Nagra 4.2 Portable Analogue Audio Instructions Manual
Here you can view all the pages of manual Nagra 4.2 Portable Analogue Audio Instructions Manual. The Nagra manuals for Recorder are available online for free. You can easily download all the documents as PDF.
Page 51
On the other hand, for a transmission, which is wholly musical, the range of the transmitter tends not to be used to its full advantage with a VU meter. b) The VU meter has a scale, which is not logarithmic. For the needle to move, it is necessary that the level exceed -20 dB. This causes the operator to compress greater than is necessary, that is to increase the level of the pianissimo. This reduces the quality of a musical transmission while increasing the range. On the other hand, it is...
Page 52
9.0 SPECIFICATIONS DIMENSIONS AND WEIGHT Dimensions of the case with the lid closed, without knobs, feet, carrying handle, or carrying handle mountings: L X W X H 12.6 x 8.8 x 4.4 (320 x 223 x 111 mm) Overall dimensions without handle L X W X H 13.2 x 9.6 x 4.5 (335 x 243 x 114 mm) Weight, without batteries or tape 13 lb (5.89 kg) Weight with ordinary batteries, 5 reels of tape 15lb (6.8 kg) POWER SUPPLY (Supply voltage, positive ground) –10.5 to -30 V...
Page 53
TAPE TRANSPORT Switchable nominal speeds 15 ips 38.10 cm/s 7½ ips 19.05 cm/s 3¾ ips 9.525 cm/s Stability of the nominal speed with respect to the temperature (within the specified range), the position of the recorder, the distribution of the tape between the reels, and the supply voltage ±0.1% WOW AND FLUTTER Weighted peak-to-peak value, in accordance with DIN 45 507/ANSI 4372 at 15 ips 38.10 cm/s ±0,05 % at 7½ is 19.05 cm/s ±0.07 % at 3¾ ips 9.525 cm/s ±0.12 %...
Page 54
FILTERS LFA 1 (low frequency Attenuation attenuation) 4 dB at 50 Hz LFA 2 8 dB at 50 Hz HP 1 (high-pass) 10 dB at 50 Hz HP 2 20 dB at 50 Hz HP 1 + LFA 1 (combination) 14 dB at 50 Hz REFERENCE GENERATOR 1.1 kHz sine wave signal with 10 kHz component 0 VU level= -8 dB ±0.1 dB OUTPUTS Line output voltage on 600 Ohm for 0 dB on the modulometer 4.4 V Line output impedance at 30 Hz 90 Ohm at 50 Hz 42 Ohm at 1 kHz 18 Ohm at 15 kHz 24 Ohm Maximum output voltage...
Page 55
MODULOMETER Integration time for - 2 dB 7.5 ms Usable scale -30 to +5 dB Frequency response from 40 Hz to 20 kHz ±0,5 dB RECORDING AND PLAYBACK CHAIN Nominal recording level 0 dB= 320 nWb/m Maximum peak level (M.P.L.) + 4 dB Magnetic tape used for Calibration : CCIR LN PEM 468 STD PER 368 NAB LN 3M 808 STD 3M 806 Erasing efficiency CCIR 84 dB NAB 88 dB Frequency response, recording at 20 dB below M.P.L. 15 ips (38 cm/s) CCIR and NAB 30 Hz to 20...
Page 56
INPUTS NAGRA 4.2 with QPSE-200-X0Y0 preamplifiers Microphone input 1,200 Ohm 0.2 to 43 m V Microphone input 2,200 Ohm 0.2 to 43 m V Unbalanced line input, impedance 100 k Ohm admissible voltage 0.37 to 120 V Unbalanced line input at accessory connector, admissible current 3.7 to 1,200 µA Mixer direct input, impedance 9 k Ohm 560 mV Pilot input, impedance 5 k Ohm 0.5 to 25 V
All Nagra manuals