Nikon Coolpix S50 User Manual

							19
Inserting Memory Cards
First Steps
Removing Memory Cards
Before removing memory cards, turn the camera
off and confirm that the power-on lamp is off.
Open the battery-chamber/memory card slot cover
and press the card in 1 to partially eject the card
2. The card can then be removed by hand.
jFormatting Memory Cards
If the message at right is displayed, the memory card must be
formatted before use (c117). Note that formatting per-
manently deletes all pictures and other data on the mem-
ory card. Be sure to make copies of any pictures you wish to
keep before formatting the memory card.
Use the rotary multi selector to choose [Format] and press d. The
screen shown at right will be displayed. To start formatting, choose [Format] again and press d.
•Do not turn the camera off or open the battery-chamber/memory card slot cover
until formatting is complete. 
• The first time you insert the memory cards used in other devices into the COOLPIX S50, be
sure to format them (c117).
jThe Write Protect Switch
SD memory cards are equipped with a write protect
switch. Pictures cannot be recorded or deleted and the
memory card cannot be formatted when this switch is in
the “lock” position. Unlock by sliding the switch to the
“write” position.
jMemory Cards
• Use only Secure Digital memory cards.
• Do not perform the following during formatting, while data are being written to or deleted
from the memory card, or during data transfer to a computer. Failure to observe this pre-
caution could result in the loss of data or in damage to the camera or memory card.
- Eject the memory card
- Remove the battery
- Turn off the camera
- Disconnect the AC adapter
• Do not disassemble or modify.
• Do not drop, bend, or expose to water or strong physical shocks.
• Do not touch the metal terminals with your fingers or metal objects.
• Do not affix labels or stickers to the memory card.
• Do not leave in direct sunlight, closed vehicles, or areas exposed to high temperatures.
• Do not expose to humidity or to corrosive gases.
2
1
Card is not formatted.
No
Format
Write protect switch
Downloaded From camera-usermanual.com Nikon Manuals 
						

							20
Basic Photography and Playback: Auto Mode
Basic Photography and Playback: Auto Mode
Step 1 Turn the Camera On and Select L (Auto) Mode
This section describes how to take pictures in L (auto) mode, an automatic,
“point-and-shoot” mode recommended for first-time users of digital cam-
eras.
1Press the power switch to turn on the
camera.
The power-on lamp will light and the monitor will
turn on.
Proceed to step 4 when M is displayed.
2Press C.
3Use the rotary multi selector to choose
L and press d.
The camera enters L (auto) mode.
4Check the battery level and number of
exposures remaining.
Battery level
Number of exposures remaining
The number of pictures that can be stored depends on the capacity of the memory
or memory card and image mode setting.
MonitorDescription
NO INDICATORBattery fully charged.
wBattery low; charge or replace 
the battery.
K
Warning!
Battery 
exhausted.Battery exhausted. Recharge or 
replace with a fully charged 
battery.
Shooting
6
MMwL
W
w
W
6
Battery level indicator
Number of exposures 
remaining
Downloaded From camera-usermanual.com Nikon Manuals 
						

							21
Step 1 Turn the Camera On and Select L (Auto) Mode
Basic Photography and Playback: Auto Mode
Indicators Displayed in L (Auto) Mode
lAvailable Functions in L (Auto) Mode
In L (auto) mode, macro close-up mode (c31) and exposure compensation (c32) can be
applied and pictures can be taken using the flash (c28) and self-timer (c30). Pressing m
in L (auto) mode displays the shooting menu. This menu allows you to specify the image
mode (c89), white balance setting (c91), and to apply continuous shooting (c93), BSS
(c95), ISO sensitivity (c96), color options (c96), and AF area (c97) to suit shooting
conditions or your own preferences.
lVibration Reduction
[Vibration reduction] (c114), when [On] (default setting) is selected, can be applied to effec-
tively reduce blur, caused by slight hand movement known as camera shake, that commonly
occurs when shooting with zoom applied or at slow shutter speeds.
Vibration reduction can be used in all shooting modes.
lAuto Power Off in L (Auto) Mode (Standby Mode)
The monitor will dim to reduce the drain on the battery if no operations are performed for
about five seconds. The monitor will brighten when camera controls are used. At default set-
tings, the monitor will turn off altogether if no operations are performed for about a minute
during shooting and playback. The camera will turn off automatically if no operations are per-
formed for another three minutes (c116).
6
MML
WW
6
Shooting mode
M displayed in L (auto) mode
Image mode
Choose from seven image-mode 
options depending on how you plan 
to use the picture. The default set-
ting is E Normal (3,072 × 2,304).Internal memory indicator
Pictures will be recorded to internal 
memory. When memory card is inserted, 
M is not displayed and pictures will be 
recorded to memory card.Vibration reduction icon
Vibration reduction can be set 
up according to the shooting 
conditions. The default setting is 
[On].
Downloaded From camera-usermanual.com Nikon Manuals 
						

