OKI C3300N User Manual

							
Replacing consumable items> 101
REPLACING CONSUMABLE ITEMS
This section explains how to replace consumable items when due. 
As a guide, the life expectancy of these items is:>To n e r
Starter Cartridge:
The machine is shipped with sufficient Black, Cyan, 
Magenta & Yellow toner for 500 A4 pages, all of which is 
used to initially fill the image drum.
Replacement Cartridge:
Replacement cartridges are available in Standard capacity 
(1,500 A4 pages @ 5% coverage) and High capacity 
(2,500 A4 pages @ 5% coverage).
> Image drum — 15,000 pages (calculated on typical office 
usage of 3 A4 pages per job).
> Transfer belt — Approximately 50,000 A4 pages at 3 
pages per job.
> Fuser (C3300) — Approximately 30,000 A4 pages.
> Fuser (C3400n) — Approximately 50,000 A4 pages.
NOTE
Toner life is directly affect ed by coverage, e.g. at 10% 
coverage there is sufficient to ner for 750 A4 pages (standard 
capacity) or 1,250 A4 pages (high capacity).
Downloaded From ManualsPrinter.com Manuals 
						

							
Replacing consumable items> 102
CONSUMABLE ORDER DETAILS
* Average life: 20% pages at continuous print, 50% pages at 3 pages per job and 30% pa ges at 1 page per job.
Only use genuine Oki Original  consumables to ensure the 
best quality and performance from your hardware. Non 
Oki Original products ma y damage your printers 
performance and invalidate your warranty. Specifications 
subject to change withou t notice. All trademarks 
acknowledged.
ITEMLIFEORDER NO.
Toner, Standard Capacity, 
black 1,500 A4 @ 5% 43459436
Toner, Standard Capacity, 
cyan 1,500 A4 @ 5% 43459435
Toner, Standard Capacity, 
magenta 1,500 A4 @ 5% 43459434
Toner, Standard Capacity, 
yellow 1,500 A4 @ 5% 43459433
Toner, High Capacity, black 2,500 A4 @ 5% 43459332
Toner, High Capacity, cyan 2,500 A4 @ 5% 43459331
Toner, High Capacity, magenta 2,500 A4 @ 5% 43459330
Toner, High Capacity, yellow 2,500 A4 @ 5% 43459329
Image drum kit, black 15,000 A4 pages* 43460208
Image drum kit, cyan 15,000 A4 pages* 43460207
Image drum kit, magenta 15,000 A4 pages* 43460206
Image drum kit, yellow 15,000 A4 pages* 43460205
Fuser (C3300) 30,000 A4 pages 43377103
Fuser (C3400n) 50,000 A4 paper 43377003
Transport belt 50,000 A4 @ 3/job 43378002
Downloaded From ManualsPrinter.com Manuals 
						

							
Replacing consumable items> 103
TONER CARTRIDGE REPLACEMENT
The toner used in this printer is a very fine dry powder. It is 
contained in four cartridges: one each for cyan, magenta, yellow 
and black.
Have a sheet of paper handy so that you have somewhere to 
place the used cartridge while you install the new one.
Dispose of the old cartridge responsibly by placing it inside the 
pack that the new one came in. Follow any regulations, 
recommendations, etc., which may be in force concerning waste 
recycling.
If you do spill any toner powder, lightly brush it off. If this is not 
enough, use a cool, damp cloth to remove any residue.  Do not 
use hot water, and never use solvents of any kind. They will make 
stains permanent.
Before changing the toner cartridge, switch off the printer and 
allow the fuser to cool for about 10 minutes before opening the 
cover.
CAUTION!
To avoid toner wastage an d possible toner sensor 
errors, do not change the- toner cartridge(s) until 
“TONER EMPTY” is displayed through the Status 
Monitor.
WARNING!
If you inhale any toner or get it in your eyes, drink a 
little water or bathe your eyes liberally in cold water. 
Seek medical attention immediately.
Downloaded From ManualsPrinter.com Manuals 
						

							
Replacing consumable items> 104
1.Press the cover release and open the printer’s top cover 
fully.
2. Note the positions of the 4 cartridges.
WARNING!
If the printer has been po wered on, the fuser may be 
hot. This area is clearly labelled. Do not touch this area.
1. Cyan cartridge 2. Magenta cartridge
3. Yellow cartridge 4. Black cartridge
1
2
3
4
Downloaded From ManualsPrinter.com Manuals 
						

							
Replacing consumable items> 105
3.Carry out one of the following:
(a) If you are replacing a tone r cartridge that has been 
supplied with your printer (release lever has 3 
positions), pull the coloured toner release lever on 
the cartridge to be replaced towards the front of the 
printer, in the direction of the arrow, but stop at the 
central (upright) position (1).
(b) If you are replacing any other toner cartridge (lever 
has 2 positions), pull the coloured toner release 
lever (1) on the cartridge to be replaced fully 
towards the front of the printer.
1
1
Downloaded From ManualsPrinter.com Manuals 
						

							
Replacing consumable items> 106
4.Lift the right-hand end of the cartridge and then draw the 
cartridge to the right to release the left-hand end as 
shown, and withdraw the toner cartridge from the printer.
5. Put the cartridge down gently onto a piece of paper to 
prevent toner from marking your furniture.
6. Remove the new cartridge fr om its box but leave its 
wrapping material in place for the moment.
7. Gently shake the new cartridge from end to end several 
times to loosen and distribute the toner evenly inside the 
cartridge.
CAUTION!
The green image drum surface  is very delicate and light 
sensitive. Do not touch it and do not expose it to normal 
room light for more than 5 m inutes. If the drum unit 
needs to be out of the printer for longer than this, please 
wrap the cartridge inside a bl ack plastic bag to keep it 
away from light. Never expose the drum to direct 
sunlight or very bright room lighting.
Downloaded From ManualsPrinter.com Manuals 
						

							
Replacing consumable items> 107
8.Remove the wrapping material and peel off the adhesive 
tape from the underside of the cartridge.
9. Holding the cartridge by its top centre with the coloured 
lever to the right, lower it into the printer over the image 
drum unit from which the old cartridge was removed.
10. Insert the left end of the cartridge into the top of the 
image drum unit first, pushing it against the spring on the 
drum unit, then lower the right end of the cartridge onto 
the image drum unit.
Downloaded From ManualsPrinter.com Manuals 
						

							
Replacing consumable items> 108
11.Pressing gently down on the cartridge to ensure that it is 
firmly seated, push the coloured lever (1) towards the 
rear of the printer. This will lock the cartridge into place 
and release toner into the image drum unit.
12. Finally, close the top cover and press down firmly so that 
the cover latches closed.
1
Downloaded From ManualsPrinter.com Manuals 
						

							
Replacing consumable items> 109
IMAGE DRUM REPLACEMENT
Switch off the printer and allow the fuser to cool for about 
10 minutes before opening the cover.
The printer contains four image drums: cyan, magenta, yellow 
and black.
1.Press the cover release and open the printer’s top cover 
fully.
WARNING!
If the printer has been powere d on, the fuser will be hot. 
This area is clearly labelled. Do not touch.
CAUTION!
 Static sensitive devices, handle with care. 
Downloaded From ManualsPrinter.com Manuals 
						

							
Replacing consumable items> 110
2.Note the positions of the 4 cartridges.
3. Holding it by its top centre, lift the image drum, complete 
with its toner cartridge (1), up and out of the printer.
1
2
3
4
1. Cyan cartridge 2. Magenta cartridge
3. Yellow cartridge 4. Black cartridge
1
Downloaded From ManualsPrinter.com Manuals