Panasonic Cordless Handset Kx-tga400b Operating Instructions

							– 11–
Base unit:
1. Press 
(FUNCTION).
2. Select “Registration” by
pressing  or  , and press H.
3. Select “Deregistration” by
pressing  or  , and press H.
4. Press Hor Ito move the cursor
to the handset number to be
canceled.
5. Press 
(ENTER).
6. Press 
(CLEAR), and press (EXIT).
Canceling Handset Registration
Make sure that the base unit and cordless handset are in the standby mode. 
Cordless handset:
1. Press 
(FUNCTION).
2. Select “Registration” by
pressing  or  , and press H.
3. Select “Deregistration” by
pressing  or  , and press H.
4. Press 
(CLEAR), and press (EXIT).
•[–] is displayed.
Using an Optional Headset
Plugging an optional headset into the cordless handset allows a hands-free
phone conversation. Please use only the Panasonic KX-TCA88 headset.
To order, call the accessories telephone number on page 1. 
Connecting the headset to the cordless handset
Open the headset jack cover, and connect the headset to the headset jack
as shown.
Headset Jack
When the headset is
connected, make sure
to use the headset to
talk with the caller. If
you want to have a
normal cordless
phone conversation,
disconnect the
headset.
Wall Mounting
The charger can be wall
mounted.
Install screws using the
wall template on the right.
Connect the AC adaptor.
Mount the charger, then
slide it down.
 3 cm 
(13 16˝ )
 3 cm 
(13 16˝ )
To Power
Outlet Screws
Wall 
Template 
						

							– 12–
CAUTION:
To reduce the risk of fire or injury to persons, read and follow these instructions.
1. Use only the battery(ies) specified.
2. Do not dispose of the battery(ies) in a fire. They may explode. Check with local
waste management codes for special disposal instructions.
3. Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may
cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.
4. Exercise care in handling batteries in order not to short the battery to conductive
materials such as rings, bracelets, and keys. The battery and/or conductor may
overheat and cause burns.
5. Charge the battery(ies) provided with or identified for use with this product only in
accordance with the instructions and limitations specified in this manual.
1Remove the cover by sliding
while pressing the arrow.
2Replace the battery, and close
the cover. Be sure to charge the
new battery for about 8 hours.
•After replacing the battery or re-connecting the battery plug, 
be sure to place the handset on the charger until a confirmation 
tone sounds or the battery strength prompt displays.
•
The handset battery is a Nickel-Metal Hydride battery. You cannot recycle this
battery.
Using the Belt Clip
You can hang the cordless handset on your belt or pocket using
the belt clip.
To attach the belt clip To remove the belt clip
Battery Replacement
If “Recharge” is displayed and/or “” flashes on the display after being
fully charged, replace the battery with a new Panasonic 
HHR-P506 (PQHHR150AA21) battery. To order, call the accessories
telephone number on page 1.  
						

							WARNING:
TO PREVENT FIRE OF SHOCK HAZARD, DO NOT EXPOSE THIS
PRODUCT TO RAIN OR ANY TYPE OF MOISTURE.
FCC and Other Information
When programming emergency numbers and/or making test calls to emergency
numbers:
1. Remain on the line and briefly explain to the dispatcher the reason for the call
before hanging up.
2. Perform such activities in the off-peak hours, such as early morning hours or late
evenings.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Privacy of communications may not be ensured when using this phone.
CAUTION:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this device.
Note:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: 
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Panasonic Consumer Electronics Company,
Division of Matsushita Electric Corporation of America
One Panasonic Way, Secaucus, New Jersey 07094
Panasonic Sales Company,
Division of Matsushita Electric of Puerto Rico, Inc.
Ave. 65 de Infantería, Km. 9.5, San Gabriel Industrial Park
Carolina, Puerto Rico 00985
Panasonic World Wide Web address:  http://www.panasonic.com
Panasonic’s e-mail address for customer inquiries:
[email protected]