Panasonic Av Control Receiver Sa-xr10 Operating Instructions

11
RQT6501
Use this mode to play digital or analog stereo sources or to play surround sources through two
speakers. When surround sources are played in this mode, the sounds intended for the other
speaker channels are played through the front speakers.
Enjoy an enhanced sound experience with greater presence and spread by using these SFC
(sound field control) modes with PCM or analog stereo sources.
The SFC modes cannot be used if the input signal is Dolby Digital or DTS.
Choose from the following...

12
RQT6501
Control guide
q q
[RECEIVER ^]:Standby/on button !0
w
w
[SOUND MODE]:To select the sound modes !0
e
e
[SFC]:To select SFC modes !1
r
r
[CHANNEL, 1, 2]:To select preset radio channels !9
t
t
[1-0,>
=10/ENTER]:To enter radio frequencies !8and channels !9
y
y
[DIRECT TUNING/DISC]:To enable selection of radio stations by frequency !8
u
u
[L BALANCE R]:To adjust front speaker balance
i i
[DVD, TV, VCR, TUNER/BAND RECEIVER]:Input and remote control mode buttons !0.
DVD:to switch input and remote...

13
RQT6501
@ @0
0
Standby/on button [POWER 8]Press to switch the unit from on to standby mode or vice versa.
In standby mode, the unit is still consuming a small amount of power.
@ @1
1
[INPUT SELECTOR]:To select the input source!0
@
@2
2
[FM MODE]:
Press to switch to monaural mode if FM reception is poor !8.
@
@3
3
[MEMORY]: To preset radio stations !8
@
@4
4
[TUNE MODE]: To allow preset channel selection with [2TUNING1] !9
@
@5
5
Remote control signal sensor
@ @6
6
Standby indicator [^]
When the unit...

14
RQT6501
Control guide
Operating a DVD player
SUBWOOFERSFC
TOP MENUMENU
TVVCR
RETURN
PAUSE STOP
SOUND MODECHANNEL VOLUME
PLAY
/SEARCHSKIP
DISPLAY
MUTING
ENTER
TEST3
6 2
5 1
4
9 8 7
0
DIRECT TUNING/DISC10/ENTER
TONE
DELAY
LEVEL
TIMER TV/VIDEO
REPEAT
DVD
L   BALANCE   R
A-B
REPEAT
MARKER
TV VOL
SUB TITLESETUPAUDIO ANGLE
POSITION
MEMORY
DVD
GROUPPAG EDVD 6CH
DIGITALTUNER/
BANDINPUT
SELECTOR
RECEIVER
RECEIVER
15
17
18
19
16
21
22
23
DVD
1
2
3
4
5
6
7
8
10
9
11
12
13
14
20
SLOW
q q[TOP MENU]:To show the...

15
RQT6501
o o
[SUB TITLE]:To change subtitles
! !0
0
[SETUP]:To show set up menus
! !1
1
[REPEAT]:To select a repeat play mode
! !2
2
[A-B REPEAT]:To specify start and finish points for A-B repeat
! !3
3
[GROUP]: (DVD Audio only)To select a group
! !4
4
[PAGE]: (DVD Audio only)To select still pictures
! !5
5
[MENU]:To show disc menus
! !6
6
[ENTER]:To confirm item selection in menus
Operations
! !7
7
[RETURN]:To return through menus and clear them
! !8
8
[SLOW/SEARCH t, y]:To search through the disc
!...

16
RQT6501
SUBWOOFERSFC
TOP MENUMENU
TVVCR
RETURN
PAUSE STOP
SOUND MODECHANNEL VOLUME
PLAY
/SEARCHSKIP
DISPLAY
MUTING
ENTER
TEST3
6 2
5 1
4
9 8 7
0
10/ENTER
TONE
DELAY
LEVEL
TIMER TV/VIDEO
REPEAT
DVD
L   BALANCE   R
A-B
REPEAT
MARKER
TV VOL
SUB TITLESETUPAUDIO ANGLE
POSITION
MEMORY
DVD
GROUPPAG EDVD 6CH
DIGITALTUNER/
BANDINPUT
SELECTOR
RECEIVER
RECEIVER
TV
VCR
6
7
1
2
3
4
5
8
DIRECT TUNING/DISC
SLOW
To turn the TV on/off
TV
e e[CHANNEL 1, 2]:To select channels sequentially
r r[1-0,  >
=10/ENTER]:To...

17
RQT6501
Changing the codes
Code table
This remote control can operate Panasonic and Technics audiovisual equipment that have remote control sensors. You may need to change the
remote control code.
It can also operate some other brands of televisions, video cassette players, and DVD players. Check the table for the brand and enter the code as
follows.
Press and hold the button
corresponding to the
equipment.
Enter the first digit.
Enter the second digit.
The remote control outputs the on/off signal.
If...

18
RQT6501
The radio
1. Press [INPUT SELECTOR] to select “TUNER
(FM)” or “AM”.
“FM” appears 2 seconds after you select “TUNER”.
2. Press [TUNING 2or 1] to select the frequency of
the station.
Tuning intervals: FM–0.2 MHz, AM–10 kHz
Automatic tuning
Hold down [TUNING 2or 1] until the frequency begins to scroll. Tuning
stops when a station is found. (Tuning may stop if there is interference.)
Manual tuning
1. Press [TUNER/BAND RECEIVER].The band changes each time you press the button.
2. Press [DIRECT...

19
RQT6501
Selecting channels
Press [CHANNEL 1or 2].
or
Press the numbered buttons.
For channel 1 to 9, press the corresponding number.
For channels 10 or over, press [>
=10/ENTER], then the two digits.
e.g. To select channel 21: 
[>
=10/ENTER] / [2] / [1]
TUNE MODE
2TUNING1
SUBWOOFERSFC
DVD
TOP MENUMENU
TVVCR
RETURN
PAUSE STOP
SOUND MODECHANNEL VOLUME
PLAY
/SEARCHSKIP
DISPLAY
MUTING
ENTER
TEST
6 2
5 1
4
9 8 7
0
DIRECT TUNING/DISC10/ENTER
TONE
DELAY
LEVEL
L   BALANCE   R
TV VOL
3
DIGITALTUNER/
BANDINPUT...

20
RQT6501
You can record to a VCR connected to VCR OUT.
See the recording unit’s operating instructions for details on how to
prepare it for recording.
When recording with a VCR, you can record any source except VCR.
1. Press [INPUT SELECTOR] to select the source to
be recorded.
2. Begin recording.
Follow your recording unit’s operating instructions.
3. Start the source to be recorded.Follow your equipment’s operating instructions.
¡You cannot record a source connected through a digital terminal.
When...