Namco Point Blank Operators Manual

							Operators Manual
Part No. 90500078
POINT BLANK
™ 
						

							© 1994Ltd - all rights reserved.
Published by:
BRENT LEISURE Ltd.
Unit 1 Brent Crescent,
London. NW10 0QT
Phone:- 0181-965-0550
Fax:- 0181-961-0574 No part of this publication may be reproduced by any mechanical, photographic or electronic
process, or in the form of phonographic recording, nor may it be stored in a retrieval system,
transmitted or otherwise copied for public or private use, without permission from 
namco Ltd.
While the information contained in this manual is given in good faith and was accurate at the
time of publication, BRENT LEISURE LIMITED reserve the right to make changes and
alterations without notice.
No responsibility is accepted for unauthorised changes or modifications made to the machine. 
						

							Contents
Operators Manual .............................................................................................. 1
1. SPECIFICATIONS ..................................................................................... 4
2. PRECAUTIONS .......................................................................................... 5
2-1 Cautions When Installing. ...................................................................................... 5
2-2 Caution when Handling. ......................................................................................... 5
2-3 Cautions when Transporting. .................................................................................. 5
3. ADJUSTMENTS ......................................................................................... 6
3-1 Turning on the Power ............................................................................................. 6
3-2 Switches for Adjustments ....................................................................................... 6
3-3 Volume Adjust ........................................................................................................ 6
3-4 Test Mode ............................................................................................................... 7
3-4-1 Switch Test ............................................................................................... 7
3-4-2 Gun and Lamp Test .................................................................................. 7
3-4-3 Game Menu .............................................................................................. 8
3-4-4 Coin Options ............................................................................................ 8
3-4-5 Monitor Test ............................................................................................. 8
3-4-6 Sound Test ................................................................................................ 9
3-4-7 Gun Sight Set-Up ..................................................................................... 9
4. PARTS .......................................................................................................... 9
5. SCHEMATIC ............................................................................................ 12 
						

							Page
1. SPECIFICATIONS
POWER SUPPLY :-220/240volts AC
 MONITOR :-Hantarex 28 Polo Colour Monitor with auto degauss.
DIMENSIONS :-780(w) x 900(d) x 2080(h)
WEIGHT :-165kg.
ACCESSORIES :-Keys: (Cash Door) ..................... 2
(Coin Door) ...................... 2
(Back Door) ..................... 2
Hex Tamper-Proof Wrench ..................... 1
IEC Mains Lead ...................................... 1
Operators Manual ................................... 1
Page 1 
						

							Page
2. PRECAUTIONS
2-1 Cautions When Installing.
This game is designed for indoor use only. The game must not be installed outdoors or
under the following conditions:-
a. In areas directly exposed to sunlight, high humidity, direct water contact, dust, high
heat or extreme cold.
b. In locations that would present an obstacle in the case of an emergency, i.e. near
fire equipment or emergency exits.
c. On an unstable surface or subject to floor vibration.
2-2 Caution when Handling.
a. AC power must always be turned OFF, and the game disconnected, before
replacing any parts or connecting/disconnecting connectors.
b. When unplugging the game from an electrical outlet, always grasp the plug, not the
mains lead.
c. The machine must be earthed with a securely connected earthed plug.
d. Care must be taken at all times to avoid electric shock when inspecting or
adjusting the game.
2-3 Cautions when Transporting.
a. Do not subject the game to physical shock when transporting or moving it.
b. Always return the levellers to the UP position before moving the machine.
c. Take care not to rope any moulded (plastic) parts when transporting.
2 
						

							Page
3. ADJUSTMENTS
3-1 Turning on the PowerAfter installing the product, turn on the power. The power switch is located above the 
mains inlet on the rear of the cabinet.
3-2 Switches for Adjustments Open the front door to find the switches for adjustments. 
1. Service Switch Press this switch to obtain game credits without incrementing the coin c\
ounter.
2. Test Switch Slide this switch to ON to enter test mode. 
Test mode allows game testing and the changing of game settings. (See 3-4 Test Mode on page 4)
3-3 Volume Adjust There are two volume controls, one each for left and right player. Turn the control to
increase or decrease the volumes.
3
TEST SWITCH
VOLUME 
CONTROLS COIN COUNTER
SERVICE
SWITCH
SERVICE BRACKET 
						

