Panasonic 42"47" Class 1080p Lcd Hdtv Tc L42et5 Owners Manual

manual electrónico
Owner’s Manual
42”/47” Class 1080p LCD HDTV
(42.0/47.0 inches measured diagonally)
Manual de usuario
Televisión de alta definición de 1080p y 
clase 42”/47” de LCD
(42,0/47,0 pulgadas medidas diagonalmente)
For assistance (U.S.A./Puerto Rico), please call:1-877-95-VIERA (958-4372)www.panasonic.com/help
For assistance (Canada), please call:1-866-330-0014concierge.panasonic.ca
Para solicitar ayuda (EE.UU./Puerto Rico), llame al:
1-877-95-VIERA (958-4372)www.panasonic.com/help
TQB2AA0636...

2
This product incorporates the following software or technology:(1) the software developed independently by or for Panasonic Corporati\
on,
(2) the software owned by third party and licensed to Panasonic Corpor\
ation,
(3) the software based in part on the work of the Independent JPEG Gro\
up,
(4) the software developed by the FreeType Project,
(5) the software licensed under the GNU LESSER GENERAL PUBLIC LICENSE (LGPL) and/or,
(6) open sourced software other than the software licensed under the L\...

3
VIERA Link™ is a trademark of 
Panasonic Corporation.
HDMI, the HDMI logo and High-
Definition Multimedia Interface are 
trademarks or registered trademarks 
of HDMI Licensing LLC in the United 
States and other countries.
SDXC Logo is a trademark of SD-
3C, LLC.
“AVCHD” and the “AVCHD” logo 
are trademarks of Panasonic 
Corporation and Sony Corporation.
“RealD 3D” is a trademark of RealD.
DLNA®, the DLNA Logo and DLNA 
CERTIFIED™ are trademarks, 
service marks, or certification 
marks of the Digital...

4
ANTENNA
LEAD-IN WIRE
ANTENNA
DISCHARGE UNIT 
(NEC SECTION 810-20)
GROUNDING 
CONDUCTORS
 (NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING 
ELECTRODE SYSTEM 
(NEC ART 250, PART H)
ELECTRIC 
SERVICE 
EQUIPMENT
GROUND CLAMP
EXAMPLE OF ANTENNA 
GROUNDING AS  PER 
(NEC) NATIONAL 
ELECTRICAL
CODE
Safety Precautions
Note to CATV System Installer
This reminder is provided to direct the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for 
proper grounding and,...

5
19)  An outside antenna system should not be located in the vicinity of overh\
ead power lines, other electric light, power circuits, or where it can fall into such power lines or circuits. When installing an \
outside antenna system, extreme care should be taken to 
keep from touching such power lines or circuits as contact with them mig\
ht be fatal.
20)  Unplug this LCD TV from the wall outlet and refer servicing to qualified service personn\
el under the following conditions:
  a.  When the power...

6
FCC and IC STATEMENT
This equipment has been tested and found to comply with the limits for a\
 Class B digital device, pursuant to Part 15 of the FCC 
Rules.  These limits are designed to provide reasonable protection against harmf\
ul interference in a residential installation.  
This equipment generates, uses and can radiate radio frequency energy an\
d, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications.  H\
owever, there is no...

7
 
■About  built-in wireless LAN 
●To use the built-in wireless LAN, an access point needs to be obtained. 
●Do not use the built-in wireless LAN to connect to any wireless network \
(SSID*1) for which you do not have usage 
rights. Such networks may be listed as a result of searches. However, using them may be regarded as illegal access.
 
●Do not subject the built-in wireless LAN to high temperatures, direct su\
nlight or moisture. 
●Check that the Access point supports WPS*2. 
(If it does not support...

8
Accessories/Optional Accessories
Accessories
Check you have all the items shown.
 Accessories
Remote Control
Transmitter
 N2QAYB000703
Batteries for the
Remote Control
Transmitter (2)
 AA Battery
Owner’s Manual
 3D Eyewear (4) 
Quick Start Guide
Child safety
Product Registration Card (U.S.A.)
 Pedestal
  Optional AccessoriesPlease contact your nearest Panasonic dealer to purchase the recommended\
 
optional accessories. For additional details, please refer to the option\
al 
accessories installation...

9
■Assembling the pedestal   Fix securely with assembly screws  
(Total 4 screws).
 
  Tighten screws firmly.A
Bracket
Front BaseHold the bracket 
not to fall over
(Image)
■Set-up
   Tighten assembly screws  (total 4 screws) loosely at first,
    then tighten them firmly to fix securely.
BRear side
Arrow 
mark
Hole for pedestal 
installation 
bracket
 Base 
Rear view
Arrow 
mark
(Image)
Work on a flat surface
Removing the pedestal from the TVBe sure to remove the pedestal in the following way when using...

10
Power cord connection
• When disconnecting the power cord, be absolutely 
sure to disconnect the power cord plug from the 
wall outlet first.
• The included power cord is for use with this unit 
only.
Insert the power cord plug (included) firmly into place.
 Installing the remote’s batteries
Pull 
open
Hook
Note the correct 
polarity (+ or -). Close
Caution
  Incorrect installation may cause 
battery leakage and corrosion, 
resulting in damage to the remote 
control.
• Do not mix old and new...