Panasonic Kx Tga660 Installation Manual

							Thank you for purchasing a Panasonic product.
Please read this installation manual before using the unit and 
save it for future reference.
For assistance, visit our Web site:
http://www.panasonic.com/help 
for customers in the U.S.A. or 
Puerto Rico.This unit is an additional handset compatible with the following 
series of Panasonic Digital Cordless Phone: 
KX-TG4131/KX-TG6591/KX-TG6631/KX-TG6641/
KX-TG7621/KX-TG7641
You must register this handset with your base unit before it can 
be used. This installation manual describes only the steps 
needed to register and begin using the handset. Please read 
the base unit’s operating instructions for further details.
Charge the batteries for about 7 hours before initial use.
Additional Digital Cordless Handset
Model No. 
KX-TGA660 Installation Manual
PNQX3161ZA  TT1110MG0 Printed in Malaysia
TGA660(e).fm  Page 1  Friday, November 19, 2010  2:22 PM 
						

							2For assistance, please visit http://www.panasonic.com/help
Accessory information
Supplied accessories
*1 PNLC1017ZB: Black, PNLC1017ZM: Metallic gray
*2 PNYNTGA660BR: Black, PNYNTGA660MR: Metallic gray
*3 The handset cover comes attached to the handset.
*4 PNKE1098Z1: Black, PNKE1098Z2: Metallic gray
Note:
LPlease read the base unit’s operating instructions for additional/
replacement accessories.
– Optional headsets: KX-TCA60, KX-TCA93, KX-TCA94, 
KX-TCA400, KX-TCA430
Accessory item/Order numberQuantity
Charger
*11
AC adaptor/PNLV226Z 1
Rechargeable batteries/HHR-4DPA 2
Handset cover
*2, *31
Belt clip
*41
TGA660(e).fm  Page 2  Friday, November 19, 2010  2:22 PM 
						

							For assistance, please visit http://www.panasonic.com/help3
Setting up
Connections/Wall mounting
Note:
LUse only the supplied Panasonic AC adaptor PNLV226.
LThe AC adaptor must remain connected at all times. (It is normal for 
the adaptor to feel warm during use.)
LMake sure that the wall and the fixing method are strong enough to 
support the weight of the unit.
Battery installation/Battery charging
Important:
LUse the supplied rechargeable batteries. For replacement, we 
recommend using the Panasonic rechargeable batteries noted on 
page 2.
LWipe the battery ends (S, T) with a dry cloth.
LAvoid touching the battery ends (S, T) or the unit contacts.
LConfirm correct polarities (S, T).
LUSE ONLY Ni-MH batteries AAA (R03) size.
LDo NOT use Alkaline/Manganese/Ni-Cd batteries.
(120 V AC, 
60 Hz)
Hooks
25.4 mm
(1 inch)
Screws
(Not supplied)
TGA660(e).fm  Page 3  Friday, November 19, 2010  2:22 PM 
						

							4For assistance, please visit http://www.panasonic.com/help
Charge for about 7 hours.
LWhen the batteries are fully charged, the charge indicator goes off and 
“Fully charged” is displayed.
Note:
LIf the batteries are fully charged, but the operating time seems to be 
shorter, clean the battery ends (S, T) and the charge contacts with a 
dry cloth and charge again.
Registering a handset to a base unit
1
Base unit:
Press and hold {LOCATOR} for about 5 seconds until the registration 
tone sounds.
LIf all registered handsets start ringing, press {LOCATOR} again to 
stop, then repeat this step.
2Handset:
Place the handset on the base unit or charger, then wait until a long 
beep sounds and w is displayed.
Note:
LIf an error tone sounds, or if _ is displayed, register the handset 
according to the base unit’s operating instructions.
Charge indicator
Confirm 
“Charging” 
is displayed. Rechargeable 
Ni-MH ONLY
TGA660(e).fm  Page 4  Friday, November 19, 2010  2:22 PM 
						

							For assistance, please visit http://www.panasonic.com/help5
Display language
1
{MENU} (11)
2{r}: Select the desired setting. s {SAVE}
3{OFF}
Belt clip
NTo attachNTo  r e m o v e
TGA660(e).fm  Page 5  Friday, November 19, 2010  2:22 PM 
						

							6For assistance, please visit http://www.panasonic.com/help
For your safety
To prevent severe injury and loss of life/property, read this section carefully before 
using the product to ensure proper and safe operation of your product.
WARNING
Power connection
LCompletely insert the AC adaptor/power plug into the power outlet. Failure to do 
so may cause electric shock and/or excessive heat resulting in a fire.
LRegularly remove any dust, etc. from the AC adaptor/power plug by pulling it 
from the power outlet, then wiping with a dry cloth. Accumulated dust may cause 
an insulation defect from moisture, etc. resulting in a fire.
LUnplug the product from power outlets if it emits smoke, an abnormal smell, or 
makes an unusual noise. These conditions can cause fire or electric shock. 
Confirm that smoke has stopped emitting and contact the Panasonic Call Center 
at 1-800-211- PANA (1-800-211-7262).
Installation
LTo prevent the risk of fire or electrical shock, do not expose the product to rain or 
any type of moisture.
LDo not place or use this product near automatically controlled devices such as 
automatic doors and fire alarms. Radio waves emitted from this product may 
cause such devices to malfunction resulting in an accident.
CAUTION
Installation and location
LThe AC adaptor is used as the main disconnect device. Ensure that the AC outlet 
is installed near the product and is easily accessible.
Battery
LWe recommend using the supplied batteries or additional/replacement batteries 
noted on page 2 for replacement battery information. USE ONLY rechargeable 
Ni-MH batteries AAA (R03) size.
LDo not mix old and new batteries.
LDo not open or mutilate the batteries. Released electrolyte from the batteries is 
corrosive and may cause burns or injury to the eyes or skin. The electrolyte is 
toxic and may be harmful if swallowed.
LExercise care when handling the batteries. Do not allow conductive materials 
such as rings, bracelets, or keys to touch the batteries, otherwise a short circuit 
TGA660(e).fm  Page 6  Friday, November 19, 2010  2:22 PM 
						