							Page
3-4 Test Mode
1. Open the coin door for access to the service bracket, then slide the tes\
t switch to ON. The Switch Test Screen appears on the monitor display.
2. Pressing the service button steps through the test screens. 
3. When testing is finished ensure that the test switch is returned to the \
OFF position to return to Game Screen
The Test Switch must always be OFF during normal game mode.
3-4-1 Switch Test 1. Enter test by switchingthe Test Switch ON. The 
Switch Test Screen
appears.
2. The corresponding writing on the test screen
will change to red while
the switch under test is
activated.
3-4-2 Gun and Lamp Test 1. Advance to the GOUT Test Screenfrom the Switch Test Screen by
pressing the service button on the
service bracket.
2. Pressing the 1 Player Start Button selects the test required. The
selected test will change to red.
3. Pressing the 2 Player Start Button will activate the test. 
1P/2P Blowback - Gun recoils each 
time 2 player start switch is
pressed 
Auto Blowback - Both guns recoil 
constantly when 2 player start
button is pressed. Pressing start
button again turns the test off. 
Flash - Not Used
SWITCH TEST
DIP SW 12 OH
COIN1 COUNT 0H
COIN2 COUNT 0H
1P SWITCH2P SWITCH
TRIGGERTRIGGER
STARTSTART
GOUT TEST
1PBLOWBACK
OFF
2PBLOWBACK
OFF
1PSTART LAMP
NO
2PSTART LAMP
NO
FLASH
NO
AUTO BLOWBACK
NO
4 
						

							Page
GAME MENU
LIFE3
MUSIC IN ATTRACT
YES
INITIALIZE HI SCORE
NO
COIN OPTIONS
GAME COST
1 COIN1 CREDIT
DISCOUNT TO CONTINUE
NO
COIN 1 MECH VALUE
1 COIN COUNT AS 1 COIN
COIN 2 MECH VALUE
1 COIN COUNT AS 1 COIN
BONUS FOR QUANTITY BUY IN
NONE
FREE PLAY
NO
COIN BOX
1 WAY
5 3-4-3 Game Menu
1. Advance to the Game Menu Screen by
pressing the service button.
2. Pressing the 1 Player Start Button selects the
test required. The selected test will change
to red.
3. Pressing the 2 Player Start Button will
change the settings.
3-4-4 Coin Options
1. Advance to the Game
Menu Screen by pressing
the service button.
2. Pressing the 1 Player Start
Button selects the test
required. The selected test
will change to red.
3. Pressing the 2 Player Start
Button will change the
settings.
Note:- The price of play
adjustments are made on
the credit board and the
coin options must be set as
shown in the table.
3-4-5 Monitor Test
1. Advance to the Game Menu Screen by pressing the service button.
2. The monitor will display vertical colour bars.
3. Pressing the service button again will cause the monitor to display a
crosshatch pattern. 
						

							Page 6
SOUND TEST
REQUEST No
0H
LEFT/RIGHT CHECK=REQUEST No 1H
3-4-6 Sound Test
1. Advance to the Game Menu Screen
by pressing the service button.
2. Pressing the 1 Player Start Button
changes the request No.
3. Pressing the 1 Player gun trigger
will generate a sound. A different
sound will be produced each time
the request No. is changed.
3-4-7 Gun Sight Set-Up
1 To initialize gun sight set-up press and hold in the Service Button and slide
the Test Switch ON.
2 Test screen for player 1 gun will appear. To adjust player 2 gun press the
Service Button.
3 Follow the instructions on the screen.
4 When set-up is completed ensure Test Switch is returned to OFF.
4. PARTS
DESCRIPTIONPART No.
Side Decal - LH40000196
Side Decal - RH40000197
Front Decal40000198
Play Panel Overlay33000022
Top Flash Vac-Form45000196
Top Flash Acrylic30000034
Play Instruction Card42000003 DECALS & PLASTICS 
						

							PageCABINET
7
DESCRIPTIONPART No.
Front Glass - Toughened (748x580x6)31000020
Mirror (735x660x3)31000021
Monitor 28 Hantarex Polo84000012
Speaker 4½ 20w (with shield can)62000006
Switch Mode Power Supply83000040
Schaffner Mains In Assy66000016
Schaffner Boot66000017
Fuse 5amp 20mm Slo-Blo63500600
Interlock Switch60000006
Interlock Cover39000028
Transformer67700015
Bridge Rectifier71000040
Capicitor 22,000mfd 25v70200043
Fuse 3amp 1¼ Slo-Blo63500547
18 15w Fluorescent Tube64500000
Choke 15w63300000
Starter63000000
75mm Castor59000005
M16 Adjustable Foot88300079
100ohm 10w W/W Potentiometer76000164
3.5-6v Panel Meter65000002
Service Switch60000059
Start Button Assy - Red60200235
Start Button Assy - Blue60200237
Test Switch60000023
Gun Assy - RedXPB-GUNRED
Gun Assy - BlueXPB-GUNBLUE
Gun Chain45000209
Chain Clip45000211
Holster45000199