Netgear Wndr37002 Manual

October 2010
208-10737-01 
v1.0
NETGEAR, Inc.
350 E. Plumeria Drive 
San Jose, CA 95134 USA
N600 Wireless Dual Band 
Gigabit Router 
WNDR3700v2 Setup 
Manual
©2010 by NETGEAR, Inc. All rights reserved. 

2
Trademarks
NETGEAR and the NETGEAR logo are registered trademarks, and Smart Wizard is a trademark of NETGEAR. Inc. 
Microsoft, Windows, and Windows NT are registered trademarks of Microsoft Corporation. Other brand and product 
names are registered trademarks or trademarks of their respective holders.
Statement of Conditions
In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to 
make changes to the products described in this document...

Contentsiii
Contents
N600 Wireless Dual Band Gigabit Router WNDR3700 Setup Manual
 Getting to Know Your Wireless Router................................................................................ 1
Unpacking Your New Wireless Router  .............................................................................. 1
Hardware Features  ............................................................................................................ 2
Front Panel...

Contentsiv
Checking the Internet Service Connection  ...................................................................... 30
Obtaining an Internet IP Address  .............................................................................. 30
Troubleshooting PPPoE  ............................................................................................ 31
Troubleshooting Internet Browsing  ........................................................................... 32
Troubleshooting Connectivity...

Getting to Know Your Wireless Router 1
Getting to Know Your Wireless Router
Congratulations on your purchase of the NETGEAR® N600 Wireless Dual Band Gigabit Router 
WNDR3700.
Before you begin installing your router, check the package contents (see “Unpacking Your New 
Wireless Router” on page 1). Become familiar with the front and back panels of your router—
especially the LEDs—and the important information on the router label (see “Hardware Features” 
on page 2). Then, read the section on “Positioning...

Getting to Know Your Wireless Router 2
To prepare your router for installation:
1.
Carefully remove the protective film from the top of your router.
2.Set up your N600 wireless gigabit router by aligning the arrow on the base with the arrow on 
the back of the case, and sliding the router onto the base.
3.Place your router in an area suitable for installation (near an AC power outlet and accessible to 
the Ethernet cables for your wired computers).
Hardware Features
Before you install and connect your...

Getting to Know Your Wireless Router 3
Front Panel
The front panel has nine status lights that you can use to monitor and verify various conditions. 
There are also two switch buttons on the right (or at the bottom if the router is in its stand). The 
status lights are described in Table 1, and the switch buttons in Table 2.  
Figure 2
Table 1. Status Light Descriptions  
ItemFunctionActivityDescription
1.Power/Test Solid Amber The unit is starting up after being powered on.
Solid Green The unit startup...

Getting to Know Your Wireless Router 4
The WLAN and WPS switch buttons toggle the WLAN and WPS functions on and off. 4.
USB Off No USB device is connected, or the “Safely Remove Hardware” 
button has been pressed and it is now safe to remove the attached 
USB device.
Solid Green The USB device has been accepted by the Router and is ready to be 
used.
Fast Blinking 
GreenThe USB device is in use.
5.Internet Off  No Ethernet cable is connected to the modem.
Solid Amber  The Ethernet cable connection to the...

Getting to Know Your Wireless Router 5
Back Panel
The rear panel of the WNDR3700 router contains the items in the list that follows the figure.
The back of the N600 wireless gigabit router includes:
1.A Power On/Off button.
2.An AC power adapter outlet.
3.Four local (LAN) 10/100/1000 Mbps Ethernet ports for connecting the router to local 
computers.
4.An Internet (WAN) 10/100/1000 Mbps Ethernet port for connecting the router to a cable or 
DSL modem.
5.A USB 2.0 port (backward compatible to USB 1.0/1.1)...

Getting to Know Your Wireless Router 6
Router Label
View the label on the bottom of the N600 wireless gigabit router to identify the security PIN, serial 
number, port connectors, status lights, and default login information.
Positioning Your Wireless Router
The N600 wireless gigabit router lets you access your network from virtually anywhere within the 
operating range of your wireless network. However, the operating distance or range of your 
wireless connection can vary significantly depending on the...