NEC Did Allocator User And Installation Guide

NDA-30047   Revision 5.0Page 5
DID Allocator User and Installation Guide Application Configuration
Chapter 2 Application Configuration
DID Allocator is configured into the APM system using the Add function of the 
Application Configuration on the APM System Administration Menu.
Enter the APM option from the APM Platform Management Menu.
Enter the System Administrator password at the APM password screen.
Enter the Application Configuration option from the System Administration 
menu.
This section...

Page 6NDA-30047   Revision 5.0
Application Configuration DID Allocator User and Installation Guide
Step 2:  Primary Configuration Parameters
On the APM Configuration Entry screen, make the entries indicated below for each 
DID Allocator parameter.
Step 3:  OAI Facilities
According to instructions in the APM Operations Manual, designate the 
following NEAX2400 facilities for DID Allocator using the Facilities command 
on the Configuration Entry screen.
MRFI Mode Release (I) MRFR Mode Release (R)
MSF OAI...

NDA-30047   Revision 5.0Page 7
DID Allocator User and Installation Guide Application Configuration
Step 4:  Secondary OAI Configuration Parameters
Using the OAI-Conf command on the APM Configuration Entry screen, make the 
entry shown for each of the following parameters.  Use the instructions provided 
for this option in the APM Operations Manual:
This completes the configuration of DID Allocator in the APM.  Now go to 
Mat Assignments to make the necessary MAT assignments.
Parameter Entry Description...

Application Configuration DID Allocator User and Installation Guide
Page 8NDA-30047   Revision 5.0
This Page Left Blank. 

NDA-30047   Revision 5.0Page 9
DID Allocator User and Installation Guide Mat Assignments
Chapter 3 Mat Assignments
This guide assumes that data settings that affect the operation of all OAI software 
on a system-wide basis have already been assigned on the NEAX Maintenance 
Administration Terminal (MAT).  Such settings include, for instance, system index 
values and assignment of Interface I/O Port Data in the Interface Processor (IP).  
For more information about these system data settings and the MAT...

Page 10NDA-30047   Revision 5.0
Mat Assignments DID Allocator User and Installation Guide
A knowledge of the Dterm stations in the NEAX system and which ones will be set 
up to access DID Allocator is necessary for using these two commands:
AOKC COMMAND:  (Assignment of OAI Key Codes)
This command is first used to associate the MSF facility and its Op Code that 
was configured in the APM for DID Allocator to one of the OAI Key Codes in 
the MAT.
(a) Select an unused OAI Key Code, from 1 to 14.  To...

NDA-30047   Revision 5.0Page 11
DID Allocator User and Installation Guide Mat Assignments
In the OAI Function Key Assignment example (Figure 3-2 on page 10), the MSF 
was selected in the APM Application Configuration and its Op-Code was 
determined to be #130.  MSF #130 is assigned through the AOKC command to an 
OAI Key Code.  The Key Code to which it is assigned in this example is #10.  The 
D
term function key that is to be used to access DID Allocator is configured as 
function key #8.  Since OAI Key...

Mat Assignments DID Allocator User and Installation Guide
Page 12NDA-30047   Revision 5.0
This Page Left Blank.