Panasonic Interchangeable Lens For Digital Camera H-f008 Operating Instructions

							Operating Instructions
INTERCHANGEABLE LENS FOR DIGITAL CAMERA
Model No.
H-F008
Before connecting, operating or adjusting this 
product, please read the instructions completely.
For USA and Puerto Rico assistance, please call: 1-800-211-PANA(7262) or, contact us via the web at: http://www.panasonic.com/contactinfoFor Canadian assistance, please call: 1-800-99-LUMIX (1-800-995-8649) or 
                                    send e-mail to: [email protected]
PP
VQT2W38
until 
2010/6/17
H-F008PP-VQT2W38.book  1 ページ  ２０１０年６月２日　水曜日　午前１０時１２分 
						

							2VQT2W38ContentsInformation for Your Safety ..................................... 2Precautions ........................................................... 5
Supplied Accessories ............................................. 6
Attaching/Detaching the Lens ................................. 6
To use commercially available filters ...................... 8
Names and Functions of Components ................... 9
Cautions for Use ..................................................... 9 Troubleshooting .................................................. 10
Specifications........................................................ 11
Limited Warranty................................................... 12-If you see this symbol-
THE FOLLOWING APPLIES ONLY IN CANADA.Information for Your SafetyKeep the unit as far away as possible from 
electromagnetic equipment (such as microwave 
ovens, TVs, video games, radio transmitters, 
high-voltage lines etc.).
≥ Do not use the camera near cell phones because 
doing so may result in noise adversely affecting 
the pictures and sound.
≥If the camera is adversely affected by electromagnetic 
equipment and stops functioning properly, turn the 
camera off and remove the battery and/or the 
connected AC adaptor. Then reinsert the battery and/
or reconnect the AC adaptor and turn the camera on.The lens can be used with a digital camera 
compatible with the lens mount standard for the 
“Micro Four Thirds
TM System”.
≥
It cannot be mounted on the 
Four Thirds
TM mount 
specification camera.
Information on Disposal in other Countries 
outside the European Union
This symbol is only valid in the 
European Union.If you wish to discard this 
product, please contact your 
local authorities or dealer and 
ask for the correct method of 
disposal.
This Class B digital apparatus complies with 
Canadian ICES-003.
H-F008PP-VQT2W38.book  2 ページ  ２０１０年６月２日　水曜日　午前１０時１２分 
						

							3
VQT2W38
≥The digital camera illustrations in these operating 
instructions show DMC-G2 as an example.
≥ The appearance and specifications of products 
described in this manual may differ from the actual 
products you have purchased due to later 
enhancements.
≥ Four Thirds
TM and Four Thirds Logo marks are 
trademarks or registered trademarks of Olympus 
Imaging Corporation, in Japan, the United States, 
the European Union and other countries.
≥ Micro Four Thirds
TM and Micro Four Thirds Logo 
marks are trademarks or registered trademarks of 
Olympus Imaging Corporation, in Japan, the 
United States, the European Union and other 
countries.
≥ G MICRO SYSTEM is a lens exchange type 
digital camera system of LUMIX based on a Micro 
Four Thirds System standard.
≥ Other names, company names, and product 
names printed in these instructions are 
trademarks or registered trademarks of the 
companies concerned.
ENGLISH
H-F008PP-VQT2W38.book  3 ページ  ２０１０年６月２日　水曜日　午前１０時１２分 
						

							4VQT2W38THE FOLLOWING APPLIES ONLY IN THE U.S.A.FCC Note:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of 
the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance 
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to 
correct the interference by one or more of the following measures:●Reorient or relocate the receiving antenna.●Increase the separation between the equipment and receiver.●Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.●Consult the dealer or an experienced radio/TV technician for help.
Any unauthorized changes or modifications to this equipment would void the user’s authority to operate this device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This 
device may not cause harmful interference, and (2) this device must accept any interference received, including 
interference that may cause undesired operation.
Responsible Party:
Panasonic Corporation of North America
One Panasonic Way
Secaucus, NJ 07094
Support Contact:
Panasonic Consumer Electronics Company
Telephone No.: 1-800-211-PANA (7262) 
H-F008PP-VQT2W38.book  4 ページ  ２０１０年６月２日　水曜日　午前１０時１２分 
						

