Panasonic Ic Recorder Rr-xr320 Operating Instructions

p
Panasonic Consumer Electronics Company, Division of Matsushita Electric Corporation of America One Panasonic Way Secaucus, New Jersey 07094
http://www.panasonic.comPanasonic Sales Company, Division of Matsushita Electric of Puerto Rico, Inc. (“PSC”)Ave. 65 de Infantería, Km. 9.5 San Gabriel Industrial Park, Carolina, Puerto Rico 00985
c 
2000 Matsushita Electric Industrial Co., Ltd.
Printed in Japan
RQT5626-P
RQT5626-P  F1200KB0
Before connecting, operating or adjusting this product, please
read these...

23
RQT5626RQT5626
Dear CustomerThank you for purchasing this product.
For optimum performance and safety, please read these instructions carefully.Optional accessoriesªUSB Reader/Writer
Replacement part number:BN-SDCAPU/1B
Table of contents
Before use
Basic operations
Advanced operations
References
LIstening caution . . . . . . . . . . . . . . . . . . . . . . . 4
Inserting the batteries. . . . . . . . . . . . . . . . . . . . 5
Hold function . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Setting...

Inser ting the batteries
Listening caution
45
+
+
-
-
2
1
3
If strong impacts or dropping of the unit cause the
batteries, battery cover, card and card cover to come
loose while recording:
≥Recording can be lost.
or 
≥The card may not be read correctly. (Reinsert the
batteries and card.) ≥Use alkaline batteries. Manganese batteries cannot be
used. 
≥Do not press any of the buttons while inserting the batteries.≥Ensure the battery cover is completely closed to avoid
malfunction. The display goes out if...

Full
Low
MODE
67
Inser ting the batteries
Hold function
The battery indicator
The indicator is shown during operation.This prevents accidental operation causing the
batteries to run down. 
When switched on
‘‘HOLD’’ appears for a few
seconds and then the display
goes out. Switch hold on
when not using the unit to
preserve the batteries.
Release hold before operation. Replace the batteries when the indicator starts
flashing.
(Flashes)
≥The unit indicates the batteries are low even
when there is still some...

ªAfter you insert a card
‘‘Welcome to Panasonic’’
appears on the display. 
The unit creates four new folders
if you insert a new, unused card.
ªTo remove the card
While the unit is stopped, open the cover and
press on the center of the card to unlock it.Do not remove the card or batteries while the unit is
performing operations. This can cause data to be
destroyed. 
Read the notes on SD Memory Cards on page 35.
You can use MultiMedia Cards in place of SD Memory
Cards, but you must format them before...

ªRecording quality
The total recording time depends on the recording quality
you select. HQ (high quality) is factory setting and provides
the best sound quality.Approximate recording times on the included 16 MB SD Memory CardªTo change the quality(‘ illustration on page 9)
This example  shows how to set quality to HQ.1
Press [MODE].
2
1Within 10 seconds
Push [SELECT, ENTER] up or
down so “QUALITY” flashes.
2Within 10 seconds
Press [SELECT, ENTER].
3
1Within 10 seconds
Push [SELECT, ENTER] up or
down to...

ªChecking the remaining
recording time
Press [MODE] while recording.
Press again to return to the
previous display. 
The above display is shown automatically when the
remaining recording time becomes very short. Press
[MODE] to show the recording time in this case.
ªChecking the remaining
memory on the card
While the unit is stopped, press
and hold [STOP] for 2 seconds.
The meter reduces from right
to left as the remaining
memory reduces.
ªConnecting external microphone
Connect the microphone to the [MIC...

Preparation
Select the folder containing the file you want to play.1
Push [SELECT, ENTER] up or down to select the
file.
The file information is shown in the following order.
2
Press [SELECT, ENTER] to start
play.
3
Press [VOLUME (r, s)] to adjust the volume. 
ªTo stop play
Press [STOP].
Press [SELECT, ENTER] to resume play from where you
stopped.
Play
FOLDER
_
`


STOP
Volume may change during cue/review and after dividing files.ªControlling play with [SELECT, ENTER]
To stop playPress during
play
Push...

Play
There are three play speeds. The speed is factory set to
normal.
ªChecking the remaining play time
Press [MODE] during play.
Press again to return to
the previous display. 
ªScanning the files: Intro-scan
This plays the first five seconds of all the
files in a folder in order.
While stopped, press and hold [SELECT,
ENTER] for about two seconds.
When you find the file you want to play,
press [SELECT, ENTER]. The file is played
through to the end.This example shows how to turn the tone off.
1
Press...

Deleting files
3
Press [ERASE].
If you deleted one file, the file numbers afterthat file decrease by one.
ªTo cancel partway through
Press [STOP] before step 3.
≥If you have selected an empty folder, “File
Erase?” will not be displayed when you press
and hold [ERASE]. 
≥You cannot delete locked files. Unlock the files
before deleting them (‘right, Locking files).
≥After repeatedly recording and deleting files, the
total possible recording time may be reduced.
You can remedy this by reformatting the card...