							For assistance, please visit http://www.panasonic.com/help7
may cause the batteries and/or the conductive material to overheat and cause 
burns.
LCharge the batteries provided with or identified for use with this product only, in 
accordance with the instructions and limitations specified in this manual.
LOnly use a compatible base unit (or charger) to charge the batteries. Do not 
tamper with the base unit (or charger). Failure to follow these instructions may 
cause the batteries to swell or explode.
Attention:
Important safety instructions
When using your product, basic safety precautions should always be followed to 
reduce the risk of fire, electric shock, and injury to persons, including the following:
1. Do not use this product near water for example, near a bathtub, washbowl, 
kitchen sink, or laundry tub, in a wet basement or near a swimming pool.
2. Do not use the telephone to report a gas leak in the vicinity of the leak.
3. Use only the power cord and batteries indicated in this manual. Do not dispose 
of batteries in a fire. They may explode. Check with local codes for possible 
special disposal instructions.
SAVE THESE INSTRUCTIONS
Other information
LOperating the product near electrical appliances may cause interference. Move 
away from the electrical appliances.
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of 
used batteries according to the instructions.
Routine care
LWipe the outer surface of the product with a soft moist cloth.
LDo not use benzine, thinner, or any abrasive powder.A nickel metal hydride battery that is 
recyclable powers the product you have 
purchased.
Please call 1-800-8-BATTERY (1-800-822-
8837) for information on how to recycle this 
battery.
TGA660(e).fm  Page 7  Friday, November 19, 2010  2:22 PM 
						

							8For assistance, please visit http://www.panasonic.com/help
Notice for product disposal, transfer, or return 
LThis product can store your private/confidential information. To protect your 
privacy/confidentiality, we recommend that you erase information such as 
phonebook or caller list entries from the memory before you dispose of, transfer, 
or return the product.
FCC and other information
This equipment is hearing aid compatible as defined by the FCC in 47 CFR Section 
68.316.
When you hold the phone to your ear, noise might be heard in your Hearing Aid. 
Some Hearing Aids are not adequately shielded from external RF (radio frequency) 
energy. If noise occurs, use an optional headset accessory or the speakerphone 
option (if applicable) when using this phone. Consult with your audiologist or 
Hearing Aid manufacturer about the availability of Hearing Aids which provide 
adequate shielding to RF energy commonly emitted by digital devices.
WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING TEST 
CALLS TO EMERGENCY NUMBERS:
1) Remain on the line and briefly explain to the dispatcher the reason for the call.
2) Perform such activities in the off-peak hours, such as early morning or late 
evenings.
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept 
any interference received, including interference that may cause undesired 
operation.
Privacy of communications may not be ensured when using this phone.
CAUTION:Any changes or modifications not expressly approved by the party responsible for 
compliance could void the user’s authority to operate this device.
NOTE:This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses, and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this 
TGA660(e).fm  Page 8  Friday, November 19, 2010  2:22 PM 
						

							For assistance, please visit http://www.panasonic.com/help9
equipment does cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user is encouraged to 
try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC RF Exposure Warning:
LThis product complies with FCC radiation exposure limits set forth for an 
uncontrolled environment. 
LThis handset may not be collocated or operated in conjunction with any other 
antenna or transmitter.
LThe handset may be carried and operated with only the specific provided belt-
clip. Other non-tested belt-clips or similar body-worn accessories may not 
comply and must be avoided.
Notice:
LFCC ID can be found inside the battery compartment or on the bottom of the unit.
Compliance with TIA-1083 standard:
Telephone handsets identified with this logo have reduced 
noise and interference when used with T-Coil equipped hearing 
aids and cochlear implants.
T
Compatible with
Hearing Aid T-Coil
TIA-1083
TGA660(e).fm  Page 9  Friday, November 19, 2010  2:22 PM 
						

							10For assistance, please visit http://www.panasonic.com/help
Notice
LThis product is designed for use in the United States of America. Sale or use 
of this product in other countries may violate local laws.
LCet appareil est conçu pour être utilisé aux États-Unis d’Amérique. La vente 
ou l’emploi de cet appareil dans certains autres pays peut constituer une 
infraction à la législation locale.
LEste producto está diseñado para usarse en los Estados Unidos de América. 
La venta o el empleo de este producto en ciertos países puede constituir 
violación de la legislación local.
L
LÎé-~ ê”ãÄÖâé
ö!ª
á›ãÒá.3.ÐáÅ”ãÄÖ]âé

ö!ªê:Þ1‘
ûãåùÔ•åÞá”°$ âêãÄÖ]æÅ¿áê
ÚããÒ
áC!åäé(oF,ê)LÒÆèùÔ•
TGA660(e).fm  Page 10  Friday, November 19, 2010  2:22 PM