Panasonic LCD Projector PT-AE300U PT-AE200U Operating Instructions
Have a look at the manual Panasonic LCD Projector PT-AE300U PT-AE200U Operating Instructions online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 10737 Panasonic manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
60-E NGLISH ENGLISH -61 Others AppendixList of compatible signals*1 The “i” appearing after the resolution indicates an interlaced signal. *2 The following symbols are used to indicate picture quality. AA Maximum picture quality can be obtained. A Signals are converted by the image processing circuit before picture is projected B Some loss of data occurs to make projection easier. 720 x 480i 15.734 59.940 A A Video/S-Video720 x 576i 15.625 50.000 AA A Video/S-Video720 x 480i 15.734 59.940 13.500 A A YP BPR 720 x 576i 15.625 50.000 13.500 AA A YP BPR 720 x 483 31.469 59.940 27.000 A A YP BPR 1 920 x 1 080i 33.750 60.000 74.250 AA A YP BPR/PC 1 920 x 1 080i 28.125 50.000 74.250 AA A YP BPR/PC 1 280 x 720 45.000 60.000 74.250 A A YP BPR 640 x 400 31.469 70.086 25.175 A A PC640 x 400 37.861 85.081 31.500 A A PC640 x 480 31.469 59.940 25.175 A AA PC/DV1640 x 480 35.000 66.667 30.240 A AA PC640 x 480 37.861 72.809 31.500 A AA PC640 x 480 37.500 75.000 31.500 A AA PC640 x 480 43.269 85.008 36.000 A AA PC720 x 400 37.927 85.038 35.500 A A PC856 x 480 30.057 60.114 31.500 A AA PC/DV1800 x 600 35.156 56.250 36.000 A A PC800 x 600 37.879 60.317 40.000 A A PC/DV1800 x 600 48.077 72.188 50.000 A A PC800 x 600 46.875 75.000 49.500 A A PC800 x 600 53.674 85.061 56.250 A A PC832 x 624 49.725 74.550 57.283 A A PC1 072 x 600 37.287 59.947 51.382 A A PC/DV11 280 x 720 45.106 60.141 76.500 A A PC1 024 x 768 48.363 60.004 65.000 A A PC/DV11 024 x 768 56.476 70.069 75.000 A A PC1 024 x 768 60.023 75.029 78.750 A A PC1 024 x 768 68.678 84.997 94.500 A A PC1 024 x 768i 35.520 86.952 44.897 A A PC1 280 x 768 45.327 56.518 76.150 A A PC/DV11 152 x 864 63.995 71.184 94.200 A A PC1 152 x 864 67.500 74.917 108.000 B B PC 1 152 x 870 68.681 75.062 100.000 B B PCDisplay resolution (dots)* 1 Scanning frequency H (kHz)V (Hz) Dot clock frequency (MHz) Picture quality* 2 AE300 AE200 NTSC/M-NTSC/PAL-M/PAL60PAL/PAL-N/SECAM 525i625i525pHDTV60HDTV50750P VGA400VGA480WIDE400WIDE480 SVGAMAC16WIDE600WIDE720 XGAWIDE768 MXGAMAC21 Format Mode plus/minus polarity compatible COMPONENT IN: Y: 1.0 V [p-p], 75 Ω P B,PR(C B,CR): 0.7 V [p-p], 75 Ω DVI-D IN (PT-AE300U only): Single-line, DVI-D, 24-pin AUDIO IN: Single-line 0.5 V [rms], RCA pin jack x2 (L-R) SD memory card slot: For SD memory cards Compatible with DCF-standard still image data Compatible with MPEG4 moving picture data (audio: G.726 compliant) Cabinet: Moulded plastic (ABS/PC) Dimensions: Width: 280 mm (11˝) Height: 85.2 mm (3-11/32˝) Length: PT-AE300U 279.7 mm (11˝) (including lens) PT-AE200U 278.5 mm (10-15/16˝) (including lens) Weight: 2.9 kg(6.4 lbs.) Operating environment: Temperature: 0 °C–40 °C (32 °F–104 °F) [When the FAN CONTROL is set to “HIGH” (page 40); 0 °C–35 °C (32 °F–95 °F)] Humidity: 20%–80% (no condensation) Certifications: UL1950, C-UL FCC Power supply: 3 V DC (AAA battery x2) Operating range: Approx. 7 m (23´) (when operated directly in front of signal receptor) Weight: 73.5 g(2.6 ozs.) (including battery) Dimensions: Width: 43 mm (1-11/16˝) Height: 22.3 mm (7/8˝) Length: 135 mm (5-5/16˝) Ceiling bracket ET-PKE300 Projection Screen ET-SR90CT(width: 1 800 mm(70)) ET-SR70CT(width: 1 400 mm(55)) *Specifications are subject to change without notice.
