Nishika N8000 3-d Manual

							lf you have any difficulty with your camera or 3-D prints, the following guide to common proble
solutions may be helPful.
ProblemSolution
1. The film does not advance when the film advance
lever is operated.
2. The shutter does not release when the shutter
release button is Pressed.
3. The red warning light in the viewfinder does not
come on when the shutter release button is par-
tially depressed, even though the scene is poorly
tit.
4. The film advance lever will not advance the film
for the last shot.
5. The rewind crank will not turn to rewind the film at
the end of a roll.
6. The expgsure COunter dOeS nOt return tO S When
the back door is opened after the film has been
rewound.
1. When loading the film, be sure that a film perfora-
tion hole at the bottom edge of the film is secure-
ly attached to the hook at the base of one of the
slots of the take-up spool, and that the film is
drawn tight across the back of the camera before
closing the back door.
2. Make sure that the film has been advanced.
3. Use the battery tester to check that the batteries
are loaded properly and have sufficient charge.
4. Do not force the lever, but rewind the film at this
point. Forcing the lever in order to squeeze in
one more picture may cause exposure overlap
More than likely, too much film was wound onto
the take-up spool during loading, not leaving
enough for the last shot. Make sure to follow the
film loading instructions carefully.
5. Be sure that the rewind release button at the bot-
tom of the camera has been pressed before at-
tempting to rewind the film.
6. Operate the film advance lever one full stroke by
pushing it to the right as far as possible. 
						

							
I
I
7. The 3-D effect of your prints is unsatisfactory:(i) Your prints look tlat, exhibiting little or no 3-Deffect; OR(ii) certain objects, especially in the foreground,Jump around and are hard to focus on as youview the print.
8. You received fewer 3-D prints than you expected.
9. Prints are overexposed (too light) or underexposed(too dark).
7. Your foreground and midground objects may nothave been at or near the ideal 3-D distances. Tryto keep your foreground objects as close to 6feet from the camera as possible, and yourmain subject between 15 and 22 teel from thecamera for outdoor shots, 10 to 14 feet for in-door shots. Do not photograph objects closerthan 5 112 feet.
8. a. since your N8000 camera exposes two standardframes of film for every 3-D shot, you should getback 6, 12 or 18 prints, depending on whetheryou used 12-,24- or 36-exposure film.b. lf you received back fewer prints, it is rikely that toomuch film was wound onto the take-up spoolduring loading.c. You may have been holding the camera vertically.Be sure you hold the camera horizontally-otherwise, no 3-D effect can be achieved, andthe picture will not be printed.
9. Make sure you have moved the aperture serectorto the appropriate setting before shooting your pic-tures, and change the setting when necessary aslighting conditions vary. Use only ISO/ASA 100color print film.In the case of underexposure, you may have failedto use a flash when it was necessary. lf you see ared light in the viewfinder when the shutter releasebutton is partially depressed, this indicates a lowlight situation where a flash is needed for properexposure. when using a flash unit indoors, set thelighting selector on your camera to the cloudy/ln-doors position.
www.orphancameras.com  
						

							NISHIKA 35mm 3DIMENSIONAL CAMERAFULL 1.YEAR UNCONDITIONAL WARRANTYON ALL PARTS AND LABOR
Your Nishika camera is warranted by Nishika corpora-tion agiinst defects in workmanship and materials for aoerioOot one year from the date of purchase. For this war-ia;it to be vati0, you must fill out theenclosed warralt.y cardand return it alonq with your dated sales receipt (original orpnotocopy) to the-addrelss listed below within thirty days otthe dateiciu purchased your Nishika camera.
lf your camera proves to be defective within the war-ranty pdrioO, we wjll rbpair or, at oul option, replace it with anio? tuiV reConditioried camera. Thb repaired or leplacedunitwill carrythe remaining warraqty period applicable to theoriginit cimera. Camera-s used fdr.commercial or profes-sional purposes are excluded from this warranty
To obtain warranty service, the camera must beshipped oi mailed to the ltisnifa Corporation Service Cen-terat the following address:
NISHIKA CORPORATIONSERVICE CENTER
r.lll5ltt?H8or o
shipping charges for the return of the defectivecamera are thb responsibility of the consumer.
This warranty does not allow for consequ,entialdamages. lSome states do not allow the exclusion or limita-tion oiincidental or consequential damages. Therefore thetoregoing exclusion or limitation may not apply to you)
ln no event shall the maximum liability of Nishika cor-poration exceed the original consumer purchase price of thisproduct.
Nishika corporation extends no other warranties, ex-press or implied, ld specifically does.not authorize.any p.er-son or representativeto assume for it 9l), other obligationoi tiaOility in connection with the sale of this product.
Camera Type:
Film Type:
Shutter Speed:
Lens System:
Flash
Synchronization:
Viewfinder:
Light Meter:
Exposure Control:
Exposure Counter:
Film Advance:
Power Source:
Other Features:
Dimensions:
Weight:
35mm, 3-dimensional
35mm ISO/ASA 100 DIN
21 color print film ONLY
1/60 sec.
Four 30mm coated oPtical
pairs prefocused from
5 112 feet to inf initY
Hot shoe contact for cord-
less flash connection to
the Nishika Twin Light
3010 (Other tyPes of
flash units may be used.)
Bright frame, parallax
corrected, vertical format
Red LED low light warning
in viewfinder
Manual aperture selection
Automatic reset
Single-stroke film advance
lever
Two AA batteries
Built-in double exposureprevention
6.7 width x 4.2 height x
2.4 depth
20.5 ounces 
						

							
This warranty gi.vgs you specific legal rights, and youmay also have other rightd which vary from st6te to state.
Your satisfaction with your Nishika3-Dimensional Camera and prints is very im-portant to us. lf you have any questions orproblems, please call us at (702) 454-9000.Our Customer Service Department is openeach weekday from 7:30 AM to 4:00 pM
Pacific Time to answer your questions andhelp you enjoy your Nishika camera.
Nishika Corporation
Service Center1 Nishika DriveHenderson, Nevada 89014
O 1989 Nishika Corporation
www.orphancameras.com  
						

							1618191422
14. Viewfinder15. Rewind Release Button16. Film Pressure Plate17. Camera Back18. Film Take-Up Spool19. Film Advance Sprockets20. Tripod Mount21. Battery Chamber22. Rewind Shaft23. Film Chamber24. Thumbwheel
\1