Panasonic Kx Tg633 Operating Instructions Manual

Important:
R We recommend storing 10 digits (including
the area code). If only 7 digits are stored, all
numbers that have the same last 7 digits
will be blocked.
n  From the caller list:
1 MC N CID
2 Mb N: Select the entry to be blocked.
R To edit the number:  MMENU N a  M b N:
“ Edit ” a  M SELECT N
Press  MEDIT N repeatedly until the
phone number is shown in the 10-digit
format. And then, press  MSAVE N. Go to
step 5.
3 MMENU N
4 Mb N:  “Save CID ” a  M SELECT N
5 Mb N:  “Call block ” a  M SELECT N
6...

1Handset:
M MENU N#130
2 Base unit:
Press and hold  M
N for about 5 seconds.
R If all registered handsets start ringing,
press  M
N again to stop, then repeat
this step.
3 Handset:
Press  MOK N, then wait until a long beep
sounds.
Deregistering a handset
1 MMENU N#131
R All handsets registered to the base unit
are displayed.
2 Mb N: Select the handset you want to
cancel.  a M SELECT N
3 Mb N:  “Yes ” a  M SELECT N a  M OFF N
22For assistance, please visit http://shop.panasonic.com/support
Programming   

Using Caller ID serviceImportant:
R This unit is Caller ID compatible. To use
Caller ID features, you must subscribe to a
Caller ID service. Contact your phone
service provider for details.
Caller ID features
When an outside call is being received, the
caller information is displayed.
Caller information for the last 50 callers is
logged in the caller list from the most recent
call to the oldest.
R If the unit cannot receive caller information,
the following is displayed:
– “Out of area ”: The caller...

Answering system
The answering system can answer calls and
record caller messages. If you do not want to
record messages, select  “Greeting only ”
as the recording time setting (page 27).
Recording capacity
The total recording time is about 17 minutes,
including your greeting message. Up to 64
messages can be recorded.
Note:
R When message memory becomes full:
– “Messages full ” is shown on the
handset display.
– The ANSWER ON/OFF indicator on the base unit flashes rapidly if the answering
system is...

1To listen to new messages:
M MENU N#323
To listen to all messages:
M MENU N#324
2 When finished, press  MOFF N.
Operating the answering system
M MENU N a  M b N:  “Answering device ” a
M SELECT N
KeyOperationMD N or  MC NAdjust the receiver/speaker
volume (during playback)1  or  MF NRepeat message (during
playback)2  or  ME NSkip message (during
playback)3Enter the  “Settings ” menu4Play new messages5Play all messages6Play greeting message76Record greeting message8Turn answering system onMPAUSE NPause...

nWhen the Spanish voice guidance is
selected
To start the voice guidance, press  9. The
voice guidance announces the available
remote commands (page 26).
Note:
R If you do not press any dial keys within 10
seconds after a voice guidance prompt, the
unit disconnects your call.
Remote commands
KeyOperation1Repeat message (during playback)2Skip message (during playback)4Play new messages5Play all messages9Stop playback *1
Start voice guidance *20Turn answering system off*4Erase currently playing...

Caller’s recording timeYou can change the maximum message
recording time allowed for each caller.
1 MMENU N#305
2 Mb N: Select the desired setting.  a
M SAVE N a  M OFF N
Selecting “ Greeting only ”
You can select  “Greeting only ” which sets
the unit to announce a greeting message to
callers but not record messages.
Select  “Greeting only ” in step 2 on
“Caller’s recording time”, page 27.
For assistance, please visit http://shop.panasonic.com/support27
Answering System 

Voicemail serviceIn addition to your unit’s answering system
you may also have voicemail service from
your phone service provider.  Voicemail is
an answering service that may be offered by
your phone service provider. This service can
also record calls when you are unavailable to
answer the phone or when your line is busy.
Messages are recorded on the phone
company system and not on the unit’s
answering system.
R To use the voicemail service rather than the
unit’s answering system, turn off the
answering...

Error messages
Display messageCause/solutionBase no power
or
No link. Re-connect base
AC adaptor.R The handset has lost communication with the base
unit. Move closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset’s registration may have been canceled.
Re-register the handset (page 21).BusyR Other units are in use and the system is busy. Try
again later.Call phone company for
your access #R You have not stored the...

ProblemCause/solutionI cannot hear a dial tone.RThe base unit’s AC adaptor or telephone line cord is not
connected. Check the connections.Time on the unit has shifted.R Incorrect time information from incoming Caller ID
changes the time. Set the time adjustment to  “Manual ”
(off) (page 18).
Battery recharge
ProblemCause/solutionI fully charged the batteries, but
– still flashes,
– is displayed, or
– the operating time seems to be shorter.
RClean the battery ends (, ) and the charge contacts
with a dry...