nothing connected
to the input jack.
•If the power is turned on when no 
input signal is input to the LCD
Projector, the screen will turn blue.
The Focus screen appears only
until the video or personal
computer equipment is connected
to the input jack and turned on.
• If an unrecognizable signal is
input, the screen goes black and
“Signal ” is displayed.
• When RGB signal is input, please
input the registered signals found on
“Signals that can be Input ”.
•
During operation, if the input
signal is terminated, the screen
goes black and  “No Signal ” will
be displayed.
Blue (Black) Screen with No Input Signal
Signal
No Signal 
						

							73Previous 
screen
Optional Accessories
For ordering instructions, see the accessory order form page.(1) Full Functional Remote Control Unit (ET -RMLC50)
(2) Replacement Lamp (ET-LAC50) 
(3) D-sub15-BNC5 Adapter Cable (ET-ADBNC)
When the  full functional remote control unit is  used, you can
operate the wireless mouse and laser pointer features.
Note