							5
VQT2W38
∫Lens Care≥Sand and dust can damage the lens. Make 
sure that no sand or dust gets inside the lens 
or the terminals when using the lens on a 
beach, etc.
≥ This lens is not waterproof. If drops of water 
get onto the lens, wipe the lens with a dry 
cloth.
≥ Do not press the lens with excessive force.
≥ When there is dirt (water, oil, and fingerprints, etc.) 
on the surface of the lens, the picture may be 
affected. Lightly wipe the surface of the lens with a 
soft, dry cloth before and after taking pictures.
≥ Do not place the lens mount facing downwards. 
Do not allow the lens contact points  1 to become 
dirty.
∫ About Condensation (Fogging of the 
Lens)≥Condensation occurs when  there are differences 
in temperature and humidity as described below. 
Condensation can cause the lens to become dirty 
and lead to mold and malfunctioning, so exercise 
caution in the following situations:
– When the camera is brought indoors from outside 
during cold weather
– When the camera is brought into an air- conditioned car
– When cold air from an air conditioner is directly  blown onto the lens
– In humid places
≥ Put the camera into a plastic bag to allow it to 
acclimatize to the surrounding temperature in 
order to prevent condensation. If condensation 
occurs, turn the power off and leave it for about 
two hours. Once the camera acclimatizes to the 
surrounding temperature the condensation will go 
away naturally.
PrecautionsH-F008PP-VQT2W38.book  5 ページ  ２０１０年６月２日　水曜日　午前１０時１２分 
						

							6VQT2W38Supplied Accessories[Inspection to be performed when you unpack the unit]When removing the unit from its packing box, check 
that the main unit and the supplied accessories are 
there and also check their external appearance and 
functions to verify that they have not sustained any 
damage during distribution and transportation.
If you discover any trouble, contact your vendor 
before using the product.
Product numbers correct as of May 2010. These 
may be subject to change.1
Lens Storage Bag
2
Lens Front Cap
3
Lens Rear Cap
(The lens front cap and lens rear cap are 
attached to the interchangeable lens at the time 
of purchase.)
Attaching/Detaching the Lens≥ Refer also to the camera’s operating instructions 
for attaching and detaching the lens.∫ Attaching the Lens≥Check that the camera is turned off.1 Turn the lens rear 
cap to detach it.A: Lens Rear Cap2 Align the lens fitting marks
 B (red marks)
 on 
the camera body and the 
lens and then rotate the 
lens in the direction of 
the arrow until it clicks.
• Do not press the lens release button  C when 
you attach a lens.
• Do not try to attach the lens when holding it at an  angle to the camera body as the lens mount may 
get scratched.
• Check that the lens is attached correctly.
VFC4456 VFC4560
VFC4315
3
12



H-F008PP-VQT2W38.book  6 ページ  ２０１０年６月２日　水曜日　午前１０時１２分 
						

							7
VQT2W38
∫Detaching the Lens≥Check that the camera is turned off.Press the lens release 
button  D while turning 
the lens as far as 
possible in the direction 
of the arrow to detach it.• Attach the lens rear cap so 
that the lens contact point does not get 
scratched.
• Attach the body cap to the camera so no dirt or  dust will get inside the main unit.∫ Attaching and Detaching the Lens Front 
Cap≥Be careful not to lose 
the lens front cap.
∫ Features of this lens≥This lens is an equisolid angle projection fisheye 
lens with a 180 x field of view in a diagonal 
direction. Be careful about the legs of the tripod or 
arms and legs of the photographer entering the 
frame when taking pictures.
≥ As the fisheye lens captures images of a very 
wide angle, the characteristics of the lens causes 
subjects close to the perimeter of the image to 
appear extremely warped, or causes the size or 
relative position of the subjects to look different 
when pictures are taken. The image will look 
greatly different even with the slightest movement 
of the camera, so view the screen and check the 
composition of the picture when taking pictures.