62-E NGLISH ENGLISH -63 Others Pin No. Signal #Earth (Luminance signal) Earth (Color signal) Luminance signal Color signal $ % & BThe pin layout and signal names for the RGB input connector are shown below. Pin No. Signal #R G/G·SYNC B SDA $ % . /HD/SYNC 0VD 1SCL Pin +is spare. Pins &–*, ,and -are for earth. Pins .and 1functions are only valid when supported by the computer #$ % &External view -1 #', ( External view Connector pin wiringBThe pin layout and signal names for the S2 VIDEO input connector are shown below.BThe pin assignments on the DVI-D input connector are as follows (interface with TMDS connector on a personal computer) View from mating side Pin No. Signal Pin No. Signal #T.M.D.S data 2- /T.M.D.S data 3+ $T T.M.D.S data 2+ 0+5 V %T.M.D.S data 2/4 shield 1Ground &T.M.D.S data 4- 2Hot plug sense 'T.M.D.S data 4+ 3T.M.D.S data 0- (DDC clock 4T.M.D.S data 0+ )DDC data * - 6T.M.D.S data 5- +T.M.D.S data 1- 7T.M.D.S data 5+ ,T.M.D.S data 1+ 8T.M.D.S clock shield -T.M.D.S data1/3 shield .T.M.D.S data 3- :T.M.D.S clock- 5T.M.D.S data 0/5 shield 9T.M.D.S clock+ # *3 : 2+
64-E NGLISH ENGLISH -65 Others DCF standardThis projector can only play back image files which comply with the DCF specification. The DCF specification imposes the following conditions. Image files or folders which do not conform to these conditions cannot be recognised by the projector.Limits on folder names Folders must be created as sub-folders of the DCIM folder on the SD memory card. BData which is contained within any folder other than the DCIM folder cannot be recognised. Folder names must consist of three numerals (folder number) followed by five alphanumeric characters. (Example: 100abcde) BThe three numerals must make up a number between 100 and 999, and the alphanumeric characters can be taken from the following set of 37 characters: 0123456789abcdefghijklmnopqrstuvwxyz_ (No distinction is made between upper-case and lower-case alphabetic characters. Doublebyte characters cannot be used.) Multiple folders using the same three-digit combination (folder number) cannot be created. BFor example, if two folders exist named 100abcde and 100fghij respectively, the projector will not recognise them. Folder sub-hierarchies are not supported. BFor example, if a folder called 323fghij is created as a sub-folder of the 102abcde folder, the projector will not be able to recognise the sub- folder.File namesFile names must consist of four alphanumeric characters followed by four numerals (file number), followed by .jpg. (Example: abcd0001.jpg) BThe four numerals must make up a number between 0001 and 9999, and the alphanumeric characters can be taken from the following set of 37 characters: 0123456789abcdefghijklmnopqrstuvwxyz_ (No distinction is made between upper-case and lower-case alphabetic characters. Doublebyte characters cannot be used.) Multiple file names using the same four-digit combination (file number) cannot be created. BFor example, if two files exist named abcd0001.jpg and efgh0001.jpg respectively, the projector cannot recognise them normally.File formatBOnly JPEG image files which comply with the Exif 2.2 standard are recognised. Projection dimensions calculation methodsThe following methods will allow you to calculate dimensions such as screen diagonal length and projection distances. Units in all calculations are metre. SDSW 16:9 LW/LT H1 SH Screen Width: SW=SDx0.872 Screen Height: SH=SDx0.490 Minimum Projection Distance: LW=1.229xSD-0.0381 Maximum Projection Distance: LT=1.481xSD-0.0381 Image Lower Edge from Lens Center: H1=SW/32Dimensions 280(11) 80.2(3-5/32)85.2(3-11/32) PT-AE200U: 278.5(10 15/16) 65.4(2 9/16) 49.7(1 15/16) 269(10-9/16) PT-AE300U: 279.7(11)
66-E NGLISH Trademark acknowledgementsBThe SD logo is a trademark. BVGA and XGA are trademarks of International Business Machines Corporation. BMacintosh is a registered trademark of Apple Computer, Inc. BS-VGA is a registered trademark of the Video Electronics Standards Association. All other trademarks are the property of the various trademark owners. These Operating Instructions are printed on recycled paper. Panasonic Consumer Electronics Company, Division of Matsushita Electric Corporation of America One Panasonic Way Secaucus New Jersey 07094Panasonic Sales Company, Division of Matsushita Electric of Puerto Rico Inc. (“PSC”) Ave. 65 de Infanteria, Km 9.5 San Gabriel Idustrial Park, Carolina, Puerto Rico 00985Panasonic Canada Inc. 5770 Ambler Drive, Mississauga, Ontario L4W 2T3 (905) 624- 5010