Mountfield Lawn Mower M Series Owners Manual

DEUTSCHD
8211-0401-01
Mountfield
M Series Lawnmower
Owner’s Manual 

3
SVENSKAS
2.
3.B4. 
1.
6.
D
E
5. 
7. 

4
SVENSKA S
12. 
ADD
FULL
FULL
ADD
8. Briggs & Stratton 9. Honda
10. Briggs & Stratton
13. 
11. Honda 
14.FULL/MAX
ADD/MIN
I*
B* G
3x
15. Left16. Right 

5
SVENSKAS
S
T
S
S
0,75 mmBriggs & Stratton : 0,76 mm
Honda: 0,7-0,8 mm
18. Honda GCV
22. 21.
19.
23 A. M4, M6
20. 
17. Briggs & Stratton
40 Nm
23 B. M2 

6
ENGLISHGB
SAFETY REGULATIONS
SYMBOLS
The following symbols can be found on the ma-
chine to remind you of the care and attention that 
are required during use. 
The symbols mean:
Warning! Read the Instruction Book and 
Safety Manual before using the machine.
Warning! Keep onlookers away. Beware 
of objects being flung out.
Warning! Keep hands and feet clear of the 
cutting deck when the machine is running.
Warning! Before starting any repair work, 
remove the spark plug cable from the 
spark plug....

7
ENGLISHGB
• Great care is required when changing direction 
on a slope.
• Do not use the machine on slopes of more than 
15°.
• Great care is required when reversing or when 
pulling the mower towards you.
• Switch off the engine if the mower must be tilt-
ed when being transported over surfaces other 
than grass, and also when the mower is being 
transported to and from the area to be cut.
• Never operate the mower with inadequate pro-
tection or without safety equipment, e.g. deflec-
tors and/or the...

8
ENGLISHGB
• Always seek professional help when the carbu-
rettor requires adjustment.
• Clean the air filter according to the directions.
• When, after many years of service, your ma-
chine needs to be replaced or is no longer re-
quired, we recommend that the machine is 
returned to your distributor for recycling.
IMPORTANT
Equipment which is marked with an asterisk (*) 
comes as standard in certain models.
Certain models do not have throttle control. The 
engine’s speed is set for optimal function...

9
ENGLISHGB
To remove the plug, press in the catch (S). On re-
installing the plug ensure that both pins are pressed 
firmly into the holes so that the plug snaps in place.
M2 Combi:
To remove the plug, unscrew the wing nut.
2. COLLECTION
Assemble the grass collector provided (fig. 4, 6). 
Open the flap, remove the plug and instead hook 
the collector onto the rear of the machine.
When mowing, the grass is collected in the collec-
tor. Empty the grass onto the compost heap or 
spread it over borders as...

10
ENGLISHGB
4. Set the throttle control B in the choke posi-
tion . NOTE! It is not necessary to use the 
choke position when the engine is warm (fig.  
12).
5. Press the Start/Stop loop G towards the handle. 
NOTE! The Start/Stop loop G must be kept 
pressed in to prevent the engine stopping (fig.  
12).
6. Grasp the starter handle and start the engine by 
pulling briskly on the starter cord.
7. When the engine starts, move the throttle con-
trol backwards until max. revs are obtained. 
NOTE! The...

11
ENGLISHGB
COOLING SYSTEM
Before each use, the engine’s cooling system must 
be cleaned. Clean the cylinder’s cooling flanges 
and air intake of grass remains, dirt, etc.
LUBRICATING DRIVE SHAFT (*)
Once per season, the wedge on the drive shaft 
should be greased. Remove the wheel (wheel cap, 
screw and washer). Then remove the circlip and 
washer so that the gear wheel can be removed from 
the shaft. Lubricate the wedge with universal 
grease.
Reinstall the wedge (the wedge is installed differ-
ently...