Panasonic Interchangeable Lens For Digital Camera H-fs014045 Operating Instructions

Operating Instructions
INTERCHANGEABLE LENS FOR DIGITAL CAMERA
Model No.
H-FS014045
Before connecting, operating or adjusting this 
product, please read the instructions completely.
For USA and Puerto Rico assistance, please call: 1-800-211-PANA(7262) or, contact us via the web at: http://www.panasonic.com/contactinfoFor Canadian assistance, please call: 1-800-99-LUMIX (1-800-995-8649) or 
                                    send e-mail to: [email protected]
PP
VQT2A12
until 
2009/ 5/17...

2VQT2A12ContentsInformation for Your Safety ..................................... 2Precautions ........................................................... 5
Supplied Accessories ............................................. 6
Attaching/Detaching the Lens ................................. 6
Names and Functions of Components ................... 8
Cautions for Use ..................................................... 9 Troubleshooting .................................................. 10...

3
VQT2A12
≥The digital camera illustrations in these operating 
instructions show DMC-G1 as an example.
≥ The appearance and specifications of products 
described in this manual may differ from the actual 
products you have purchased due to later 
enhancements.
≥ Four Thirds
TM is a trademark.
≥ Micro Four Thirds is a trademark.
≥ Other names, company names, and product 
names printed in these instructions are 
trademarks or registered trademarks of the 
companies concerned.
ENGLISH
VQT2A12_ENG_SPA.book...

4VQT2A12THE FOLLOWING APPLIES ONLY IN THE U.S.A.FCC Note:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of 
the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance 
with the instructions, may cause harmful interference to radio communications....

5
VQT2A12
∫Lens Care≥Sand and dust can damage the lens. Make 
sure that no sand or dust gets inside the lens 
or the terminals when using the lens on a 
beach, etc.
≥ This lens is not waterproof. If drops of water 
get onto the lens, wipe the lens with a dry 
cloth.
≥ Do not press the lens with excessive force.
≥ When there is dirt (water, oil, and fingerprints, etc.) 
on the surface of the lens, the picture may be 
affected. Lightly wipe the surface of the lens with a 
soft, dry cloth before and after...

6VQT2A12Supplied Accessories[Inspection to be performed when you unpack 
the unit]
When removing the unit from its packing box, check 
that the main unit and the supplied accessories are 
there and also check their external appearance and 
functions to verify that they have not sustained any 
damage during distribution and transportation.
If you discover any trouble, contact your vendor 
before using the product.1
Lens Storage Bag
2
Lens Hood
3
Lens Cap
4
Lens Rear Cap
(The lens cap and lens rear cap are...

7
VQT2A12
∫Detaching the Lens≥Check that the camera is turned off.Press the lens release 
button  C while turning 
the lens as far as 
possible in the direction 
of the arrow to detach it.• Attach the lens rear cap so 
that the lens contact point does not get 
scratched.
• Attach the body cap to the camera so no dirt or  dust will get inside the main unit.∫ Attaching and Detaching the Lens Cap≥Be careful not to lose 
the lens cap.
∫ Attaching the Lens Hood 
(Supplied Accessory)Insert the lens hood into...

8VQT2A122Reverse the lens hood and then attach it 
in the same way as shown previously.• When taking pictures with 
the flash with the lens hood 
attached, the lower portion 
of the screen may turn dark 
(vignetting effect) and the 
control of the flash may be 
disabled because the photo 
flash may be obscured by the lens hood. We 
recommend detaching the lens hood.
• When using the AF assist lamp in the dark,  detach the lens hood.∫ Attaching Filters≥Edges of pictures may be cut off if more than one 
PL...

9
VQT2A12
4[O.I.S.] switchWhen the lens is attached to the camera the 
stabilizer function is set to activate if the [O.I.S.] 
switch is set to [ON].
≥We recommend setting the [O.I.S.] switch to [OFF] 
when using a tripod.
≥ The stabilizer function may not be effective in the 
following cases.
– When there is a lot of jitter.
– When the zoom magnification is high.
– When using the digital zoom.
– When taking pictures while following a moving  subject.
– When the shutter speed becomes slower to take...

10VQT2A12– Near heaters, air conditioners or humidifiers
– Where water may make the unit wet
– Where there is vibration
– Inside a vehicle
≥ Refer also to the operating instructions of the 
digital camera.
≥ When the unit is not going to be used for a 
prolonged period, mold and other problems may 
cause performance failure. It is recommended that 
you check the unit’s operation prior to use.
≥ Do not leave the lens in contact with rubber or 
plastic products for extended periods of time.
≥ Do not touch...