Panasonic Kx Ps8100 Operating Instructions Manual

11 Contents
Setting up the printer  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .40
Preparing the color imaging unit  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .40
Setting up the output tray . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .41
Installing the toner cartridges . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .42
Setting up the scanner  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .44...

12 Contents
Installing the software to Windows 98  . . . . . . . . . . . . . . . . . .103
Installing the scanner driver, utilities and PostScript printer driver. . . . . . .103
Installing the software for Windows NT 4.0  . . . . . . . . . . . . . .114
Setting up PostScript printing with Windows NT 4.0  . . . . . . . . . . . . . . . . .114
Installing the PostScript printer driver for Windows NT 4.0  . . . . . . . . . . . .115
Specifying installed devices . . . . . . . . . . . . . . . . . . . . . . . . . ....

13 Contents
Completing setup from Fiery WebSetup . . . . . . . . . . . . . . . . .151
Setting up Fiery WebTools . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .151
Accessing Fiery WebSetup  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .154
System Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .156
Network Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .158...

14
Clearing media jams . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . .218
Chapter 10
Appendix
Chapter 9 

15
For Your  Safety
General
Warning
•
To prevent fire or shock hazard, do not expose this product to rain or any 
type of moisture.
Cautions
•
Do not open covers and do not attempt to repair the unit yourself. Refer 
servicing to qualified personnel.
•Avoid contact with the rotating rollers when the ADF top cover is open.
Power source
Warning
•
The power source voltage of this unit is listed on the nameplate. Only plug 
the unit into an outlet with the proper voltage.
•When you operate this equipment,...

16 For Your  Safety
Light source
•Do not look directly at the light source lamps of the scanner when 
scanning as this may be harmful to your eyes.
Moving the units
The scanner weighs approximately 22.5 kg {49.5 lbs.} and the printer 
weighs approximately 49.5 kg {108.9 lbs.}. They must be handled by two 
people. Turn the power off and remove the power cords when handling the 
units. 

17 For Your  Safety
Caution labels 
CLASS
KLASSE
CLASSE
CLASE1 LASER PRODUCT
1 LASER PRODUKT
1 LASER PRODUIT
1 LÁSER PRODUCTO
CAUTION:
HOT SURFACE INSIDE
CAUTION:HOT SURFACE BELOWATTENTION:SURFACE CHAUDE CI-DESSOUSVORSICHT:HEIßE OBERFLÄCHE DARUNTERATENCION:SUPERFICIE CALIENTE ABAJO
ATTENTION:SURFACE
CHAUDE
CI-INTERIEUR
VORSICHT:HEISSE FLÄCHE
INTERN
ATENCION:SUPERFICIE
CALIENTE
EN EL INTERNO
CAUTION:HOT SURFACE
INSIDE
ATTENTION:
Rayonnement laser invisible
dangereux en cas
douverture et lorsque
la...

18 For Your  Safety
FOR USERS IN U.K.
IMPORTANT:
FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY
Both the printer and scanner are supplied with a moulded three pin mains plug each for your safety and 
convenience. 
A 13 amp fuse is fitted in this plug. Should the fuse need to be replaced please ensure that the 
replacement fuse has a rating of 13 amps and that it is approved by ASTA or BSI to BS 1362.
Check for the ASTA mark   or the BSI mark   on the body of the fuse.
If the plug contains a...

Chapter 1
19Before You Start
Before you set up your new system, please read the following information.
Cautions
To avoid problems, do not use the equipment under the following conditions:
•Direct exposure to sunlight
•Extremely high or low temperature [temperature range: 10˚C to 32.5˚C 
(50˚F to 90.5˚F)]
•Extremely high or low humidity (humidity range: 20% to 80% RH)
•Condensation due to rapid change of temperature
•Areas of poor ventilation
•Areas of high dust or chemical fume concentration (solvent...

20 Before You  Start
•Directly in front of air conditioning vents
•Liquids near the equipment
•Liquid spills can cause severe damage.
•Too much media/document which exceeds the limit mark (     ) on the 
guide of the tray.
•Front/right/left doors opened while the printer is operating; it may cause a 
media jam.
•Any toner other than genuine Panasonic toner. It may damage the printer.
Not genuine toner