							22
Basic Photography and Playback: Auto Mode
Step 2 Frame a Picture
1Ready the camera.
Hold the camera steadily in both hands, keeping your
fingers and other objects away from the lens, flash,
and self-timer lamp.
2Frame the picture.
Position the main subject near the center of the mon-
itor.
Using the Zoom
Use the zoom buttons to activate optical zoom.
Press t (j) to zoom out, increasing the area visi-
ble in the frame, or v (k) to zoom in so that the
subject fills a larger area of the frame.
When the camera is zoomed in to the maximum magnification (3×), holding
down v (k) triggers digital zoom. The subject is magnified up to 4×, for a
total magnification of 12×.
A monitor indicator shows the current zoom ratio.
6
MML
WW
6
Zoom out Zoom in
Optical zoom 
(up to 3×)Zoom indicator turns 
yellow when digital 
zoom is in effect. Zoom indicator dis-
played when the zoom 
buttons are pressed.
Downloaded From camera-usermanual.com Nikon Manuals 
						

							23
Step 2 Frame a Picture
Basic Photography and Playback: Auto Mode
jDigital Zoom
Unlike optical zoom, data from the camera’s image sensor are processed digitally with digital
zoom. Details visible at maximum optical zoom are simply enlarged, producing a slightly
“grainy” image.
lHigh-sensitivity Shooting Mode
In high-sensitivity shooting mode (c33), sensitivity is increased to reduce blurring caused by
camera shake or subject movement under low lighting.
lAnti-shake Mode
In anti-shake mode (c42), [Vibration reduction] (c114) and [BSS] (best shot selector)
(c95) are enabled to reduce blurring caused by camera shake and subject movement, and
the flash is disabled. With [BSS] enabled, the camera takes shots to a maximum of ten, they
are compared, and the sharpest picture (picture with the highest level of detail) is saved. A
higher sensitivity is set, and the shutter speed will be faster, even for shooting subjects in the
same brightness, than in L (auto) mode. This mode is not suited to shooting under low
lighting, but is suited to shooting under natural light when the camera is zoomed in.
Downloaded From camera-usermanual.com Nikon Manuals 
						

							24
Basic Photography and Playback: Auto Mode
Step 3 Focus and Shoot
1Press the shutter-release button halfway.
The camera focuses on the subject positioned within
the active focus area. By default, the camera auto-
matically chooses the focus area (one of five) contain-
ing the subject closest to the camera and adjusts
exposure accordingly.
When the subject is in focus, the active focus area
and focus indicator (p) glow green.
When the camera is unable to focus, the focus area
and focus indicator blink red. Change the composi-
tion and try again.
The focus area is not displayed when digital zoom is
in effect.
2Press the shutter-release button the rest
of the way down.
The picture will be recorded to the memory card or
internal memory.
lShutter-Release Button
The camera features a two-stage shutter-release button. To set focus and exposure, press the
shutter-release button halfway, stopping when you feel resistance. Focus and exposure lock
while the shutter-release button is held in this position. To release the shutter and take a pic-
ture, press the shutter-release button the rest of the way down. Do not use force when press-
ing the shutter-release button, as this may result in camera shake and blurred pictures.
6
MM
WW
L
6
6
MM
WW
L
6
Take picture Set focus and 
exposure
Downloaded From camera-usermanual.com Nikon Manuals 
						

							25
Step 3 Focus and Shoot
Basic Photography and Playback: Auto Mode
jDuring Recording
While pictures are being recorded, the y (wait) icon will be displayed, and the M icon will
blink. Do not turn the camera off, open the battery-chamber/memory card slot cover, or
remove or disconnect the power source while these icons are displayed. Cutting power or
removing the memory card in these circumstances could result in loss of data or in damage to
the camera or card.
kAutofocus
Autofocus may not perform as expected in the following situations:
• Subject is very dark
• Objects of sharply differing brightness are included in the scene (e.g., the sun is behind the
subject and is in deep shadow)
• No contrast between the subject and surroundings (e.g., when the subject is standing in
front of a white wall, wearing a white shirt)
• Several objects are at different distances from the camera (e.g., the subject is inside a cage)
• Subject is moving rapidly
In the situations noted above, try pressing the shutter-release button halfway to refocus sev-
eral times, or use focus lock (c97).
lAF-assist Illuminator and Flash
If the subject is poorly lit, the AF-assist illuminator may light by pressing the shutter-release
button halfway, or the flash may fire by pressing the shutter-release button all the way down.
Downloaded From camera-usermanual.com Nikon Manuals 
						

