Panasonic Hx Dc3 Bacis Owners Manual

 VQT4U69 11
∫
About batteries that you can use with this unit
Inserting/removing the battery
≥Press the power button to turn off the unit. ( l18)
1Open the battery/card cover.
Preparation
Power supply
The battery that can be used with this unit is VW-VBX070.
It has been found that counterfeit battery packs which look very 
similar to the genuine product are made available to purchase in 
some markets. Some of these battery packs are not adequately 
protected with internal protection to meet the...

12 VQT4U69
2Insert the battery, taking care to match up the terminal markings.
Aterminal markings
≥ Insert the battery so that the terminal markings face up. It is possible to 
mistakenly insert the battery upside down, so be sure to check the 
orientation carefully.
3Close the battery/card cover.
≥Securely close it until it clicks.
Removing the batteryPress and hold down the power button to turn off the unit, then pull up and 
remove the battery.
≥Always check that the LCD monitor and status indicator...

 VQT4U69 13
Charging the battery
The unit is in the standby condition when the AC adaptor is connected. 
The primary circuit is always “live” as long as the AC adaptor is 
connected to an electrical outlet.
Important:
≥The AC adaptor and USB cable are for use with this unit only. Do 
not use them with other equipment. Similarly, do not use AC 
adaptors and USB cables from other equipment with this unit.
≥ The battery is charged while the unit is off or in the Standby Mode.
The battery cannot be charged...

14 VQT4U69
1Connect the USB cable to the AC adaptor.
≥Check that the plug portion of the AC adaptor is not misaligned.
2Connect the AC adaptor into the AC outlet.
3Connect the USB cable to the unit.
≥Connecting the USB cable in the wrong direction may cause damage to 
the USB/AV terminal of the unit. If the terminal has become damaged, it 
may not operate correctly, including failure to recognize the cable even if it 
has been connected.
≥The status indicator flashes red with a period of approximately 2...

 VQT4U69 15
Charging and recording time
∫Charging/Recording time
≥Temperature: 25oC (77 oF)/humidity: 60%RH (When using AC adaptor)
≥These times are approximations.
≥The indicated charging time is for when the battery has been 
discharged completely. Charging time and recordable time vary 
depending on the usage conditions such as high/low temperature.
≥ The actual recordable time refers to the recordable time when 
repeatedly starting/stopping recording, turning the unit on/off, moving 
the zoom lever...

16 VQT4U69
The unit can record motion pictures, still pictures or audio to an SD card 
or built-in memory. To record to an SD card, read the following.
Cards that you can use with this unit
Use SD cards conforming to Class 4 or higher of the SD Speed 
Class Rating for motion picture recording.
≥Keep the Memory Card out of reach of children to prevent swallowing.
Inserting/removing an SD card
When using an SD card not from Panasonic, or one previously used on 
other equipment, for the first time on this...

 VQT4U69 17
2Insert (remove) the SD card into (from) the card slot.
≥Face the label side B  in the direction shown in the illustration and 
press it straight in as far as it will go.
≥ Press the center of the SD card and then pull it straight out.
3Close the battery/card cover.
≥Securely close it until it clicks.

HX-DC3PP&PU-VQT4U69_mst.book  17 ページ  ２０１２年１２月１０日　月曜日　午前１０時７分 

18 VQT4U69
Open the LCD monitor and press the power button to 
turn on the unit.
The LCD monitor turns on.
If the screen to set the date and time appears when you turn on the unit, 
skip to step 2 and follow the steps to set the date and time.
1Select the menu. (l25)
2Select an item ([DATE]/[TIME]/[DISP]) using the SET 
button and then tilt the SET button to the right or 
press the SET button.
Preparation
Turning the unit on/off
Preparation
Setting date and time
[MENU]:   # [CLOCK SET]
To turn off the...

 VQT4U69 19
3(When [DATE] or [TIME] is selected)
Tilt the SET button to the left or right to select the 
desired item and then up and down to set the 
numerical values.
e.g.: When [DATE] is selected
≥The year can be set between 2000 and 2039.
(When [DISP] is selected)
Select the date format display method using the SET 
button.
4Press the SET button.
5Select [SAVE DATE AND TIME] using the SET button 
and then press the SET button.
≥To return to the recording screen or playback screen, press the MENU...

20 VQT4U69
≥Before turning on the unit, remove the lens cap.
≥Motion pictures are recorded to the SD card if one is inserted. If no SD 
card is inserted, the motion pictures are recorded to the built-in memory.
1Open the LCD monitor.
2Press the REC/  button to change to recording 
mode.
3Press the recording start/stop button to start 
recording.
A When you begin recording,  ¥ appears.
4Press the recording start/stop button again to pause 
recording.
Basic
Recording motion pictures
000:00:00 000:00:00...