Panasonic Cd Player Weather Band Receiver Cq 5101u Operating Instructions

							CQ-5101U11
Radio
Radio Mode
Press [MODE]to change to the radio mode.
Band
Press [BAND]to change the band.
Seek Tuning
Hold down for more than 0.5 seconds and release it.
[}TUNE]: Higher frequency
[{TUNE]: Lower frequency
T uning will automatically stop when the next broadcast
station is received. FM stereo indicator, lights while receiving an FM stereo signal.
w
Manual Tuning
[}TUNE]: Higher frequency
[{TUNE]: Lower frequency
e
( When a CD disc is loaded.)
Radio
aCD PlayeraAUX Mode
c
FM1FM2
AM162
(Weather Band)
q
Band
Frequency
$26RYE
 
 
 


 .
 
 
						

							CQ-5101U12
Radio (Continued)
Preset buttons from [1]to [6]
Preset Station Setting
Up to 6 stations can be saved in each of the FM1, FM2
and AM preset station memories.
Note:Existing saved stations are overwritten with new
stations after following this procedure.
blinks once
Band
Press [BAND](APM)to select a desired band. 
(
➡page 11)
Auto Preset Memory (APM)
Hold down [BAND](APM: auto preset memory) for more than
2 seconds.
•  The 6 stations with good reception will be automatically
saved in the memory under preset buttons from 
[1]to [6].
• Once set, the preset stations are sequentially scanned for 5 seconds each.
• To stop scanning, press one of the buttons from  
[1] to [6] .
Manual Preset Memory
qUse manual or seek tuning to find a station. (➡page 11)
wHold down one of the preset buttons from [1]to [6]until
the display blinks once.
Preset Station Calling
Press the corresponding preset button from [1]
to [6]to tune in a preset station.
q
w
Caution
To   ensure safety, never attempt
to preset stations while you are
driving.
Preset Number
$26RYE
 
 
 
 
 .
 
 
						

							CQ-5101U13
Tuning in a Weather Band Station
• Press [BAND](APM)to select WB (Weather Band). (apage 11)
• Press any of the buttons 
[1]to [6]to monitor the preset station.
Weather Band Stations
National Weather Radio Broadcasts from over 380 Iocations throughout the
U.S. on seven VHF/FM frequencies.
T une to weather band to receive continuous weather information 24 hours
a day on one of the following frequencies.
1. 162.550 MHz
2. 162.400 MHz
3. 162.475 MHz
4. 162.425 MHz
5. 162.450 MHz
6. 162.500 MHz
7. 162.525 MHz
Occasionally the frequency of an existing or planned station must be
changed because of unexpected radio frequency interfere with adjacent
NOAA weather Radio Stations and/or with other Government or
commercial Operations within the area. If you have a question concerning
NOAA Weather Radio, please contact your nearest National Weather
Service Office.
Note:The weather band (CH1-6) has been preset. CH7 is selected by
pressing 
[}]or [{].
WB Weather Band Frequency (channel) Number
Warning
Any NOAA broadcast weather report, including current and forecasts,
may not reflect your actual weather conditions at your exact time and
location. You should always pay attention to your actual weather
conditions to make safe decisions accordingly.
CH7
Selection
$26RYE
 
 
 
 
 .
 
 
						

							CQ-5101U14
CD Player
Disc Insert and Playback
Disc insert
Playback will start automatically after the player recognized
the loaded disc as an ordinary music CD. (When a CD-R or
CD-RW which has CD-DA* formatted data as the same as an
ordinary music CD is loaded, this player recognizes it as an
ordinary music CD.)
*CD-DA: A general music CD format.
“LOAd” will be displayed until the disc is loaded.
Notes:
•Do not insert a disc when “DISC” indicator lights.
• The power will be turned on automatically when a disc is loaded.
Stop and Disc Eject
Press [u](eject) to stop CD play and eject the disc.
During disc ejection, “EJ” will be displayed.
Listening to a CD
Press [MODE](POWER)to change to the CD player mode.
Playback will start automatically when a disc is loaded.
Radio CD playerAUX Mode
Label Side
( When a CD disc is loaded.)
Display change
Press [DISP]to change the display.
CD mode display (default) Clock displayRandom/Repeat indicator
DISC indicator
Play time
Current Track
$26RYE
 
 
 

 .
 
