Panasonic Household Massage Lounger Epma73 Operating Instructions

EN12
Part names and functions (Continued)
Controller
111On/Off buttonSpeaker
MANUAL selection button ▶ See page EN34
Air massage intensity controller ▶ See page EN25
Voice guidance volume controller ▶ See page EN51
STRETCH selection On/Off buttons ▶See page EN38
● “Neck” , “chest” , “hip” , “leg”  stretch.
4
14
OTTOMAN/CHAIR controllers ▶ See page EN43 OK button
212USER buttons 
▶See pages EN30-31Back massage intensity controller ▶ See page EN25
313Quick stop button
● Press this button to stop the...

EN13
Before Use
Display
1
139
2
1
13
Massage area display
“Foot Heat” display ▶See page EN29
Operation display
● Currently performing massage actions light 
up while massaging.
● Currently selected action’ s frame is flashed 
when manual operation is selected.
Body scanning display  ▶ See page EN26
Repeat display  ▶See page EN28
3Remaining time display
2Stretch action display ▶ See page EN38
12Air intensity display ▶ See page EN28
5
7
10
11
8
4
6
Back intensity display ▶ See page EN29
Massage ending...

EN14
1
Where to use the unit
● Ensure there is adequate space to recline. 
●  Do not expose the massage lounger to direct sunlight or high temperatures, such as in front of 
heating sources, because this can cause discoloration or hardening of the synthetic leather.
●   Place the unit on a mat to prevent floor damage. When placing a mat under the unit, the size of 
the mat should be sufficient (at least 120 c m × 70 cm (47.2 in. 

× 27.6 in.)) to cover the areas 
where the unit touches and where the leg...

Before Use
EN15
3
Removing everything from the box and installing the unit
Unit weight Approx. 85 kg (187.2 lbs)
● Since the unit is very heavy , be careful to avoid back injuries. (The unit must 
be carried by two or more persons.)
●  Put the unit down slowly watching 
your step carefully.
●  Put down the leg rest by holding it 
with your hands until it has been 
set on the floor completely. If you 
release your hands before the leg 
rest is fully extended, the leg rest 
will forcefu lly return
 to the...

EN16
Assembly
1
2
Attaching the controller stand to the right or left side panel of this unit
Fasten the armrest with the attachment screws. (On both the right and left sides)
Fasten the controller stand with the 
attachment screws. (4 positions)
Use this screw …  Attachment screws (M6 × 13)　 × 4 pcs. (Black)
Insert the armrest into the unit.
Ô “R”  (right side) and  “L” (left side) are indicated 
at the bottom of the armr est.
Ô

  Insert the armrest from the top aligning the ▲ 
marks on the side of...

Before Use
EN17
3
Connect the air plugs
① Press air plugs into the air plug sockets below the armrest until you hear a click.
・Arm massage will not operate unless the air plugs are inserted securely.
②Follow the same step when connecting to the armrest on the left side.
Protrusion Air plug jack
Air plug
View from bottom
Press until the protrusion clicks 
into place.
4
Connect the power cord to the unit
Front
GROUNDING INSTRUCTIONS
● 
The unit must be properly grounded. If it should malfunction or break...

EN18
Assembly 
（Continued）
5
Turn on the power and raise the backrest to the upright position.
Insert the power plug into the 
power outlet.
●  Always be sure to insert into an AC 
120 V plug. 
Fasten the controller 
cord using the clip.
● Fasten so the cable under 
the clip will not sag too 
much with the backrest 
raised. 
(Because there is a 
chance of the cord 
becoming tangled with 
your feet, etc.)
Placing the controller 
into the cont ro
ller 
stand. Confirm the lock switch key 
is set to the  ...

Before Use
EN19
Fasten the pillow using 
the fasteners.
● 
See page EN23 for guidelines 
on positioning the pillow 
during the massage.
Fasten the comfort cushion using 
the zipper.Fasten the pillow using 
the fasteners.
● See page EN23 for guidelines 
● ❶Fasten the comfort cushion using 
the zipper.●
❷
7
Pillow
Fasteners Fasteners Zipper
Comfort cushion
Fasten to the right sideLeg rest
View from 
front
Fastening band TabController cord Controller cord
Cord-holder groove
③
③
④②
● ⑤
●
⑥
When the...

EN20
Check the surrounding area.
Before sitting down
1
Make sure there are no 
objects, people, or pets in 
the vicinity of the unit.
2
Flip up the comfort cushion and deploy the leg & sole 
massage section.
Comfort cushion
Press 
firmly.
● Do not massage with the 
comfort cushion still on the 
backrest.
How to deploy the leg & sole massage section
● ① While raising the 
leg rest rotation lock 
release lever in the 
direction of the arrow.
●● ②  Rotate from bottom.
●
③  Rotate until it stops 
rotating.
●...

Before Use
lock switchonoff
lock
open
power
EN21
Be careful not to trip 
over the power cord.
Be sure to push the connector all 
the way into the appliance inlet.
4
Switching on the power supply
3
Check the power cord and the power plug.
Insert the power plug into an electrical outlet.
Turn the lock switch key to the 
 open ¡ position.
Slide the power switch to the   on¡ position.
Insert the power plug into an electrical outlet.
Turn the lock switch key to the  open¡ position.
● ❶
Turn the lock...