Panasonic Expandable Digital Cordless Handset Kx-tga820 Installation Manual

Thank you for purchasing a Panasonic cordless telephone.
Please read this Installation Manual before using the unit and 
save it for future reference.
For assistance, visit our website:
http://www.panasonic.com/help for 
customers in the U.S.A. or Puerto 
Rico.This unit is an additional handset for use with Panasonic 
Digital Cordless Phones: 
KX-TG8231/KX-TG8232
You must register this handset with your base unit before it can 
be used. This installation manual describes only the steps 
needed to...

2For assistance, please visit http://www.panasonic.com/help
Supplied accessories
*1 The handset cover comes attached to the handset.
Note:
LPlease read the base unit’s operating instructions for additional/
replacement accessories.
Sales and support information
LTo order additional/replacement accessories, call 1-800-332-5368.
LTTY users (hearing or speech impaired users) can call 1-866-605-
1277.
Connection
Note:
LUse only the supplied Panasonic AC adaptor PQLV209.
LThe AC adaptor must remain connected...

For assistance, please visit http://www.panasonic.com/help3
Battery installation/Battery charge
Important:
LUse only the supplied rechargeable batteries noted on page 2, 6.
LUSE ONLY rechargeable Ni-MH batteries AAA (R03) size.
LDo NOT use Alkaline/Manganese/Ni-Cd batteries.
LEnsure correct polarities (S, T) when installing the batteries.
LWipe the battery ends (S, T) with a dry cloth.
LWhen installing the batteries, avoid touching the battery ends (S, T) 
or the unit contacts.
1Press the notch on the...

4For assistance, please visit http://www.panasonic.com/help
Attention:
Register the handset to the KX-TG8231/KX-TG8232 
base unit
1
Lift the handset and press {OFF}. Place the handset on the base unit.
LContinue the operation even when the handset display shows 
“Registering”.
2Press and hold {x} (LOCATOR) on the base unit for about 5 
seconds, until the registration tone sounds.
LIf all registered handsets start ringing, press {x} (LOCATOR) to 
stop, then repeat this step.
3With the handset still on the...

For assistance, please visit http://www.panasonic.com/help5
Belt clip
You can hang the handset on your belt or pocket using the supplied belt 
clip.
NTo attach the belt clipNTo remove the belt clip
TGA820(e).fm  Page 5  Thursday, June 28, 2007  5:07 PM 

6For assistance, please visit http://www.panasonic.com/help
Important safety instructions
WARNING:
LTo prevent the risk of fire or electrical shock, do not expose the product 
to rain or any type of moisture.
LUnplug the product from power outlets if it emits smoke, an abnormal 
smell, or makes an unusual noise. These conditions can cause fire or 
electric shock. Confirm that smoke has stopped emitting and contact 
the Panasonic Call Center at 1-800-211-PANA (1-800-211-7262).
LDo not place or use this...

For assistance, please visit http://www.panasonic.com/help7
LDo not mix old and new batteries.
LDo not dispose of the battery(ies) in a fire, as they may explode. Check 
with local waste management codes for special disposal instructions.
LDo not open or mutilate the battery(ies). Released electrolyte is 
corrosive and may cause burns or injury to the eyes or skin. The 
electrolyte may be toxic if swallowed.
LExercise care when handling the battery(ies). Do not allow conductive 
materials such as rings,...

8For assistance, please visit http://www.panasonic.com/help
external RF (radio frequency) energy. If noise occurs, use an optional 
headset accessory or the speakerphone option (if applicable) when 
using this phone. Consult with your audiologist or Hearing Aid 
manufacturer about the availability of Hearing Aids which provide 
adequate shielding to RF energy commonly emitted by digital devices.
WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING 
TEST CALLS TO EMERGENCY NUMBERS:
1) Remain on the line and...

For assistance, please visit http://www.panasonic.com/help9
to try to correct the interference by one or more of the following 
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC RF Exposure Warning:
LThis product complies with FCC radiation exposure limits...

10For assistance, please visit http://www.panasonic.com/help
Notes
TGA820(e).fm  Page 10  Thursday, June 28, 2007  5:07 PM