 
						

							CQ-5101U15
Track Search
Hold down...
[dTUNE]: Fast forward
[sTUNE]: Fast reverse
Release to resume the regular play.
Pause
• Press [BAND] (h/5).
• Press again to cancel.
Track Selection
Press [dTUNE]: Advance to the next track.
Press 
[sTUNE]: Back to the beginning of the current track.
Back to the previous track. (Press
twice.)
Repeat play
• Press [5] (REPEAT).
The current track is repeated.
• Press 
[5] (REPEAT)again to cancel.
Random play
• Press [6] (RANDOM).
All the tracks are played in random order.
• Press 
[6] (RANDOM)again to cancel.
Scan play
• Press [4] (SCAN).
The first 10 seconds of each track on the 
disc are played in sequence.
• Press 
[4] (SCAN)again to cancel.
Caution
•Only 12 cm {5} CD, CD-DA data recorded CD-R and CD-RW discs are availab\
le for this unit.
• This unit does not support CD text display.
•
This unit does not support MP3 and WMA disc playback.
• Refer to page 21 about notes on CD-R/RW.
• This unit is not designed for any 8 cm {3} disc.
• Do not use irregular shaped discs.
• Do not use discs that have a seal or label attached.
• Do not insert foreign matter into the disc slot.
lights
lights
blinks
$26RYE
 
 
 
 
 .
 
 
						

							CQ-5101U16
AUX (Auxiliary Input Mode)
Connecting with the portable audio player
The AUX input terminal is equipped on the front panel. This jack is used\
 to connect a portable audio device using a
standard mini-plug cable. By connecting a commercially available portable audio device, this unit can play the music
recorded on the device.
The AUX Input Example:
Front AUX IN
(3.5 mm ø stereo)3.5 mm ø stereo mini-plug cable (Option) Stereo line out
(3.5 mm ø)
Silicon audio player,
HDD audio player etc.
(Option)
Caution
• Set the volume level to low enough before the AUX
connection is completed.  Failure to observe this may
cause loud noise and, consequently, damage your
speakers and your hearing.
•  Do not connect this AUX directly with a speaker/
headphone output.  Failure to observe this may
distort sound and break the internal amplifier.
Notes:
• When the high impedance output enuipment such as
old type audio equipment with an output transformer
is connected, sound may be distorted or become
extremely low levels.
• The connected audio equipment should be kept away from the speakers.
• Be sure that your hand does not catch and yank the mini-plug cable.
Wa rning
¡Do not place the connected portable audio device or mini-plug cable in a\
 location where it will prevent the
SRS airbag may not operate correctly or the portable audio device may be\
 catapulted outward by the
deploying airbag, which may result in serious injury or death.
*Refer to the owners manual for your car regarding the deploying positi\
on of the SRS airbag.
¡Please or temporarily fix the portable audio device and mini-plug cable \
where they will not interfere the
driver when driving. Otherwise, they may interfere driving or cause auto accident.
Before Using the Portable Audio Device
Main Unit
CQ-5101U
$26RYE
 
 
 
 
 .
 
 
						

							CQ-5101U17
Listening to the portable audio device
qTurn on the connected portable audio device and play the music.
wPress [MODE](POWER) to change to AUX mode. The sound of the portable audio device \
is output through the
speakers.
Display change
Press [DISP]to change the display.
AUX input mode (default)
Clock display
RadioCD playerAUX Mode
( When a CD disc is loaded.)
“AU In” will be displayed when
switch to the AUX mode.
Notes:
• 
If you disconnect the mini-plug cable and connect it again in AUX mode, \
noise is generated and may cause
speaker damage. Disconnect or connect the mini-plug cable after turning \
the units power off or switching it to
another mode.
• Each device has a different output level. Be sure that the volume is not\
 too high.
• If the input volume of the connected device is high, the distortion may \
result. In such cases, adjust the volume on the connected device.
• For the power source of the portable audio device, use a battery, etc., provided with the device. If the device is powered through a cigarette lighter socket or accessory socket of the car, noise may be generated.
$26RYE
 
 
 
 
 .
 
