Panasonic Kx Tgma44 Installation Manual

Installation Manual
Additional Digital Cordless Handset
Model No.    KX-TGMA44KX-TGMA45Thank you for purchasing a Panasonic product.
You must register this handset with your base unit before it can be used. This
installation manual describes only the steps needed to register and begin using
the 
handset. Please read the base unit’s operating instructions for further details.
Please read this installation manual before using the unit and save it for future
reference.
For assistance, visit our Web site:...

Installation
Accessory information 
...............3
Important Information
For your safety ...........................
4
Important safety instructions ......5
Other information .......................6
Getting Started
Setting up ..................................7
Controls ................................... 10
Accessibility
Accessibility  ............................. 14
Tone control .............................14
Volume booster  .......................15
Speech booster (making your
voice louder)...

Accessory information
Supplied accessories
Accessory item/Part number Quantity
Charger * 1
1
AC adaptor *
 2
/PNLV226X 1
Rechargeable batteries *
 3
/HHR-4DPA 2
Handset cover *
 4
,
  *5
1
Belt clip *
 6
1*1 PNLC1071ZW (White), PNLC1071ZS (Silver), PNLC1071ZB (Black)
*

2 The AC adaptor comes connected to the charger at the of shipment.
*3 The supplied rechargeable batteries in the handset are installed with yellow insulation sheet inserted between battery ends and terminals at the time of
shipment....

For your safety
T
o prevent severe injury and loss of life/property, read this section
carefully before using the product to ensure proper and safe operation of
your product. WARNING
Power connection
R
C

ompletely insert the AC adaptor/power plug into the power outlet.
Failure to do so may cause electric shock and/or excessive heat
resulting in a fire.
R Regularly remove any dust, etc. from the AC adaptor/power plug by
pulling it from the power outlet, then wiping with a dry cloth.
Accumulated dust may...

Ni-MH rechargeable batteries (supplied)
R
W
e recommend using the supplied batteries or additional/replacement
batteries noted on page 3 for replacement battery information.  USE
ONLY rechargeable Ni-MH batteries AAA (R03) size .
R Do not mix old and new batteries.
R Do not open or mutilate the batteries. Released electrolyte from the
batteries is corrosive and may cause burns or injury to the eyes or
skin. The electrolyte is toxic and may be harmful if swallowed.
R Exercise care when handling the...

2. Do not use the telephone to report a gas leak in the vicinity of the
l eak.
3. Use only the power cord and batteries indicated in this manual. Do not dispose of batteries in a fire. They may explode. Check with local
codes for possible special disposal instructions.
SAVE THESE INSTRUCTIONS Other information
R
O

perating the product near electrical appliances may cause
interference. Move away from the electrical appliances.
CAUTION:  Risk of explosion if battery is replaced by an incorrect type....

Setting up
Connections/Wall mounting
Connect the AC adaptor to the unit by pressing the plug firmly.
Fasten the cord by hooking it.
Connect the AC adaptor to the power outlet.
Drive the screws ( ) (not supplied) into the wall, if necessary.
 25 mm (1 inches)
Note:
R
T
he AC adaptor comes connected to the charger at the time of
shipment.
R The AC adaptor must remain connected at all times. (It is normal for
the adaptor to feel warm during use.)
R Make sure that the wall and the fixing method are strong...

Charge for about 7 hours.
R
C
onfirm  “Charging ” is displayed ( ).
R W
hen the batteries are fully charged,  “Fully charged ” is displayed. Note:
R
I

f the batteries are fully charged, but the operating time seems to be
shorter, clean the battery ends ( ,  ) and the charge contacts with a
d

ry cloth and charge again. Handset battery level
Icon Battery level
High
Medium
Low
Needs charging.
Empty
Panasonic Ni-MH battery performance
Operation Operating time
In continuous use 13 hours max.*
 1
Not in use...

Battery installation (for replacement)
I
mportant:
R Use the supplied rechargeable batteries. For replacement, we
recommend using the Panasonic rechargeable batteries noted on
page 3.
R USE ONLY rechargeable Ni-MH batteries AAA (R03) size ( ).
R D

o NOT use alkaline/manganese/Ni-Cd batteries.
R Confirm correct polarities ( ,  ).
For a
ssistance, please visit http://shop.panasonic.com/support
9Getting Started
TGMA44_45(en)_0606_ver101.pdf   92016/06/06   16:11:271   1  

Controls
Handset
A
Belt clip holes
B Speaker
C MTONE N (Tone control)
D Mj N/M k N (
VOL.: Volume
up/down)
E MF
LASH N
M TALK N
F Dial keypad
*:

 Temporary tone dialing
0 : ( ) Ringer off G
Headset jack
RT

his jack is used to
connect an optional
headset or a
user-supplied neckloop to
the handset. You must set
the  “Headset type ”
setting to match the type
of device connected.
H MZ N (
SP-PHONE:
Speakerphone)
10 For a
ssistance, please visit http://shop.panasonic.com/support Getting Started...