Panasonic Dvd Vcr Deck Pv D734 Operating Instructions

11
Inserting Batteries
123
Remote control operations
¥ Aim the remote control at the remote sensor and press control buttons
to operate.
¥ Operate the remote control within 30° angle on either side of the remote
sensor, up to a distance of Approx. 5 meters.
Replace the compartment
cover.Install two ÒAAAÓ batteries paying
attention to the polarity diagram in
the battery compartment. Open the battery compartment
cover.
Approx. 5 meters
(15 FEET)
Battery precautions
The precautions below should be followed...

12
OUT(TV) IN
(ANT)
OUT (TV) IN
(ANT)
OUT (TV) IN
(ANT)
NOTES: ¥ A clear picture will not be obtained by the DVD/VCR unless the antenna s\
ignal is good. Connect the
antenna to the DVD/VCR properly.
¥ For better quality recording, an indoor antenna or a telescopic antenna \
is not recommended. The use of
an outdoor type antenna is required.
¥ If you are not sure about the connection, please refer to qualified serv\
ice personnel.
If you are using an antenna system, follow these instructions. If you ar\
e...

13
UHF
VHF
UHF
VHF
VHF/UHF IN
NOTE: If a VHF or UHF antenna is
used, set the TV/CATV
menu option to the ÒTVÓ
mode.
NOTE: If a VHF or UHF antenna is
used, set the TV/CATV
menu option to the ÒTVÓ
mode.
NOTE: If a VHF or UHF antenna is
used, set the TV/CATV
menu option to the ÒTVÓ
mode. 75 ohm Coaxial Cable (supplied)
Splitter
75 ohm Input
75/300 ohm outputs
(not supplied)
Splitter
75 ohm Input
300 ohm outputs
(not supplied)TV with single 75 ohm VHF/UHF
antenna input
TV with 300 ohm UHFand 75 ohm VHF...

14
VHF/UHF
IN (ANT)
OUT
(TV)IN
(ANT)
VHF/UHF
IN (ANT)
OUT
(TV)IN
(ANT)
VHF/UHF
IN (ANT)
OUT
(TV)IN
(ANT)
Many cable companies offer services permitting reception of extra channels including pay or subscription channels.
This DVD/VCR has an extended tuning range and can be tuned to most cable channels without using a cable
company supplied converter box, except for those channels which are intentionally scrambled. If you subscribe to
a special channel which is scrambled, you must have a descrambler box...

15
VHF/UHF
IN (ANT)
A
B
OUT
(TV)IN
(ANT)
VHF/UHF
IN (ANT)
A
B
OUT
(TV)IN
(ANT)
This DVD/VCR cannot receive scrambled programs since it does not contain a descrambler. In order to receive scrambled
programs, your existing descrambler must be used. Descrambler boxes are available from cable companies. Consult
your local cable company for more information concerning connection to their descrambler equipment. There are many
ways to connect your DVD/VCR to a cable system. Below are six common methods of...

16
To Audio (R) Input
To Audio (L) Input To Video
Input Audio (L) Output
Audio (R) OutputVideo Output
DVD/VCRTV
AUDIO/VIDEO cable (not supplied)
Connect to a TV with Audio/Video Output
You can enjoy playback by connecting the unit to a TV.Connect the unit to a TV equipped with audio input (L/R) and video input jacks using the audio/video cable (not supplied).
Connect to a TV with S-Video Output (for DVD playback)
If your TV has an S-VIDEO input, you can get higher quality by connecting it with the...

17
Connect to an AV Amplifier with built-in digital surround
If you are using an Amplifier with a built-in digital surround as follows, you can enjoy the various audio systems
such as Dolby Digital and DTS by using the Optical or Coaxial Digital Output.
Use this connection to connect an:
¥ AV amplifier with built-in *Dolby Digital decoder
¥ AV amplifier with built-in *DTS decoder
Connect to a Stereo Amplifier with Audio Output
You can enjoy high quality audio by connecting the audio output to your...

18
Auto clock setting
The Auto Clock feature enables the automatic clock setting and updating, and also to set the Time Zone
and Daylight Saving Time by receiving XDS (Extended Data Service) information carried on the channel
signal.
Press VCR MENU. The VCR menu screen will appear.
Press SET + or Ð to select the ÒSYSTEM SETUPÓ menu, then
press ENTER.
2Press SET + or Ð to select the
ÒSTANDARD TIMEÓ option, then
press ENTER.
You must set the antenna connection before the AC cord plug is
inserted into the...

19
Daylight Saving Time setting
Repeat the step 1 on page 18 and
press SET + or Ð to select
ÒDAYLIGHT SAVING TIMEÓ option,
then press  ENTER.1
2
Press SET + or Ð to select ÒONÓ
or ÒOFFÓ, then press ENTER. You can set the Daylight Saving Time ÒONÓ or ÒOFFÓ.
Preparation:
¥Turn ON the TV and set to the video input mode.
¥Press VCR/DVD to select the VCR mode. (The VCR indicator
will light.)
When you want to set the Daylight Saving Time, on the first
Sunday in April you set to ÒONÓ, and on the last Sunday in...

20
4
Manual clock setting
You must set the date and time for
timer recordings and Daylight
Saving Time if the Auto Clock
process did not set them correctly.
Press SET + or Ð to set the
month, then press ENTER.
2
3
Press SET + or Ð to select the
ÒCLOCK SETÓ option, then press
ENTER.
After a power failure or disconnection
of the power, the timer settings will be
lost. In this case, reset the present time. NOTE:
1Press VCR MENU. The VCR menu screen will appear.
5Set the day, year and time as in
step 4....