 
						

							CQ-5101U18
Troubleshooting 
No power.
Tr ouble
Vehicle’s ignition switch is not on.
aTu rn your vehicle’s ignition switch to ACC or ON.
Cables are not correctly connected.
aConnect cables correctly.
Power connector is not correctly connected.
aConnect the power connector to the terminal that is always active.
Power connector is not correctly connected. 
aConnect the power connector to your vehicle’s ACC source.
Grounding wire is not correctly connected. 
aConnect the grounding wire to a metal part of the vehicle.
Mute is set to ON. 
aSet it to OFF.
Cables are not correctly connected. 
aConnect cables correctly.
The ground lead is not connected properly. 
aConnect the ground lead properly.
Check point
Troubleshooting Tips
❐Common
No sound.
Noise.
Warn ing
¡Do not use the unit in an irregular condition,
for example, without sound, or with smoke
or a foul smell, which can cause ignition or
electric shock. Immediately stop using the
unit and consult your dealer.
¡Never try to repair the unit by yourself
because it is dangerous to do so.
If You Suspect Something Wrong
Check and take steps as described below.
If the described suggestions do not solve the problem, it is
recommended to take the unit to your nearest authorized
Panasonic Servicenter. The product should be serviced only by
qualified personnel. Please refer the checking and the repair to
professionals. Panasonic shall not be liable for any accidents
arising out of neglect of checking the unit or your own repair
after your checking.
Never take measures especially for those other than
indicated by 
italicletters in “Check point” described below
because those are too dangerous for users to handle
themselves.
$26RYE
 
 
 
 
 .
 
 
						

							CQ-5101U19
Sound skips due to 
vibration.
Mounting angle is over 30˚.
aAdjust mounting angle to less than 30˚.
Instable mounting.
aMount the unit securely with the mounting parts, referring to the
section on installation.
Much noise in FM stereo
and monaural broad-
casts.
Trouble
Station is too far, or signals are too weak.
aSelect other stations of higher signal level.
The radio antenna is not extended enough.
aExtend fully the radio antenna.
Preset station is reset.Battery cable is not correctly connected.
aConnect the battery cable to the terminal that is always active.
Check point
❐Radio
Disc is in the CD
compartment but no
sound is made, or disc is
ejected automatically.
Trouble
Disc is upside down.
aPlace disc in the correct direction with the label side up.
Sound skips, bad sound
quality. (e.g. caused by
noise)
• Disc is dirty.
• Disc has scratches.
aClean disc, referring to  the section on “Notes on Discs”.
aThe unit may not successfully playback a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive) and a
disc which are incompatible one another. Refer to instructions for the
concerned devices for details.
• Disc is dirty.
• Disc has scratches.
aClean disc, referring to the section on “Notes on Discs”.
A disc that has data other than CD-DA type is loaded.
aDiscs that have CD-DA type data should be used.
aThe unit may not successfully playback a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive) and a
disc which are incompatible one another. Refer to instructions for the
concerned devices for details.
Check point
❐CD
$26RYE
 
 
 
 
 .
 
 
						

							CQ-5101U20
No sound from left, right,
front, or rear speaker.
Trouble
Left and right balance, or front and rear balance is off on one side.
aAdjust BAL/FAD as appropriate.
Left and right sounds are
reversed in stereo
listening.The right speaker wire is connected to the left speaker and the left spe\
aker
wire to the right speaker.
aConnect the speaker wires to the correct ones.
Cables are not correctly connected.
aConnect the cables correctly.
Check point
❐Sound Setting
Disc is not ejected.
Ti me is counted but no
sound comes out.
Tr ouble
• Disc is defective.
• Mechanical trouble.
aPress [u] (eject).  If  nor mal operation is not restored, call the store
where you purchased the unit or the nearest Servicenter to ask for
r epairs.
The first track of a mix mode disc was reproduced. (Mix mode is a forma\
t in
which data except music is recorded on the first track and music data is\
recorded on other than the first track in a session.)
aPlayback music data recorded on other than the first track.
Check point
❐CD (Continued)
Error Display Messages
❐ CD
Disc is dirty, or is upside down.
A disc that has data other than CD-DA type is loaded.
➡Check the disc.
Disc has scratches.
➡Check the disc.
No operation by some cause. 
➡If normal operation is not restored, call the store where you purchased
the unit or the nearest Servicenter to ask for r epairs.
TroubleCheck point
Troubleshooting (Continued)
$26RYE
 
 
 
 
 .