Netgear Wn1000rp Wifi Range Extender For Mobile User Manual
Have a look at the manual Netgear Wn1000rp Wifi Range Extender For Mobile User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 137 Netgear manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
31 A A. Supplemental Information Factory Settings You can press and hold the Factory Settings button on the side panel for 7 seconds. The booster resets, and returns to its factory settings. Table 1. Factory Settings Smart Wizard Enabled Wireless Wireless communication Enabled Wireless Network Name (SSID) NETGEAR_EXT Security Disabled Transmission speed Auto 1 1. Maximum wireless signal rate (IEEE Standard 802.11). Actual throughput will va ry. Network conditions and environmental factors, including volume of network traffic, building materials and construction, and network overhead, lower actual data throughput rate. Country/Region United States (varies by region) Operating mode 802.11n, 802.11g, 802.11b Data rate Up to 150 Mbps
Supplemental Information 32 WiFi Booster for Mobile WN1000RP Technical Specifications Table 2. Technical Specifications Network protocol and standards compatibilityData and Routing Protocols: TCP/IP, DHCP server and client AC input 100-240V, 0.2A (Max.) Physical specifications• Dimensions: 67 x 55 x 52 mm (2.63 x 2.17 x 2 in) • Weight: 0.086 kg (3 oz) Environmental• Operating temperature: 32° to 140° F (0° to 40° C) • Operating humidity: 90% maximum relative humidity, non condensing • Electromagnetic emissions: Meets requirements of: FCC Part 15 Class B. Interface 802.11n/g/b
33 B B. Compliance Notification Regulatory Compliance Information This section includes user requirements for operating this product in accordance with National laws for usage of radio spectrum and operation of radio devices. Failure of the end-user to comply with the applicable requirements may result in unlawful operation and adverse action against the end-user by the applicable National regulatory authority. This products firmware limits operation to only the channels allo wed in a particular Region or Country. Therefore, all options described in this users guide may not be available in your version of the product. Europe – EU Declaration of Conformity Products bearing themarking comply with the following EU directives: • EMC Directive 2004/108/EC • Low Voltage Directive 2006/95/EC If this product has telecommunications functiona lity, it also complies with the requirements of the following EU Directive: • R&TT E Directive 1999/5/EC Compliance with these directives implies conformity to ha rmo nized European standards that are noted in the EU Declaration of Conformity. Intended for indoor use only in all EU me mb er states, EFTA states, and Switzerland. This device may not be used for setting up outdoor radio links in France and in some areas the RF output power may be limited to 10 mW EIRP in the frequency range of 2454 - 2483.5 MHz. For detailed information the end-user should contact the national spectrum authority in France. FCC Requirements for Operation in the United States FCC Information to User This product does not contain any user serviceable co mponents and is to be used with approved antennas only. Any product changes or modifications will invalidate al l applicable regulatory certifications and approvals. FCC Guidelines for Human Exposure This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum di stance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. FCC Declaration of Conformity We, NETGEAR, Inc., 350 East Plumeria Drive, San Jose, CA 95134, declare under our so le responsibility that the WiFi Booster for Mobile WN1000RP complies with Part 15 Subpart B of FCC CFR47 Rules. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept an y interference received, including interference that may cause undesired operation.
Compliance Notification 34 WiFi Booster for Mobile WN1000RP FCC Radio Frequency Interference Warnings & Instructions This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following methods: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. FCC Caution • Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. • This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. • For product available in the USA market, only channel 1~11 can be operated. Selection of other channels is not possible. • This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. TV Tuner (on Selected Models) Note to CATV System Installer: This reminder is provided to call the CATV system installer’s attention to Section 820-93 of the National Electrical Code, which provides guidelines for proper grounding and, in particular, specifies that the Coaxial cable shield be connected to the grounding system of the building as close to the point of cable entry as possible. Canadian Department of Communications Radio Interference Regulations This digital apparatus (WiFi Booster for Mobile WN1000RP) does not exceed the Class B limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications. This Class [B] digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada Industry Canada This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Caution: Ce dispositif est conforme à la norme CNR-210 dIndustrie Canada applicable aux appareils radio exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable.
Compliance Notification35 WiFi Booster for Mobile WN1000RP NOTE IMPORTANTE: Déclaration dexposition aux radiations: Cet équipement est conforme aux limites dexposition aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé av ec un minimum de 20 cm de distance entre la source de rayonnement et votre corps. Interference Reduction Table The table below shows the Recommended Minimum Distance between NETGEAR equipment and household appliances to reduce interference (in feet and meters). Household ApplianceRecommended Minimum Distance (in feet and meters) Microwave ovens 30 feet / 9 meters Baby Monitor - Analog 20 feet / 6 meters Baby Monitor - Digital 40 feet / 12 meters Cordless phone - Analog 20 feet / 6 meters Cordless phone - Digital 30 feet / 9 meters Bluetooth devices 20 feet / 6 meters ZigBee 20 feet / 6 meters