							26
Basic Photography and Playback: Auto Mode
Step 4 Viewing and Deleting Pictures
Full-Frame Playback
Press i.
The last picture taken will be displayed.
Use the rotary multi selector G, H, I, or J to view
additional pictures.
Pictures taken in “tall” orientation will be rotated auto-
matically (c116). The rotating direction can be changed
(c103).
Pictures may be displayed briefly at low resolution while
being read from the memory card or internal memory.
Press i or the shutter-release button to switch to shoot-
ing mode.
When M is displayed, pictures stored in the internal mem-
ory will be displayed. When memory card is inserted, M is
not displayed and pictures stored on the memory card will
be displayed.
Deleting Pictures
1Press T to delete the picture currently
displayed in the monitor.
2Use the rotary multi
selector to select
[Yes] and press d.
To exit without deleting the
picture, choose [No] and
press d.
15/05/2007 15:3015/05/2007 15:300004.JPG0004.JPG0004.JPG
4 4O M
M
4 4
EE
O
15/05/2007 15:30
Internal memory
indicator
MMErase 1 image?Erase 1 image?Erase 1 image?
No
Ye sK
Done
Downloaded From camera-usermanual.com Nikon Manuals 
						

							27
Step 4 Viewing and Deleting Pictures
Basic Photography and Playback: Auto Mode
kFull-Frame Playback Mode
The following options are available in full-frame playback mode.
Quick Playback Zoom
Pressing v (k) during full-frame playback zooms the current
picture in 3×, with the center of the picture displayed in the
monitor (Quick Playback Zoom) (c47).
Press d to return to full-frame playback. 
kViewing Pictures
• When the camera is off, holding down i will turn the camera on in full-frame playback
mode. If the camera is turned off in voice recording mode (c69) or audio playback mode
(c71), the camera will be turned on in audio playback mode.
• Pictures stored in the internal memory can only be viewed if no memory card is inserted.
kDeleting the Last Picture Taken
In shooting mode, press T to delete the last picture taken.
When the confirmation dialog shown at right is displayed, use
the rotary multi selector to choose [Yes] and press d.
To exit without deleting the picture, choose [No] and press d.
OptionUseDescriptionc
Playback zoomv (k)Press v (k) to enlarge view of pic-
ture currently displayed in monitor 
up to about 10×.47
View thumbnailst (j)Press t (j) to display nine, 16, or 
25 picture thumbnails.45
Display thumbnail 
wheelRotate the rotary multi selector to 
display the thumbnail wheel.46
D-LightingAPress A to enhance brightness 
and contrast in dark portions of pic-
tures.49
Record/play voice 
memodPress d to record or play back voice 
memos up to 20 seconds in length.52
Switch to shooting 
mode
iPress i or the shutter-release but-
ton to switch to the shooting mode 
selected in the shooting-mode 
selection menu.26
X3.0
MMErase 1 image?Erase 1 image?Erase 1 image?
No
Ye s
Downloaded From camera-usermanual.com Nikon Manuals 
						

							28
Basic Photography and Playback: Auto Mode
Using the Flash
The flash has a range of 0.3–3.5 m (1–11.4 ft.) when the camera is zoomed
out all the way. With maximum optical zoom applied, the range is 0.3–3 m
(1–9.8 ft.) (when [ISO sensitivity] is set to [Auto]). The following flash modes
are available:
1Press J (flash mode).
The flash menu is displayed.
2Use the rotary multi selector to choose
the desired flash mode and press d.
The icon for the selected flash mode is displayed at
the top of the monitor.
When z (auto) is applied, z is only displayed for
five seconds.
The flash mode applied in L (auto) mode and high-
sensitivity shooting mode is stored in the camera’s
memory even after the camera is turned off.
If a setting is not applied by pressing d within five
seconds, the selection will be cancelled.
zAuto (default setting for L (auto) mode)
Flash fires automatically when lighting is poor.
AAuto with red-eye reduction
Reduces “red-eye” in portraits (c29).
BOff
Flash will not fire even when lighting is poor.
JFill flash
Flash fires when a picture is taken. Use to “fill-in” (illuminate) shadows and 
back-lit subjects.
DSlow sync
Flash illuminates main subject; slow shutter speeds are used to capture back-
ground at night or under dim light.
zzFlash
6
MMzz
WW
L
6
Downloaded From camera-usermanual.com Nikon Manuals