H-F008PP-VQT2W38.book  7 ページ  ２０１０年６月２日　水曜日　午前１０時１２分 
						

							8VQT2W38To use commercially available filters≥There is a filter holder at the rear of this lens. To 
use it, insert a commercially available sheet filter, 
such as a gelatin filter or similar, into the filter 
holder.1 Prepare the filter.• Cut the filter to the 
size that can be used 
with this lens. 
(right image)
Size of the filter
A : 21.5 mm to 22 mm
B : 3mm to 4mm
2 Insert the cut filter C all the way into the 
filter holder  D.E: Lens fitting mark
• To remove the filter, pull it out straight.3 Mount the lens onto the digital camera.

 


 





H-F008PP-VQT2W38.book  8 ページ  ２０１０年６月２日　水曜日　午前１０時１２分 
						

							9
VQT2W38
Names and Functions of Components∫Lens
1 Lens surface
2 Lens hood
3 Focus ringRotate to focus when taking pictures with manual 
focus.4Filter holder
5 Contact points
6 Lens fitting mark
Note
≥ Since this lens is a fisheye lens with 180 x diagonal 
field of view, the perimeter of the image may 
become dark (vignette) when a flash is used to 
take pictures.
Cautions for Use∫ About the LensTake care not to drop or knock the lens. Also 
take care not to put a lot of pressure on the lens.
≥Take care not to drop the bag that you inserted the 
lens in as it may damage the lens. The camera may 
stop operating normally and pictures may no longer 
be recorded.When using pesticides and other volatile 
substances around the camera make sure that 
they do not get onto the lens.
≥If such substances get onto the lens they can 
damage the exterior case or cause the paint to 
peel.
23 4
1
56
H-F008PP-VQT2W38.book  9 ページ  ２０１０年６月２日　水曜日　午前１０時１２分 
						

							10VQT2W38Do not carry the unit when it is still attached to 
the camera body.
≥Under no circumstances should the unit be stored 
in any of the following locations since doing so 
may cause problems in operation or 
malfunctioning.
– In direct sunlight or on a beach in summer
– In locations with high temperatures and humidity  levels or where the changes in temperature and 
humidity are acute
– In locations with high concentrations of sand,  dust or dirt
– Where there is fire
– Near heaters, air conditioners or humidifiers
– Where water may make the unit wet
– Where there is vibration
– Inside a vehicle
≥ Refer also to the operating instructions of the 
digital camera.
≥ When the unit is not going to be used for a 
prolonged period, we recommend storing with a 
desiccant (silica gel). Failure to do so may result in 
performance failure caused by mold, etc. It is 
recommended that you check the unit’s operation 
prior to use. ≥
Do not leave the lens in contact with rubber or 
plastic products for extended periods of time.
≥ Do not touch the lens contact point. Doing so can 
cause failure of the unit.
≥ Do not disassemble or alter the unit.
Do not use benzine, thinner, alcohol or other 
similar cleaning agents to clean the lens glass or 
exterior cabinet.
≥ Using solvents can damage the lens or cause the 
paint to peel.
≥ Wipe off any dust or fingerprints with a soft, dry 
cloth.
≥ Use a dry, dust cloth to remove dirt and dust on 
the focus ring.
≥ Do not use a household detergent or a chemically 
treated cloth.
A sound is heard when the camera is turned on 
or off.
≥ This is the sound of lens or aperture movement 
and is not a malfunction.
Troubleshooting
H-F008PP-VQT2W38.book  10 ページ  ２０１０年６月２日　水曜日　午前１０時１２分