Panasonic Dmc Fx01 Operating Instructions Manual

Preparation
11VQT0V86
Quick Guide
This is an overview of how to record and 
playback pictures with the camera. For 
each step, be sure to refer to the pages 
indicated in brackets.
1Charge the battery. (P12)
 The battery is not charged when the 
camera is shipped. Charge the 
battery before use.
2Insert the battery and the card. 
(P13, 14)
3Turn the camera on to take 
pictures.
 Set the clock. (P16)
1Set the mode dial to [ ].2Press the shutter button to take 
pictures. (P22)
4Play back the pictures....

Preparation
12VQT0V86
Charging the Battery 
with the Charger
The battery is not charged when the 
camera is shipped. Charge the battery 
before use.
1Attach the battery with attention 
to the direction of the battery.
2Connect the charger to the 
electrical outlet.
 Charging starts when the [CHARGE] 
indicator A lights green.
 Charging is complete when the 
[CHARGE] indicator A turns off (after 
about 130 minutes).
3Detach the battery after charging 
is complete.
 After charging is completed, be sure...

Preparation
13VQT0V86
Recording once every 30 seconds with 
full flash every second recording.
 Rotating the zoom lever from Tele to Wide 
or vice versa in every recording.
 Turn the camera off every 10 recordings.
 CIPA is an abbreviation of 
[Camera & Imaging Products 
Association].
¢The number of recordable pictures 
decreases when the power LCD function 
or high angle function (P35) are used.
Playback time
The number of recordable pictures and playback 
time will vary depending on the operating...

Preparation
14VQT0V86
2Insert:
Insert the charged battery fully 
paying attention to its direction.
Remove:
Slide the lock A to remove the 
battery.
31Close the card/battery door.
2Slide the release lever in the 
direction of the arrow.
 Remove the battery after use. Store the 
removed battery in the battery carrying 
case (supplied).
 When a fully charged battery has been 
inserted for more than 24 hours, the clock 
setting is stored (in the camera) for at 
least 3 months even if the battery is...

Preparation
15VQT0V86
2Insert:
Insert the card fully until it clicks 
and it is locked.
Remove:
Push the card until it clicks, then 
pull the card out upright.
 Check the direction of the card.
 Do not touch the connection terminals 
on the back side of the card.
 The card may be damaged if it is not 
fully inserted.
31Close the card/battery door.
2Slide the release lever in the 
direction of the arrow.
 If the card/battery door cannot be 
completely closed, remove the card and 
insert it again.
...

Preparation
16VQT0V86
SD Memory Card 
 On this unit, you can use SD Memory 
Cards of the following capacity (from 8 MB 
to 2 GB).
Please confirm the latest information on the 
following website.
http://panasonic.
co.jp/pavc/global/cs
(This Site is English only.)
 Refer to P99 for information about the 
number of recordable pictures and the 
available recording time for each SD 
Memory Card.
 This unit supports SD Memory Cards 
formatted in FAT12 system and FAT16 
system based on SD Memory Card...

Preparation
17VQT0V86
 Turn the camera off after finishing 
setting the clock. Then turn it on and 
check that the clock setting is correct.
∫Changing the clock setting
1Press [MENU/SET] to display the menu 
and then press 2.
2Press 4 to select the [SETUP] menu 
icon [ ] and then press 1.
3Press 34 to select [CLOCK SET] and 
then press 1. Set as shown previously.
 When a fully charged battery has been 
inserted for more than 24 hours, the clock 
setting is stored (in the camera) for at 
least 3 months...

Preparation
18VQT0V86
4Press 1, press 34 to select the 
setting and then press [MENU/
SET].
5Press [MENU/SET] to close the 
menu.
 You can also press the shutter 
button halfway to close the menu.
∫About the menu screen items
 There are 4 menu screens (1/4, 2/4, 3/4 
and 4/4).
 You can switch menu screens from any 
menu item by rotating the zoom lever.
[CLOCK SET]
Press [ ] to display the [SETUP] menu 
and select the item to set. (P17)
Change date and time. (P16)
[MONITOR]
Press [ ] to display the...

Preparation
19VQT0V86
[LEVEL 1]:The LCD monitor turns off if the 
camera is not operated for 
about 15 seconds in recording 
mode.
[LEVEL 2]:The LCD monitor turns off if the 
camera is not operated for 
about 15 seconds in recording 
mode or for about 5 seconds 
after taking a picture.
[OFF]:Economy mode cannot be 
activated.
 In economy mode, the LCD monitor is 
turned off while the flash is being charged.
 The status indicator lights while the LCD 
monitor is turned off. Press any button to 
turn on...

Preparation
20VQT0V86
[SHUTTER]
Press [ ] to display the [SETUP] menu 
and select the item to set. (P17)
Set to select the volume of shutter sound.
[SHUTTER VOL.]
[]:No shutter sound
[]:Soft shutter sound
[]:Loud shutter sound
[SHUTTER TONE]: / /
 The [SHUTTER] setting also affects 
simple mode [ ].
[VOLUME]
Press [ ] to display the [SETUP] menu 
and select the item to set. (P17)
The volume of speakers can be adjusted in 
7 steps from level 6 to 0.
 When you connect the camera to a TV, the 
volume of...