Home > NEC > Cordless Telephone > NEC St4 Single Line Telephone User Guide

NEC St4 Single Line Telephone User Guide

Add to Favourites
    Download as PDF

    View the NEC St4 Single Line Telephone User Guide for free. All the NEC manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview Comments
    Page 1 Volume Control Use the three-position volume control to set the loudness of ringing. 920-244A ST4 Single Line Telephone User Guide Message Waiting Lamp Lights when you have messages waiting (if your phone system can send them). Also flashes when your ST4 rings. Flash While on a call, press Flash for outside line or PBX features. (640 mS +/- 100 mS)Last Number Redial Lift handset and press LND to redial your last call. When placing a call in DP mode, you can dial * to change to Tone Dialing. Dial Mode...
    Page 2 Federal Communications Commission (FCC) Note ST4 W ithout Message W aiting Lamp: 1.The ST4 complies with Part 68 of the FCC rules and incorporates FCC compliant telephone cords, plugs and jacks. The label on the bottom of the telephone contains the FCC registration number. 2.The REN of equipment is to be used to determine the quantity of devices which may be connected to a telephone line. Exceeding the maximum allowed REN of the tele- phone line may result in telephones not ringing in response to an...
    Page 3 Industry Science Canada Note ST4 W ithout Message W aiting Lamp: Notice The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunications network pro- tective, operational and safety requirements. The Department does not guarantee the equipment will operate to the user’s satisfaction. Before installing equipment, users should ensure that it is permissible to be connected to the facilities of the local...
    Page 4 Installing the Wall Mount Kit 88403-1 88403 - 2 Retaining ClipsHandset Holder To install the handset hanger: 1. Use a small flat-blade screwdriver to push the hanger out of the phone. 2. Invert the hanger and push it back into the phone. To wall-mount the phone: 1. Using the two screws provided (or other suitable fasteners), attach the wall-mount bracket to the wall. 2. Push the phone onto the mounting tabs and slide down until it clicks in place. To store the handset without hanging up: 1. Hang the...
    Start reading NEC St4 Single Line Telephone User Guide

    Related Manuals for NEC St4 Single Line Telephone User Guide

    All NEC manuals