Home > Multi-Tech Systems > Communications System > Multi-Tech Systems 4 Channel Voice/fax Update Information Manual

Multi-Tech Systems 4 Channel Voice/fax Update Information Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Multi-Tech Systems 4 Channel Voice/fax Update Information Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 104 Multi-Tech Systems manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							
    	 
    
    	 
    	 
    	 	  
    !  
    Introduction
    This product update provides the information necessary to perform a 4-channel voice/fax field upgrade to your
    MultiVOIP.  For example, a MultiVOIP MVP400 can be upgraded to an MVP800 by following the installation
    instructions provided below.
    Installation
    To install the 4-Channel Voice/Fax upgrade kit:
    1. Check the contents of your upgrade kit to insure that it contains the parts listed below:
    • 4-Channel Voice/Fax  logic board
     Phillips screws (6)
     4-Channel Voice/Fax Product Update
    2. Turn the power switch to OFF and unplug the power cord from the wall outlet.
    3. Turn the unit up-side-down and remove the eight screws (four on the bottom and four on the rear)
    securing the cover to the chassis.
    4. Slide the cover towards the back and off the chassis. Set aside.
    
    	
    
     
    
    
    
    	
    
    
    Figure 1:  Removing the Cover
    5. Remove the three screws and the Voice/Fax Cover which covers  expansion slots 5 to 8 (CHANNEL 5
    to 8) on the back panel of the unit (Refer to Figure 2). Discard the cover plate and the screws.
    	
    
    
    	
    
    
    	
    
    
    
     	!#
     	!#
    
    
    $
    
    %&	
    Figure 2: Back View with Cover Removed   
    						
    							
    6. Connect the ribbon cable from the existing 4-channel board to the 50-pin connector on the 4-Channel
    Voice/Fax logic board.
    7. Place the 4-Channel Voice/Fax logic board in the CHANNEL 5 through 8 slots in the back panel of the
    unit and onto the six metal standoffs (Refer to Figure 3).
    8. Secure the 4-Channel Voice/Fax logic board to the metal standoffs using the 6 screws provided in the
    kit.
    	
    
    
    		
    
    
    	
    
    
    #&
    
    () 	!#
    
    
    $
    
    %&	
    Figure 3: Adding the 4-Channel Voice/Fax Board
    9. Set switch 1 of the four-position dip switch to the up (open) position on the new 4-Channel Voice/Fax
    logic board. All four dip switches must be in the down (closed) position on the existing Voice/Fax logic
    board.
    10. Slide  the cover back on to the chassis and reinstall the cover screws.
    11. Refer to your Users Guide to configure your 4-Channel Voice/Fax logic board. 
    						
    All Multi-Tech Systems manuals Comments (0)

    Related Manuals for Multi-Tech Systems 4 Channel Voice/fax Update Information Manual