Panasonic Digital Camera Dmc Ts1 Operating Instructions
Here you can view all the pages of manual Panasonic Digital Camera Dmc Ts1 Operating Instructions. The Panasonic manuals for Digital Camera are available online for free. You can easily download all the documents as PDF.
Page 131
131VQT1Z45 Others If a name or birthday is set for [BABY1]/[BABY2]/face recognition function, this personal information is kept in the camera and included in the recorded image. Disclaimer • Information including personal information may be altered or vanish due to erroneous operation, effect of static electricity, accident, malfunction, repair, or other handlings. Please note in advance that Panasonic is not liable in any way for any direct or indirect damage from the alteration or vanishing of...
Page 132
VQT1Z45132 Others Message Display Confirmation messages or error messages will be displayed on the screen in some cases. The major messages are described below as examples. [THIS MEMORY CARD IS LOCKED] >The Write-Protect switch on the SD Memory Card and the SDHC Memory Card are moved to [LOCK]. Move the switch back to unlock it. (P21) [NO VALID PICTURE TO PLAY] >Record a picture or insert a card with a recorded picture and then play it. [THIS PICTURE IS PROTECTED] >Delete the picture after canceling the...
Page 133
133VQT1Z45 Others [MEMORY CARD ERROR FORMAT THIS CARD?] • This card has a format which is not recognized by the camera.> Format the card again with the camera after saving necessary data on a PC etc. (P32) [PLEASE TURN CAMERA OFF AND THEN ON AGAIN]/[SYSTEM ERROR] • This message will be displayed if the lens did not operate properly. > Turn the camera off and on. If the message persists, contact the dealer or your nearest Service Center. [MEMORY CARD PARAMETER ERROR] >Use a card compatible with this...
Page 134
VQT1Z45134 Others [PRINTER BUSY]/[PLEASE CHECK THE PRINTER] • The printer cannot print.> Check the printer. [NO BATTERY POWER REMAINS] • The remaining battery power is low. > Charge the battery. [THIS BATTERY CANNOT BE USED] • The battery cannot be recognized by the camera. > Use a genuine Panasonic battery. If this message is displayed even when a genuine Panasonic battery is used, contact the dealer or your nearest Service Center. •The battery cannot be recognized as its terminal is dirty. > Remove...
Page 135
135VQT1Z45 Others Troubleshooting First, try out the following procedures (P135–142). • The battery is not inserted correctly. (P19)•The battery is exhausted.•Keep the ON/OFF button pressed until the status indicator is turned on. •Is [AUTO LCD OFF] (P29) of the [ECONOMY] mode active?> Press the shutter button halfway to cancel these modes. •The battery is exhausted. •The battery is exhausted.•If you leave the camera on, the battery will be exhausted. > Turn the camera off frequently by using the...
Page 136
VQT1Z45136 Others •Was this picture taken with the flash at the close range when the zoom is near [W] (1k)? > Zoom in a little, and then take the pictures. (P41) •Is this a picture taken in [PIN HOLE] in scene mode? > Check that the exposure is correctly compensated. (P55) •Setting the [MIN. SHTR SPEED] to faster speed might make the picture darker. > Set the [MIN. SHTR SPEED] (P90) to slower speed. > Set auto bracket (P56), [HI-SPEED BURST] (P64), [FLASH BURST] (P64) in Scene mode or [BURST] (P88) of...
Page 137
137VQT1Z45 Others •It is recommended to use a card with SD Speed Class¢ with “Class 6” or higher when recording motion pictures. ¢ SD speed class is the speed standard regarding continuous writing. •Depending on the type of the card, recording may stop in the middle. > When you set the picture quality to [ ], [ ] or [ ], we recommend using a high-speed card with “10MB/s” or greater displayed on the package. > In the event that it stops even after using a “10MB/s” card or higher, the data writing speed...
Page 138
VQT1Z45138 Others •The LCD monitor may flicker for a few seconds after turning the camera on indoors under fluorescent light. This is not a malfunction.> Adjust the brightness of the screen. (P27) •[POWER LCD] is activated. (P28) •This is not a malfunction. These pixels do not affect the recorded pictures. •In dark places, noise may appear to maintain the brightness of the LCD monitor. This does not affect the pictures you are recording. •Is the flash setting set to [ Œ]? > Change the flash setting....
Page 139
139VQT1Z45 Others •Is this a non-standard picture, a picture which has been edited using a PC or a picture which was taken by another make of digital camera? •Did you remove the battery immediately after picture-taking or did you take the picture using a battery with a low remaining charge? > Format the data to delete the pictures mentioned above. (P32) (Other pictures will be deleted as well and it will not be possible to restore them. Therefore, check well before formatting.) • Is the clock in the...
Page 140
VQT1Z45140 Others •Depending on the TV model, the pictures may be extended horizontally or vertically or they may be displayed with their edges cut off. •Are you trying to play back the motion pictures by directly inserting the card in the card slot of the TV?> Connect the camera to the TV with the AV cable (supplied), or with the HDMI mini cable (optional), and then play back the motion pictures on the camera. (P112, 113) > Motion pictures recorded in [AVCHD Lite] can be played back on Panasonic...