Panasonic Hx Wa03 Basic Owners Manual
Here you can view all the pages of manual Panasonic Hx Wa03 Basic Owners Manual. The Panasonic manuals for Camera are available online for free. You can easily download all the documents as PDF.
Page 21
VQT4X05 21 ∫ About batteries that you can use with this unit Inserting/removing the battery ≥Press the power button to turn off the unit. ( l30) 1Open the rear door. Preparation Power supply The battery that can be used with this unit is VW-VBX090. It has been found that counterfeit battery packs which look very similar to the genuine product are made available to purchase in some markets. Some of these battery packs are not adequately protected with internal protection to meet the requirements of...
Page 22
22 VQT4X05 2(To insert the battery pack) Confirm the orientation of the terminal markings and insert the battery. Aterminal markings ≥ Confirm that lever B is locked on to the battery. ≥ It is possible to mistakenly insert the battery upside down, so be sure to check the orientation carefully. (To remove the battery pack) Push the lever B toward the direction of arrow, and pull the battery straight out. HX-WA30&WA3&WA03_PP&PU-VQT4X05_mst.book 22 ページ 2013年1月16日 水曜日 午後5時29分
Page 23
VQT4X05 23 3Close the rear door. 1Close the rear door. 2 Slide the open/close lever. 3 Lock the LOCK lever. ≥ Lock securely to the points where the red portion C of the open/close lever and LOCK lever are no longer visible. LOCK SD CARD/ BATTERY LOCK SD CARD/ BATTERYSD CARD/ BATTERY LOCK Unlocked state Locked state Open/close lever Lock lever HX-WA30&WA3&WA03_PP&PU-VQT4X05_mst.book 23 ページ 2013年1月16日 水曜日 午後5時29分
Page 24
24 VQT4X05 Charging the battery The unit is in the standby condition when the AC adaptor is connected. The primary circuit is always “live” as long as the AC adaptor is connected to an electrical outlet. Important: ≥The AC adaptor and USB cable are for use with this unit only. Do not use them with other equipment. Similarly, do not use AC adaptors and USB cables from other equipment with this unit. ≥ The battery is charged while the unit is off or in the Standby Mode. The battery cannot be charged...
Page 25
VQT4X05 25 3Connect the USB cable to the unit. ≥Connecting the USB cable in the wr ong direction may cause damage to the USB/AV connector of the unit. If the connector has become damaged, it may not operate correctly, including failure to recognize the cable even if it has been connected. ≥ The status indicator flashes red with a period of approximately 2 seconds (approximately 1 second on, 1 second off), and charging begins. It will turn off when the charging is completed. ≥ Do not use any other AC...
Page 26
26 VQT4X05 ≥These times are approximations. ≥ The indicated charging time is for when the battery has been discharged completely. Charging time and recordable time vary depending on the usage conditions such as high/low temperature. In particular, using the battery at a low temperature below 0 oC (32 oF) will drastically shorten the usable time due to a characteristic of the battery. ≥ The actual recordable time refers to the recordable time when repeatedly starting/stopping recording, turning...
Page 27
VQT4X05 27 The unit can record motion pictures, still pictures or audio to an SD card or built-in memory. To record to an SD card, read the following. Cards that you can use with this unit Use SD cards conforming to Class 4 or higher of the SD Speed Class Rating for motion picture recording. ≥Keep the Memory Card out of reach of children to prevent swallowing. Preparation Recording to a card Please confirm the latest informat ion about SD Memory Cards/SDHC Memory Cards/SDXC Memory Cards that can be...
Page 28
28 VQT4X05 Inserting/removing an SD card When using an SD card not from Panasonic, or one previously used on other equipment, for the first time on this unit, format the SD card. (l40) When the SD card is formatted, all of the recorded data is deleted. Once the data is deleted, it cannot be restored. Caution: Check that the status indicator has gone off. 1Open the rear door. Status indicator A ≥When this unit is accessing the SD card or built-in memory, the status indicator lights up red. 1 Unlock...
Page 29
VQT4X05 29 2Insert (remove) the SD card into (from) the card slot. 3Close the rear door. ≥Face the label side A in the direction shown in the illustration and press it straight in as far as it will go. ≥ Press the center of the SD card and then pull it straight out. 1 Close the rear door. 2 Slide the open/close lever. 3 Lock the LOCK lever. ≥ Lock securely to the points where the red portion of the open/close lever and LOCK lever are no longer visible. LOCK SD CARD/ BATTERY ...
Page 30
30 VQT4X05 Open the LCD monitor and press the power button to turn on the unit. The LCD monitor turns on. Preparation Turning the unit on/off To turn off the unitHold down the power button until the LCD monitor goes off. ≥Pressing the power button for a short time sends the unit into Standby Mode. HX-WA30&WA3&WA03_PP&PU-VQT4X05_mst.book 30 ページ 2013年1月16日 水曜日 午後5時29分